<< Prev Question Next Question >>

Question 11/20

An administrator obtains the following CLI output:

How much time does the local system take to detect remote failures without receiving packets?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (20q)
Question 1: What interface must be selected when configuring the managem...
Question 2: Which two things does the no vrrp 100 address-family ipv6 co...
Question 3: Refer to the exhibit. (Exhibit) What can be determined from ...
Question 4: What is the impact of entering the qos-mode uniform command ...
Question 5: VLAN 40 is configured in Switch A with an anycast-address of...
Question 6: An administrator is installing Enterprise SONIC in ONIE from...
Question 7: What two methods can be used to upgrade or downgrade Enterpr...
Question 8: What does the show vian command display?...
Question 9: Which network devices route unencapsulated user traffic in a...
Question 10: What are three characteristics of VLAN translation?...
Question 11: An administrator obtains the following CLI output: (Exhibit)...
Question 12: What is ECMP?
Question 13: Which three actions are required to route traffic sourced fr...
Question 14: What are two characteristics of route maps in Enterprise SON...
Question 15: An administrator for a service provider uses this command on...
Question 16: Create port channel 10 on interfaces Eth 1/11 and 1/12, so t...
Question 17: Refer to the exhibit. (Exhibit) Eth 1/1 of SONiC-1 and Eth1/...
Question 18: What is a correct use-case scenario for ZTP in Enterprise SO...
Question 19: How many ports are in each port-group on the S5200 series sw...
Question 20: Refer to the exhibit. (Exhibit) Which three actions can a cu...