300-360 Exam Dumps | You are planning the coverage for wireless VoIP by using Ekahau. Which signal strength does Ekahau recommend

Home
Cisco
Designing Cisco Wireless Enterprise Networks
Cisco.300-360.v2018-02-15.q100
Question 99

Valid 300-360 Dumps shared by ExamDiscuss.com for Helping Passing 300-360 Exam! ExamDiscuss.com now offer the newest 300-360 exam dumps, the ExamDiscuss.com 300-360 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 300-360 dumps with Test Engine here:

Access 300-360 Dumps Premium Version
(180 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 99/100

You are planning the coverage for wireless VoIP by using Ekahau. Which signal strength does Ekahau recommend using for VoIP?

A. -84 dBm

B. -76 dBm

C. -67 dBm

D. -53 dBm

Correct Answer: C

Each vendor has their own recommended signal strength for a given data rate or application. For instance, one vendor may recommend designing their VoIP solution at -67 dBm (perhaps the most widely-used value for VoIP deployment if I had to choose one), while another may say -70 dBm. In most cases the values will differ only by a couple dB.
https://www.ekahau.com/blog/2015/01/13/ekahau-site-survey-heatmap-visualizations-part-
2-signalstrength/

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (100q): Question 1: Which three statements describe WLAN RF interaction with env...; 1 commentQuestion 2: A hospital environment was designed to guarantee RF coverage...; Question 3: When designing a large, high-availability wireless network, ...; Question 4: An engineer is deploying outdoor Cisco Aironet 1500 Series A...; Question 5: A customer has deployed an N+N redundant wireless infrastruc...; Question 6: You must create a simple implementation of QoS on a WIAN. Th...; Question 7: Which two basic characteristics would be needed from antenna...; 3 commentQuestion 8: Refer to the exhibit. An engineer has determined that Cisco ...; Question 9: A network engineer is configuring QoS with a DSCP value of 4...; Question 10: An engineer is conducting a location readiness test and want...; Question 11: You must upgrade a data- based wireless network to support V...; 1 commentQuestion 12: Cisco 7925G phones are experiencing intermittent connectivit...; Question 13: An engineer is implementing Q0S for a new wireless voice net...; 2 commentQuestion 14: A wireless engineer is hired to design a network for six bui...; Question 15: Refer to the exhibit. (Exhibit) Which type of cable connecto...; Question 16: Which option is an advantage at using Cisco CleanAir technol...; Question 17: Which list of characteristics must all controllers in a mobi...; Question 18: After installation of a new data-only wireless network, an e...; Question 19: A Cisco 7925 phone at a client's location is not registering...; Question 20: A customer is having issues streaming video over wireless in...; 1 commentQuestion 21: You have a customer that is building a new campus of four 3-...; Question 22: An engineer is planning for a 24 Mbps data rate for a new in...; Question 23: When designing a WLAN, AP placement is important. Which opti...; Question 24: If you are calibrating for 2.4 GHz and the site will not be ...; Question 25: An engineer is preparing for an indoor wireless LAN survey a...; Question 26: After implementing mesh with an IP surveillance camera conne...; Question 27: The AP has been configured property for a VoWLAN survey The ...; 2 commentQuestion 28: A customer is preparing to deploy a wireless network in a st...; 1 commentQuestion 29: IEEE 802.llk-2008 is an amendment to IEEE 80211- 2007 standa...; Question 30: When implementing video teleconferencing over a wireless net...; Question 31: What are two advantages of conducting an active survey versu...; 2 commentQuestion 32: Which two information points should a pre-site survey questi...; Question 33: An engineer plugs in a Cisco Aironet 2700 Series Access Poin...; Question 34: Which two types of information must be included in the insta...; Question 35: An engineer must perform a survey where the target client de...; Question 36: Which three components and tasks should be considered while ...; Question 37: A network engineer is preparing for an office site survey wi...; 3 commentQuestion 38: After the completion of a site survey with Ekahau Site Surve...; Question 39: You are designing an outdoor mesh network to cover several s...; Question 40: An engineer is tuning RRM parameters to improve client conne...; Question 41: Which two steps are associated with the active portion of th...; Question 42: An engineer is assigned to provide wireless coverage in a pr...; Question 43: Which three options are benefits of U-APSD? (Choose three.)