Lab Simulation 21
Guidelines
This is a lab item in which tasks will be performed on virtual devices.
- Refer to the Tasks tab to view the tasks for this lab item.
- Refer to the Topology lab to access the device console(s) and perform the tasks.
- Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window.
- All necessary preconfigurations have been applied.
- Do not change the enable password or hostname for any device.
- Save your configurations to NVRAM before moving to the next item.
- Click Next at the bottom of the screen to submit this lab and move to the next question.
- When Next is clicked, the lab closes and cannot be reopened.
Topology

Tasks
All physical cabling is in place and verified. Router R1 is configured and passing traffic for VLANs
5 and 6. All relevant ports are pre-configured as 802.1q trunks.
1. Configure SW-1 port E0/0 to permit only VLANS 5 and 6
2. Configure both SW-1 and SW-2's E0/1 ports to send and receive untagged traffic over VLAN
77
3. Configure SW-2 E0/2 port to permit only VLAN 6
4. Configure both SW-3 and SW-4 ports e0/0 and e0/1 for link aggregation using the industry standard protocol with the following requirements:
- SW-3 ports must immediately negotiate the aggregation protocol
- SW-4 ports must not initiate the negotiation for the aggregation protocol
- Use the designated number assignment