300-360 Exam Dumps | Refer to the exhibit. An engineer has determined that Cisco 7925 phones are roaming between 2.4 6Hz and

<< Prev Question Next Question >>

Question 8/100

Refer to the exhibit. An engineer has determined that Cisco 7925 phones are roaming between 2.4 6Hz and 5 6Hz radios on the same access points, which results in poor audio performance Which action must the engineer take to mitigate this issue?

A. Enable Band Select on the WLAN

B. Configure EDCA parameters for Voice Optimized.

C. Configure the Cisco 7925 phone to only use 5 6Hz.

D. Enable TPCv2 to normalize the RF environment.

Recent Comments (The most recent comments are at the top.)

Mrtn - May 16, 2018

I think it is A Enable Band Select on the WLAN I am confused too but here it says:
https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Mobility/vowlan/41dg/vowlan41dg-book/vowlan_ch10.html?bookSearch=true

The recommended method used to limit the Cisco Unified Wireless IP Phone 7921 operation to a single frequency band is to leave the phones at their default setting and to configure the WLAN on the controller—or Cisco Wireless Control System (WCS)—to operate on the required frequency band.

Then here it says about band select:
https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Mobility/vowlan/41dg/vowlan41dg-book/vowlan_ch10.html?bookSearch=true
Band selection enables client radios that are capable of dual-band (2.4- and 5-GHz) operation to move to a less congested 5-GHz access point. The 2.4-GHz band is often congested

sbcoms - Mar 27, 2018

I thought the answer should be C too, as it fits in with Cisco's original CUWSS recommendation of 2.4 Ghz for data and 5 Ghz for voice

Bitaites - Mar 07, 2018

The correct anwser is C

Question 8/100

Recent Comments (The most recent comments are at the top.)

LEAVE A REPLY

Download PDF File