300-115 Exam Dumps | Which statement about Cisco Discovery Protocol configuration on a Cisco switch is true?

Home
Cisco
Implementing Cisco IP Switched Networks
Cisco.300-115.v2018-06-11.q159
Question 79

Valid 300-115 Dumps shared by EduDump.com for Helping Passing 300-115 Exam! EduDump.com now offer the newest 300-115 exam dumps, the EduDump.com 300-115 exam questions have been updated and answers have been corrected get the newest EduDump.com 300-115 dumps with Test Engine here:

Access 300-115 Dumps Premium Version
(162 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 79/159

Which statement about Cisco Discovery Protocol configuration on a Cisco switch is true?

A. CDP is enabled by default and can be disabled globally with the command no cdp run.

B. CDP is disabled by default and can be enabled globally with the command cdp enable.

C. CDP is enabled by default and can be disabled globally with the command no cdp enable.

D. CDP is disabled by default and can be enabled globally with the command cdp run.

Correct Answer: A

Explanation/Reference:
Explanation:
CDP is enabled on your router by default, which means the Cisco IOS software will receive CDP information. CDP also is enabled on supported interfaces by default. To disable CDP on an interface, use the "no cdp enable interface" configuration command. To disable it globally, use the "no cdp run" command.
Reference:
http://www.cisco.com/en/US/docs/ios/12_2/configfun/command/reference/frf015.html#wp10175

