Lab Simulation 10
Guidelines
This is a lab item in which tasks will be performed on virtual devices
- Refer to the Tasks tab to view the tasks for this lab item.
- Refer to the Topology tab to access the device console(s) and perform the tasks.
- Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window.
- All necessary preconfigurations have been applied.
- Do not change the enable password or hostname for any device.
- Save your configurations to NVRAM before moving to the next item.
- Click Next at the bottom of the screen to submit this lab and move to the next question.
- When Next is clicked the lab closes and cannot be reopened.
Topology

Tasks
Refer to the topology. All physical cabling is in place. Configure a local user account, a Named ACL (NACL), and security.
Task 1
Configure a local account on Sw101 with telnet access only on virtual ports 0-4. Use the following information:
- Username: support
- Password: max2learn
- Privilege level: Exec mode
Task 2
Configure and apply a single NACL on Sw101 using the following:
- Name: ENT_ACL
- Restrict only PC2 on VLAN 200 from pinging PC1
- Allow only PC2 on VLAN 200 to telnet to Sw101
- Prevent all other devices from telnetting from VLAN 200
- Allow all other network traffic from VLAN 200
Task 3
Configure security on interface Ethernet 0/0 of Sw102:
- Set the maximum number of secure MAC addresses to four.
- Drop packets with unknown source addresses until the number of secure MAC addresses drops below the configured maximum value. No notification action is required.
- Allow secure MAC addresses to be learned dynamically.