Valid 300-115 Dumps shared by EduDump.com for Helping Passing 300-115 Exam! EduDump.com now offer the newest 300-115 exam dumps, the EduDump.com 300-115 exam questions have been updated and answers have been corrected get the newest EduDump.com 300-115 dumps with Test Engine here:
Access 300-115 Dumps Premium Version
(162 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 45/159
Which option lists the modes that are available for configuring UDLD on a Cisco switch?
Correct Answer: A
Explanation/Reference:
Explanation:
The Cisco-proprietary UDLD protocol monitors the physical configuration of the links between devices and ports that support UDLD. UDLD detects the existence of unidirectional links. When a unidirectional link is detected, UDLD puts the affected port into the errdisabled state and alerts the user. UDLD can operate in either normal or aggressive mode.
Reference:
http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/configuration/guide/udl d.html
Explanation:
The Cisco-proprietary UDLD protocol monitors the physical configuration of the links between devices and ports that support UDLD. UDLD detects the existence of unidirectional links. When a unidirectional link is detected, UDLD puts the affected port into the errdisabled state and alerts the user. UDLD can operate in either normal or aggressive mode.
Reference:
http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/configuration/guide/udl d.html
- Question List (159q)
- Question 1: What is the maximum number of VLANs that can be assigned to ...
- Question 2: You have been asked to install and configure a new switch in...
- Question 3: What is the default HSRP priority?...
- Question 4: Which of the below options is VALID for etherchannel load-ba...
- Question 5: Stackwise
- Question 6: Which VLAN range is eligible to be pruned when a network eng...
- Question 7: To follow the Layer 2 switching guidelines, a network engine...
- Question 8: After configuring new data VLANs 1020 through 1030 on the VT...
- Question 9: For security reasons, the IT manager has prohibited users fr...
- Question 10: Refer to the exhibit. (Exhibit) All ports are members of VLA...
- Question 11: Ferris Plastics, Inc. is a medium sized company, with an ent...
- Question 12: Which feature describes MAC addresses that are dynamically l...
- Question 13: After reviewing UDLD status on switch ports, an engineer not...
- Question 14: A network engineer notices inconsistent Cisco Discovery Prot...
- Question 15: Which four LACP components are used to determine which hot-s...
- Question 16: Refer to the exhibit. (Exhibit) f1/0 and f1/1 have the same ...
- Question 17: Which authentication service is needed to configure 802.1x?...
- Question 18: After the implementation of several different types of switc...
- Question 19: On which interface can port security be configured?...
- Question 20: Refer to the exhibit. (Exhibit) How can the traffic that is ...
- Question 21: When SDM templates are configured, which action must be perf...
- Question 22: Exhibit of HSRP with problem with secondary (error is duplic...
- Question 23: A DHCP configured router is connected directly to a switch t...
- Question 24: What is the function of NSF?
- Question 25: What is the maximum number of switches that can be stacked u...
- Question 26: Refer to the exhibit. (Exhibit) Why would the switch be cons...
- Question 27: Refer to the exhibit. (Exhibit) Which option describes the r...
- Question 28: SIMULATION SWITCH.com is an IT company that has an existing ...
- Question 29: For client server failover purposes, the application server ...
- Question 30: When you design a switched network using VTPv2, how many VLA...
- Question 31: Which AAA Authorization type includes PPP, SLIP, and ARAP co...
- Question 32: Which type of information does the DHCP snooping binding dat...
- Question 33: Several new switches have been added to the existing network...
- Question 34: Which statement about restrictions for multichassis LACP is ...
- Question 35: A network engineer is installing a switch for temporary work...
- Question 36: In a Cisco switch, what is the default period of time after ...
- Question 37: A network engineer deployed a switch that operates the LAN b...
- Question 38: What would happen if we delete VLAN that exit on switchport?...
- Question 39: What is the default interval at which Cisco devices send Cis...
- Question 40: An administrator recently configured all ports for rapid tra...
- Question 41: Which switch feature determines validity based on IP-to-MAC ...
- Question 42: Which SDM template disables routing and supports the maximum...
