Valid H12-811_V1.0 Dumps shared by ExamDiscuss.com for Helping Passing H12-811_V1.0 Exam! ExamDiscuss.com now offer the newest H12-811_V1.0 exam dumps, the ExamDiscuss.com H12-811_V1.0 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com H12-811_V1.0 dumps with Test Engine here:
Access H12-811_V1.0 Dumps Premium Version
(352 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 15/142
Which of the following statements regarding static routing and dynamic routing is incorrect?
Correct Answer: B
Detailed Explanation:Static routing does not automatically recover from link failures; manual reconfiguration is required if a static route path becomes invalid. Dynamic routing protocols, on the other hand, adapt automatically to network changes, adjusting routes as needed. (Reference: HCIA-Datacom Training Material, Static vs. Dynamic Routing)
- Question List (142q)
- Question 1: The country code configuration affects the actual transmissi...
- Question 2: (The IPv6 address architecture does not include which of the...
- Question 3: After the administrator performs the configuration shown in ...
- Question 4: When the host accesses the web service of the server, the va...
- Question 5: Which of the following statements is true?...
- Question 6: Which of the following mask lengths is recommended for devic...
- Question 7: Which of the following BIDs cannot be contained in a configu...
- Question 8: (An administrator cannot log in to a Huawei router through T...
- Question 9: (Which of the following OSPF packets can be used to confirm ...
- Question 10: Which of the following port numbers is used by the FTP contr...
- Question 11: On the Huawei VRP, what is the default preference of differe...
- Question 12: (Which of the following are not main functions of routers?)...
- Question 13: According to the VTY user interface configuration shown in t...
- Question 14: The users who log on the router through Telnet are not permi...
- Question 15: Which of the following statements regarding static routing a...
- Question 16: The following figure shows the display stp command output on...
- Question 17: An ACL is essentially a packet filter. An ACL takes effect o...
- Question 18: When a switch port receives a frame that does not carry a VL...
- Question 19: Which of the following statements is true about link aggrega...
- Question 20: VLAN 4095 is reserved for system use and VLAN 1 cannot be de...
- Question 21: An authenticator router has been configured with two domains...
- Question 22: < Huawei > system-view [Huawei]command-privilege level...
- Question 23: (Which of the following methods can be used to assign servic...
- Question 24: A Layer 2 ACL can match information such as the source MAC a...
- Question 25: SNMP packets are transmitted by UDP....
- Question 26: If the transport-layer protocol is UDP, the value of the "Pr...
- Question 27: Which of the following statements regarding Designated Route...
- Question 28: Which of the following OSPF versions is specific to IPv6?...
- Question 29: If the broadcast address of a network is 172.16.1.255, which...
- Question 30: What is used as the data link-layer MAC address that identif...
- Question 31: In the following figure, all links are Ethernet links, and a...
- Question 32: Which of the following packets are exchanged between STAs an...
- Question 33: Which of the following IEEE 802.11 standards supports the 2....
- Question 34: Refer to the following commands run on GigabitEthernet0/0/1 ...
- Question 35: The network administrator performs the configuration shown i...
- Question 36: What is the total length of the port ID in STP?...
- Question 37: A switch receives a unicast data frame with a VLAN tag but c...
- Question 38: Which of the following networks are LANs?...
- Question 39: Fit APs can work independently of an AC....
- Question 40: As shown in the figure, RTA uses NAT and has an address pool...
- Question 41: Which of the following ACLs can match the transport layer po...
- Question 42: The router that runs OSPF first enters the Full state and th...
- Question 43: A router that runs OSPF can enter the Full state only after ...
- Question 44: On the network shown in the figure, host A logs in to router...
- Question 45: Which of the following is not a common network layer in a mi...
- Question 46: (The administrator performs the configuration shown in the f...
- Question 47: (Each network device running SNMP runs an agent process loca...
- Question 48: Which of the following elements are included in a routing ta...
- Question 49: On the command line interface of Huawei AR routers, the role...
- Question 50: If Spanning Tree Protocol (STP) is disabled on the network c...
- Question 51: As specified by the RSTP protocol, when a root port fails, w...
- Question 52: After an Eth-Trunk in LACP mode is created, devices on both ...
- Question 53: What function does Ctrl+Z have in the VRP system?...
- Question 54: Refer to the captured three packets shown in the figure. Whi...
- Question 55: On the network shown in the figure, Host A and Host B cannot...
- Question 56: In a broadcast address, all host bits are set to 1, and a br...
- Question 57: The IP address 192.168.1.127/25 represents a ( ) address....
- Question 58: Which of the following statements about the network shown in...
- Question 59: Network devices running SNMP can proactively report traps to...
- Question 60: Assuming that OSPF has been enabled on all routers in the fo...
- Question 61: Which of the following parameters is used to elect the root ...
- Question 62: How many port states are involved in RSTP?...
- Question 63: Which of the following WLAN security policies support open l...
- Question 64: When an Ethernet frame is received by an interface on a Laye...
- Question 65: After a switch restarts, static MAC address entries saved on...
- Question 66: If the packet matches the deny rule in an ACL, the packet is...