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (159q): Question 1: What is the maximum number of VLANs that can be assigned to ...; Question 2: You have been asked to install and configure a new switch in...; Question 3: What is the default HSRP priority?...; Question 4: Which of the below options is VALID for etherchannel load-ba...; Question 5: Stackwise; Question 6: Which VLAN range is eligible to be pruned when a network eng...; Question 7: To follow the Layer 2 switching guidelines, a network engine...; Question 8: After configuring new data VLANs 1020 through 1030 on the VT...; Question 9: For security reasons, the IT manager has prohibited users fr...; Question 10: Refer to the exhibit. (Exhibit) All ports are members of VLA...; Question 11: Ferris Plastics, Inc. is a medium sized company, with an ent...; Question 12: Which feature describes MAC addresses that are dynamically l...; Question 13: After reviewing UDLD status on switch ports, an engineer not...; Question 14: A network engineer notices inconsistent Cisco Discovery Prot...; Question 15: Which four LACP components are used to determine which hot-s...; Question 16: Refer to the exhibit. (Exhibit) f1/0 and f1/1 have the same ...; Question 17: Which authentication service is needed to configure 802.1x?...; Question 18: After the implementation of several different types of switc...; Question 19: On which interface can port security be configured?...; Question 20: Refer to the exhibit. (Exhibit) How can the traffic that is ...; Question 21: When SDM templates are configured, which action must be perf...; Question 22: Exhibit of HSRP with problem with secondary (error is duplic...; Question 23: A DHCP configured router is connected directly to a switch t...; Question 24: What is the function of NSF?; Question 25: What is the maximum number of switches that can be stacked u...; Question 26: Refer to the exhibit. (Exhibit) Why would the switch be cons...; Question 27: Refer to the exhibit. (Exhibit) Which option describes the r...; Question 28: SIMULATION SWITCH.com is an IT company that has an existing ...; Question 29: For client server failover purposes, the application server ...; Question 30: When you design a switched network using VTPv2, how many VLA...; Question 31: Which AAA Authorization type includes PPP, SLIP, and ARAP co...; Question 32: Which type of information does the DHCP snooping binding dat...; Question 33: Several new switches have been added to the existing network...; Question 34: Which statement about restrictions for multichassis LACP is ...; Question 35: A network engineer is installing a switch for temporary work...; Question 36: In a Cisco switch, what is the default period of time after ...; Question 37: A network engineer deployed a switch that operates the LAN b...; Question 38: What would happen if we delete VLAN that exit on switchport?...; Question 39: What is the default interval at which Cisco devices send Cis...; Question 40: An administrator recently configured all ports for rapid tra...; Question 41: Which switch feature determines validity based on IP-to-MAC ...; Question 42: Which SDM template disables routing and supports the maximum...; Question 43: When two MST instances (MST 1 and MST 2) are created on a sw...; Question 44: Refer to the exhibit. (Exhibit) When a network administrator...; Question 45: Which option lists the modes that are available for configur...; Question 46: What is the default value for the errdisable recovery interv...; Question 47: Which portion of AAA looks at what a user has access to?...; Question 48: Refer to the exhibit. (Exhibit) A network engineer wants to ...; Question 49: A new network that consists of several switches has been con...; Question 50: Pilot testing of the new switching infrastructure finds that...; Question 51: Question about the voice vlan; Question 52: L2 etherchannel formed where do you assign IP...; Question 53: After the recent upgrade of the switching infrastructure, th...; Question 54: A network engineer wants to make sure that an access switch ...; Question 55: An access switch has been configured with an EtherChannel po...; Question 56: The command storm-control broadcast level 75 65 is configure...; Question 57: After port security is deployed throughout an enterprise cam...; Question 58: While working in the core network building, a technician acc...; Question 59: Your customer has asked you to come in and verify the operat...; Question 60: Refer to the exhibit. (Exhibit) Switch A, B, and C are trunk...; Question 61: A network engineer must implement Ethernet links that are ca...; Question 62: Refer to the exhibit. (Exhibit) What is the result of the SP...; Question 63: Interface FastEthernet0/1 is configured as a trunk interface...; Question 64: Which technique allows specific VLANs to be strictly permitt...; Question 65: Refer to the exhibit. (Exhibit) How many bytes are added to ...; Question 66: Which statement describes what happens if all VSL connection...; Question 67: Which statement describes what happens when a switch enters ...; Question 68: Which First Hop Redundancy Protocol is an IEEE Standard?...; Question 69: Which feature puts the port into err-disabled state when the...; Question 70: A network engineer wants to ensure Layer 2 isolation of cust...; Question 71: The network manager has requested that several new VLANs (VL...; Question 72: Which private VLAN can have only one VLAN and be a secondary...; Question 73: Which statement describes one major issue that VTP can cause...; Question 74: Refer to the exhibit. (Exhibit) What is the result of the co...; Question 75: Which statement about the use of PagP link aggregation on a ...; Question 76: A network engineer configured an Ethernet switch using these...; Question 77: A network engineer has just deployed a non-Cisco device in t...; Question 78: Refer to the exhibit. (Exhibit) The users in an engineering ...; Question 79: Which statement about Cisco Discovery Protocol configuration...; Question 80: Refer to the exhibit. (Exhibit) Which login credentials are ...; Question 81: A network engineer configured a fault-tolerance