- Question 43: When two MST instances (MST 1 and MST 2) are created on a sw...
- Question 44: Refer to the exhibit. (Exhibit) When a network administrator...
- Question 45: Which option lists the modes that are available for configur...
- Question 46: What is the default value for the errdisable recovery interv...
- Question 47: Which portion of AAA looks at what a user has access to?...
- Question 48: Refer to the exhibit. (Exhibit) A network engineer wants to ...
- Question 49: A new network that consists of several switches has been con...
- Question 50: Pilot testing of the new switching infrastructure finds that...
- Question 51: Question about the voice vlan
- Question 52: L2 etherchannel formed where do you assign IP...
- Question 53: After the recent upgrade of the switching infrastructure, th...
- Question 54: A network engineer wants to make sure that an access switch ...
- Question 55: An access switch has been configured with an EtherChannel po...
- Question 56: The command storm-control broadcast level 75 65 is configure...
- Question 57: After port security is deployed throughout an enterprise cam...
- Question 58: While working in the core network building, a technician acc...
- Question 59: Your customer has asked you to come in and verify the operat...
- Question 60: Refer to the exhibit. (Exhibit) Switch A, B, and C are trunk...
- Question 61: A network engineer must implement Ethernet links that are ca...
- Question 62: Refer to the exhibit. (Exhibit) What is the result of the SP...
- Question 63: Interface FastEthernet0/1 is configured as a trunk interface...
- Question 64: Which technique allows specific VLANs to be strictly permitt...
- Question 65: Refer to the exhibit. (Exhibit) How many bytes are added to ...
- Question 66: Which statement describes what happens if all VSL connection...
- Question 67: Which statement describes what happens when a switch enters ...
- Question 68: Which First Hop Redundancy Protocol is an IEEE Standard?...
- Question 69: Which feature puts the port into err-disabled state when the...
- Question 70: A network engineer wants to ensure Layer 2 isolation of cust...
- Question 71: The network manager has requested that several new VLANs (VL...
- Question 72: Which private VLAN can have only one VLAN and be a secondary...
- Question 73: Which statement describes one major issue that VTP can cause...
- Question 74: Refer to the exhibit. (Exhibit) What is the result of the co...
- Question 75: Which statement about the use of PagP link aggregation on a ...
- Question 76: A network engineer configured an Ethernet switch using these...
- Question 77: A network engineer has just deployed a non-Cisco device in t...
- Question 78: Refer to the exhibit. (Exhibit) The users in an engineering ...
- Question 79: Which statement about Cisco Discovery Protocol configuration...
- Question 80: Refer to the exhibit. (Exhibit) Which login credentials are ...
- Question 81: A network engineer configured a fault-tolerance link on Giga...
- Question 82: Which option is a possible cause for an errdisabled interfac...
- Question 83: What is the maximum number of virtual MAC addresses that GLB...
- Question 84: Which command creates a login authentication method named "l...
- Question 85: Which private VLAN access port belongs to the primary VLAN a...
- Question 86: What effect does the mac address-table aging-time 180 comman...
- Question 87: Which VTP mode is needed to configure an extended VLAN, when...
- Question 88: Your customer has asked you to come in and verify the operat...
- Question 89: After UDLD is implemented, a Network Administrator noticed t...
- Question 90: A Cisco Catalyst switch that is prone to reboots continues t...
- Question 91: A network engineer is setting up a new switched network. The...
- Question 92: A manager tells the network engineer to permit only certain ...
- Question 93: There was exhibit for RSPAN with two sessions...
- Question 94: Which statement about the use of SDM templates in a Cisco sw...
- Question 95: A network engineer must set the load balance method on an ex...
- Question 96: Which statement about using EtherChannel on Cisco IOS switch...
- Question 97: Refer to the exhibit. (Exhibit) A network engineer investiga...
- Question 98: Which command globally enables AAA on a device?...
- Question 99: If a network engineer applies the command mac-address-table ...
- Question 100: Refer to the exhibit. (Exhibit) Users of PC-1 experience slo...
