Two network technicians are installing a fiber-optic link between routers. The technicians used a light meter to verify the correct fibers However, when they connect the fibers to the router interface the link does not connect. Which of the following would explain the issue? (Select TWO).
Correct Answer: A,B
The issue is that the fiber-optic link between routers does not connect after the technicians verified the correct fibers with a light meter. There are two possible reasons for this:
* A. They used the wrong type of fiber transceiver: A fiber transceiver is a device that converts electrical signals to optical signals and vice versa. It is important to use the correct type of fiber transceiver that matches the fiber type, wavelength, and connector. For example, if the fiber is single-mode, the transceiver should also be single-mode. If the transceiver is mismatched, the link will not work.
* B. Incorrect TX/RX polarity exists on the link: TX/RX polarity refers to the alignment of the transmit (TX) and receive (RX) ports on both ends of the fiber link. The TX port on one end should connect to the RX port on the other end, and vice versa. If the polarity is reversed, the link will not work.
The other options are not likely to cause the issue:
* C. The connection has duplexing configuration issues: Duplexing refers to the ability of a link to send and receive data simultaneously (full duplex) or alternately (half duplex). Duplexing is a configuration issue for copper-based links, not fiber-optic links. Fiber-optic links are always full duplex.
* D. Halogen light fixtures are causing interference: Halogen light fixtures emit infrared light, which can interfere with some types of fiber-optic cables that use infrared light as the carrier signal. However, this is not a common problem, and it can be avoided by using shielded fiber-optic cables or different wavelengths.
* E. One of the technicians installed a loopback adapter: A loopback adapter is a device that connects the TX and RX ports of a fiber transceiver to test its functionality. It is used for troubleshooting purposes, not for establishing a link between routers. If one of the technicians installed a loopback adapter, the link would not work.
* F. The RSSI was not strong enough on the link: RSSI stands for Received Signal Strength Indicator, which measures the power of the optical signal received by a fiber transceiver. If the RSSI is too low, it means that the signal is attenuated or degraded by factors such as distance, connectors, splices, or bends.
However, this is not a likely cause of the issue, because the technicians used a light meter to verify the correct fibers, which implies that the signal was strong enough.
References:
* CompTIA Network+ N10-008 Certification Study Guide, Chapter 4: Network Media and Topologies, page 171-174
* CompTIA Network+ Certification Exam Objectives, Domain 2: Network Implementations, Objective
2.2: Given a scenario, install and configure the appropriate cabling solution, Sub-objective: Fiber
* Ace Your CompTIA Network+ Exam: Explore Top Study Resources, Section: CompTIA Network+ Certification Kit: Exam N10-008 6th Edition
* How to use fiber optical cable to connect second WiFi router, YouTube video by FS.COM
* Fiber Optic Router...What is it and why do you need one?, Article by Hitron Technologies