link on Giga...; Question 82: Which option is a possible cause for an errdisabled interfac...; Question 83: What is the maximum number of virtual MAC addresses that GLB...; Question 84: Which command creates a login authentication method named "l...; Question 85: Which private VLAN access port belongs to the primary VLAN a...; Question 86: What effect does the mac address-table aging-time 180 comman...; Question 87: Which VTP mode is needed to configure an extended VLAN, when...; Question 88: Your customer has asked you to come in and verify the operat...; Question 89: After UDLD is implemented, a Network Administrator noticed t...; Question 90: A Cisco Catalyst switch that is prone to reboots continues t...; Question 91: A network engineer is setting up a new switched network. The...; Question 92: A manager tells the network engineer to permit only certain ...; Question 93: There was exhibit for RSPAN with two sessions...; Question 94: Which statement about the use of SDM templates in a Cisco sw...; Question 95: A network engineer must set the load balance method on an ex...; Question 96: Which statement about using EtherChannel on Cisco IOS switch...; Question 97: Refer to the exhibit. (Exhibit) A network engineer investiga...; Question 98: Which command globally enables AAA on a device?...; Question 99: If a network engineer applies the command mac-address-table ...; Question 100: Refer to the exhibit. (Exhibit) Users of PC-1 experience slo...; Question 101: Question with recognition of vlans 3050 and 3060...; Question 102: Which feature is automatically enabled when a voice VLAN is ...; Question 103: While doing network discovery using Cisco Discovery Protocol...; Question 104: Which command configures an HSRP group to become a slave of ...; Question 105: Ferris Plastics, Inc. is a medium sized company, with an ent...; Question 106: Ferris Plastics, Inc. is a medium sized company, with an ent...; Question 107: Which gateway role is responsible for answering ARP requests...; Question 108: There is native VLAN mismatch after administrator change nat...; Question 109: Which command correctly configures standby tracking for grou...; Question 110: Which configuration command ties the router hot standby prio...; Question 111: Why is there a mismatch? Switch1# sh etherchannel summary Nu...; Question 112: One site is active on port channel what other side you can c...; Question 113: A network is running VTPv2. After verifying all VTP settings...; Question 114: What is the function of NSF?; Question 115: A network engineer wants to add a new switch to an existing ...; Question 116: A network engineer deployed a switch that operates the LAN b...; Question 117: An access switch has been configured with an EtherChannel po...; Question 118: A network engineer configures port security and 802.1x on th...; Question 119: Which two protocols can be automatically negotiated between ...; Question 120: What percentage of bandwidth is reduced when a stack cable i...; Question 121: Select and Place: (Exhibit); Question 122: What is required for a LAN switch to support 802.1q Q-in-Q e...; Question 123: Which option lists the information that is contained in a Ci...; Question 124: Which action allows a network engineer to limit a default VL...; Question 125: Which option describes a limitation of LLDP?...; Question 126: Refer to the exhibit. (Exhibit) The network switches for two...; Question 127: Which statement about LLDP-MED is true?...; Question 128: Which statement about the UDLD protocol is true?...; Question 129: What is the default amount by which the hot standby priority...; Question 130: After configuring new data VLANs 1020 through 1030 on the VT...; Question 131: A server with a statically assigned IP address is attached t...; Question 132: Which option is a benefit of using VSS?...; Question 133: Which feature must be enabled to eliminate the broadcasting ...; Question 134: Which SDM template is the most appropriate for a Layer 2 swi...; Question 135: Which command does a network engineer use to verify the span...; Question 136: A network engineer changed the port speed and duplex setting...; Question 137: An EtherChannel bundle has been established between a Cisco ...; Question 138: What happens on a Cisco switch that runs Cisco IOS when an R...; Question 139: Which command is needed to enable DHCP snooping if a switchp...; Question 140: Which statement about Cisco devices learning about each othe...; Question 141: After an EtherChannel is configured between two Cisco switch...; Question 142: Refer to the exhibit. (Exhibit) Which statement about switch...; Question 143: Refer to the exhibit. (Exhibit) Switch A, B, and C are trunk...; Question 144: Refer to the exhibit. (Exhibit) A multilayer switch has been...; Question 145: When you configure a private VLAN, which type of port must y...; Question 146: What's state of port security by default in a switch?...; Question 147: Where does a subordinate switch in a stack store the informa...; Question 148: Which VRRP router is responsible for forwarding packets that...; Question 149: DHCP snooping and IP Source Guard have been configured on a ...; Question 150: Ferris Plastics, Inc. is a medium sized company, with an ent...; Question 151: A network engineer tries to configure storm control on an Et...; Question 152: Your customer has asked you to come in and verify the operat...; Question 153: In which portion of the frame is the 802.1q header found?...; Question 154: Which statement describes what happens when a port configure...; Question 155: Ferris Plastics, Inc. is a medium sized company, with an ent...; Question 156: Refer to the exhibit. (Exhibit) Which EtherChannel negotiati...; Question 157: What is the maximum number of 10 Gigabit Ethernet connection...; Question 158: When you configure private VLANs on a switch, which port typ...; Question 159: A network engineer is trying to deploy a PC on a network. Th...

[×]

Download PDF File

Enter your email address to download Cisco.300-115.v2018-06-11.q159.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 79/159

LEAVE A REPLY

Download PDF File