- Question 101: Question with recognition of vlans 3050 and 3060...
- Question 102: Which feature is automatically enabled when a voice VLAN is ...
- Question 103: While doing network discovery using Cisco Discovery Protocol...
- Question 104: Which command configures an HSRP group to become a slave of ...
- Question 105: Ferris Plastics, Inc. is a medium sized company, with an ent...
- Question 106: Ferris Plastics, Inc. is a medium sized company, with an ent...
- Question 107: Which gateway role is responsible for answering ARP requests...
- Question 108: There is native VLAN mismatch after administrator change nat...
- Question 109: Which command correctly configures standby tracking for grou...
- Question 110: Which configuration command ties the router hot standby prio...
- Question 111: Why is there a mismatch? Switch1# sh etherchannel summary Nu...
- Question 112: One site is active on port channel what other side you can c...
- Question 113: A network is running VTPv2. After verifying all VTP settings...
- Question 114: What is the function of NSF?
- Question 115: A network engineer wants to add a new switch to an existing ...
- Question 116: A network engineer deployed a switch that operates the LAN b...
- Question 117: An access switch has been configured with an EtherChannel po...
- Question 118: A network engineer configures port security and 802.1x on th...
- Question 119: Which two protocols can be automatically negotiated between ...
- Question 120: What percentage of bandwidth is reduced when a stack cable i...
- Question 121: Select and Place: (Exhibit)
- Question 122: What is required for a LAN switch to support 802.1q Q-in-Q e...
- Question 123: Which option lists the information that is contained in a Ci...
- Question 124: Which action allows a network engineer to limit a default VL...
- Question 125: Which option describes a limitation of LLDP?...
- Question 126: Refer to the exhibit. (Exhibit) The network switches for two...
- Question 127: Which statement about LLDP-MED is true?...
- Question 128: Which statement about the UDLD protocol is true?...
- Question 129: What is the default amount by which the hot standby priority...
- Question 130: After configuring new data VLANs 1020 through 1030 on the VT...
- Question 131: A server with a statically assigned IP address is attached t...
- Question 132: Which option is a benefit of using VSS?...
- Question 133: Which feature must be enabled to eliminate the broadcasting ...
- Question 134: Which SDM template is the most appropriate for a Layer 2 swi...
- Question 135: Which command does a network engineer use to verify the span...
- Question 136: A network engineer changed the port speed and duplex setting...
- Question 137: An EtherChannel bundle has been established between a Cisco ...
- Question 138: What happens on a Cisco switch that runs Cisco IOS when an R...
- Question 139: Which command is needed to enable DHCP snooping if a switchp...
- Question 140: Which statement about Cisco devices learning about each othe...
- Question 141: After an EtherChannel is configured between two Cisco switch...
- Question 142: Refer to the exhibit. (Exhibit) Which statement about switch...
- Question 143: Refer to the exhibit. (Exhibit) Switch A, B, and C are trunk...
- Question 144: Refer to the exhibit. (Exhibit) A multilayer switch has been...
- Question 145: When you configure a private VLAN, which type of port must y...
- Question 146: What's state of port security by default in a switch?...
- Question 147: Where does a subordinate switch in a stack store the informa...
- Question 148: Which VRRP router is responsible for forwarding packets that...
- Question 149: DHCP snooping and IP Source Guard have been configured on a ...
- Question 150: Ferris Plastics, Inc. is a medium sized company, with an ent...
- Question 151: A network engineer tries to configure storm control on an Et...
- Question 152: Your customer has asked you to come in and verify the operat...
- Question 153: In which portion of the frame is the 802.1q header found?...
- Question 154: Which statement describes what happens when a port configure...
- Question 155: Ferris Plastics, Inc. is a medium sized company, with an ent...
- Question 156: Refer to the exhibit. (Exhibit) Which EtherChannel negotiati...
- Question 157: What is the maximum number of 10 Gigabit Ethernet connection...
- Question 158: When you configure private VLANs on a switch, which port typ...
- Question 159: A network engineer is trying to deploy a PC on a network. Th...