...; Question 44: An engineer must design a wireless voice network and is audi...; Question 45: An engineer is configuring an autonomous AP for RADIUS authe...; Question 46: An engineer is determining the signal levels for the wireles...; Question 47: An engineer is preparing for an active site survey of a ware...; 3 commentQuestion 48: An engineer is preparing for an active site survey of a hosp...; Question 49: An engineer is tuning RRM parameters to improve client conne...; Question 50: You have a multinational customer that would like you to per...; Question 51: A corporation has a Cisco Unified Wireless Network that has ...; Question 52: Which two critical requirements must be addressed in the RF ...; Question 53: A network engineer is performing a site survey in preparatio...; 1 commentQuestion 54: An engineer is assigned to replace an older data-grade auton...; Question 55: During a post-deployment survey, the wireless engineer notic...; Question 56: What is a common cause for signal attenuation?...; Question 57: An engineer is deploying an outdoor Mesh network. Which four...; Question 58: An engineer has been assigned the task of deciding the cell ...; Question 59: An 802.11n implementation is being discussed. Users are sati...; Question 60: When should a Layer I site survey be performed?...; Question 61: A customer has a business-critical voice network and wants t...; Question 62: What is the recommended minimum speed at the edge of the cel...; Question 63: An engineer is performing a predictive wireless design for a...; Question 64: Which three factors must you consider before you deploy APs ...; 5 commentQuestion 65: During an installation of a wireless network in a country th...; Question 66: An engineer receives a digital image scanned from the floor ...; Question 67: A customer reports that wireless clients are not able to rec...; 2 commentQuestion 68: An engineer is concerned with the compliance guidelines for ...; Question 69: An engineer is determining powering requirements for a P2P w...; Question 70: An engineer must design wireless coverage in thick-walled st...; Question 71: An engineer is assigned to assist a customer by estimating t...; Question 72: You are designing a wireless network to support high user de...; Question 73: What is the result if a client radio is incapable of support...; Question 74: What two factors could cause a post-deployment audit to show...; Question 75: A wireless engineer is configuring VoWLAN on a WLC. Which co...; 2 commentQuestion 76: You must redesign an existing wireless network that spans mu...; Question 77: A customer wants to upgrade their current wireless infrastru...; Question 78: A network engineer is having wireless multicast fail when it...; Question 79: What is the optimal distance between APs for location servic...; Question 80: What protocol can be enabled to listen in on IPv4 multicast ...; Question 81: A post-deployment active wireless site survey was just compl...; Question 82: Which three recommendations must be taken into consideration...; Question 83: A customer has determined that a cable run for a low-through...; Question 84: Which type of information should be included in an installat...; 2 commentQuestion 85: Which description of the ideal VoWLAN design is true?...; Question 86: You are designing a wireless mesh network for an oil refiner...; Question 87: An engineer is deploying centralized wireless solution with ...; Question 88: Given an AP that can transmit at 100 mW and the client at 40...; Question 89: An engineer is performing a predictive wireless design for a...; 1 commentQuestion 90: An access point will be partially exposed to the outdoor env...; Question 91: An engineer has performed a post-deployment site survey and ...; Question 92: An engineer is installing a wireless network in an industria...; Question 93: A customer recently placed 10 WLCs in a mobility group and n...; Question 94: A customer has restricted the AP and antenna combinations fo...; Question 95: When calculating bandwidth usage for an application, what tw...; Question 96: Which three parameters are used by Cisco Prime Infrastructur...; Question 97: An engineer wants the controller to report when a client exc...; Question 98: As part of a wireless site survey in a hospital, an engineer...; Question 99: You are planning the coverage for wireless VoIP by using Eka...; Question 100: When reviewing a design for a voice over wireless deployment...

[×]

Download PDF File

Enter your email address to download Cisco.300-360.v2018-02-15.q100.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 99/100

LEAVE A REPLY

Download PDF File