<< Prev Question Next Question >>

Question 44/53

switch# configure terminal
switch (config) # interface ethernet 1/4
switch (config-if) # switchport mode trunk
switch (config-if) # channel-group 1 mode active
Refer to the exhibit. Which type of port channel was created?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (53q)
Question 1: Which technology is required in the underlay to facilitate r...
Question 2: Instructions * This task does not require device configurati...
Question 3: Which statement accurately describes the implementation of F...
Question 4: Which option must be configured when you implement a vPC?...
1 commentQuestion 5: Instructions * This task does not require device configurati...
Question 6: Which two Nexus family linecards allow the configuration of ...
Question 7: What are two requirements for configuring SAN device aliases...
Question 8: Which two statements are true when performing a SPAN capture...
Question 9: A Cisco Nexus 2000 Series Fabric Extender is connected to tw...
Question 10: Which command should you run to enforce SNMP message encrypt...
Question 11: What can be identified by running the switch# show install a...
Question 12: When you configure LISP, which two components must be config...
Question 13: Which two options can be used for link aggregation when you ...
Question 14: Which two items are services that are provided by Cisco Fabr...
1 commentQuestion 15: Which statement accurately describes MP-BGP EVPN?...
1 commentQuestion 16: Which two issues explain why a packet is not being routed as...
Question 17: Which protocol is used to exchange MAC address reachability ...
1 commentQuestion 18: Which two options should you consider when you configure a S...
Question 19: Which option must be enabled to implement manual MACsec?...
Question 20: ipv6 access-list MY_ACL permit tcp 2001:cc1e:aaaa::/64 2001:...
Question 21: Which Cisco MDS feature needs to be enabled for Cisco TrustS...
1 commentQuestion 22: Which command configures the aging for VLAN 100 to 500 minut...
Question 23: After enabling strong, reversible 128-bit Advanced Encryptio...
1 commentQuestion 24: You plan to configure authentication for OSPF. In which mode...
Question 25: You experience an issue on a Cisco Nexus 7700 Series switch....
Question 26: In policy-based routing, which action is taken for packets t...
1 commentQuestion 27: Which two options accurately describe the implementation of ...
Question 28: What are two ways to configure the switch ID for Cisco Fabri...
1 commentQuestion 29: What is the Overlay Transport Virtualization site VLAN used ...
Question 30: You are configuring QoS on a Cisco Nexus 5000 Series switch....
Question 31: Instructions * This task does not require device configurati...
Question 32: You have two Fibre Channel switches that are connected via E...
Question 33: On a Cisco Nexus 7000 Series router, witch statement about H...
Question 34: Which two protocols can be used to back up the configuration...
Question 35: You create a checkpoint on a Cisco Nexus 7700 Series switch....
Question 36: You have a Cisco Nexus 5000 Series switch. Port security is ...
Question 37: Which statement about SNMP support on Cisco Nexus switches i...
Question 38: What is an Overlay Transport Virtualization extended VLAN?...
Question 39: Which statement about electronic programmable logic device i...
Question 40: Which two features are required to implement a Layer 3 VXLAN...
Question 41: You have two Cisco Nexus 7700 Series switches named SwitchA ...
Question 42: Which GLBL load-balancing method ensures that a client is al...
Question 43: Which implicit rules are applied to all IPv6 ACLs?...
Question 44: switch# configure terminal switch (config) # interface ether...
Question 45: N7K-1(config)# feature vpc N7K-1(config)# vpc domain 113 N7K...
Question 46: Which statement about enhanced zoning on Cisco Multilayer Di...
Question 47: Which action limits the maximum number of routes that are al...
Question 48: You plan to implement the OSPF protocol whithin the data cen...
Question 49: Which LISP component provides connectivity between LISP and ...
Question 50: Which security feature is only supported on the Cisco Nexus ...
Question 51: Which command should you ran to distribute NTP configuration...
Question 52: You are connecting a Cisco Nexus 2300 Series FEX to a Cisco ...
Question 53: Instructions * This task does not require device configurati...