- Question 67: (Which of the following statements is true about active inte...
- Question 68: A company applies for a class C IP address for subnetting. I...
- Question 69: UDP does not guarantee data transmission reliability and doe...
- Question 70: To provide the information about the IP addresses that a use...
- Question 71: What is used as the data link-layer MAC address that identif...
- Question 72: For STP, the Message Age in the configuration BPDUs sent by ...
- Question 73: What are the advantages of using DHCP to allocate IP address...
- Question 74: (You can run the "pwd" and "dir" commands on the Versatile R...
- Question 75: Assume that an OSPF-enabled router has no loopback interface...
- Question 76: Which of the following commands can switch a view from the s...
- Question 77: By default, all SNMP versions (SNMPv1, SNMPv2c, and SNMPv3) ...
- Question 78: (Loops may cause broadcast storms on a Layer 2 network.)...
- Question 79: On the VRP platform, which of the following parameters can b...
- Question 80: Which of the following VRP commands can be used to enter are...
- Question 81: The router ID of the OSPF-enabled router must be the same as...
- Question 82: telnetlib is a module provided by Python to implement the Te...
- Question 83: Which of the following fields are included in an MPLS header...
- Question 84: The following figure shows the display interface Eth-Trunk 1...
- Question 85: Dynamic routing protocols can automatically adapt to network...
- Question 86: In RSTP, an edge port becomes a common STP port after receiv...
- Question 87: The Network Management Station uses SNMP to manage devices. ...
- Question 88: Which of the following information is displayed when an ente...
- Question 89: Which of the following statements is true about the Forward ...
- Question 90: When forwarding a data packet, a router needs to change the ...
- Question 91: Which of the following statements about hybrid interfaces is...
- Question 92: (An Eth-Trunk interface can be used only as a Layer 2 interf...
- Question 93: Following a failure of services in the network, an administr...
- Question 94: (Refer to the display startup command output shown in the fi...
- Question 95: Which of the following operations are mandatory to restore t...
- Question 96: When a router is powered on, the router reads the configurat...
- Question 97: A routing entry contains multiple fields. Which of the follo...
- Question 98: If the MAC address of an interface is 00E0-FCEF-0FEC, the co...
- Question 99: Which of the following planes does a network device have?...
- Question 100: Which of the following statements about static routes on Hua...
- Question 101: An ACL rule is as follows. Which of the following IP address...
- Question 102: It is advised to assign static IP addresses to servers durin...
- Question 103: Static NAT can only implement one-to-one mapping between pri...
- Question 104: Which of the following statements is true about root bridge ...
- Question 105: In the case of Huawei routers, what is the "-i" parameter in...
- Question 106: Refer to the following display vlan command output on SWA. W...
- Question 107: In STP, the bridge ID on the switching network is as follows...
- Question 108: When an AP and an AC are located on different Layer 3 networ...
- Question 109: What is the protocol number of OSPF at the network layer?...
- Question 110: In STP, which of the following items may affect the selectio...
- Question 111: Which of the following states indicates that the OSPF neighb...
- Question 112: Which of the following is not included in the routing table?...
- Question 113: When two switches are connected through link aggregation, wh...
- Question 114: (Which of the following routing protocols are dynamic routin...
- Question 115: If a device running STP receives an RSTP configuration BPDU,...
- Question 116: What is the protocol of the Router Advertisement (RA) packet...
- Question 117: Which of the following parts compose SNMP?...
- Question 118: Which of the following port statuses may exist on an STP-ena...
- Question 119: When the ACL in the following figure is configured on a Teln...
- Question 120: By referring to the network structure and OSPF areas shown i...
- Question 121: Which of the following commands is used to display the CPU u...
- Question 122: Which of the following is the default port number of the Tel...
- Question 123: What is the TPID value defined by IEEE 802.1Q?...
- Question 124: In the following figure, all links are Ethernet links, and a...
- Question 125: The following figure shows the display interface Eth-Trunk 1...
- Question 126: A company applies for a class C IP address for subnetting. I...
- Question 127: The priority of static routes cannot be manually specified....
- Question 128: Which of the following IEEE 802.11 standards supports a theo...
- Question 129: What is the length range of an Ethernet_II frame that contai...
- Question 130: RSTP uses the proposal/agreement mechanism to shorten the ti...
- Question 131: A Layer 2 switch works at the data link layer. As such, it c...
- Question 132: If AAA authentication is used on Huawei devices and the remo...
- Question 133: Which of the following network types are supported by OSPF?...
- Question 134: During STP calculation, the port cost is associated with the...
- Question 135: For STP, the default root path cost of the root bridge is 0....
- Question 136: telnetlib is a module provided by Python to implement the Te...
- Question 137: In RSTP, an edge port becomes a common STP port after receiv...
- Question 138: (When a network engineer enters a command, the following inf...
- Question 139: As shown in the figure, all switches run STP. Assume that th...
- Question 140: More than two switches can be stacked into one logical devic...
- Question 141: Refer to the following display vlan command output. Which of...
- Question 142: On Huawei routers, which of the following is the default pre...
