156-836 Exam Dumps | What does the lldpctl command do?

Home
CheckPoint
Check Point Certified Maestro Expert - R81 (CCME)
CheckPoint.156-836.v2024-06-27.q36
Question 30

Valid 156-836 Dumps shared by ExamDiscuss.com for Helping Passing 156-836 Exam! ExamDiscuss.com now offer the newest 156-836 exam dumps, the ExamDiscuss.com 156-836 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 156-836 dumps with Test Engine here:

Access 156-836 Dumps Premium Version
(90 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 30/36

What does the lldpctl command do?

A. Show all devices discovered by LLDP protocol on downlink ports

B. Show all devices discovered by LLDP protocol on all ports

C. Discover orchestrators

D. Show all devices discovered by LLDP protocol on uplink ports

Correct Answer: B

Explanation
The lldpctl command is a tool to display information about the devices discovered by the Link Layer Discovery Protocol (LLDP) on all ports of the Maestro Orchestrator and the Security Group Members. LLDP is a protocol that enables devices to exchange information about their identity, capabilities, and configuration.
LLDP can help to discover the topology and connectivity of the Maestro environment.
References
*Check Point Certified Maestro Expert (CCME) R81.X Courseware, Module 4: Using the Command Line Interface and WebUI, Lesson 4.2: LLDP, page 4-9
*Check Point R81 Maestro Administration Guide, Chapter 3: Working with Security Group Modules, Section:
LLDP, page 3-9

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (36q): Question 1: What cannot be learned from the output of lldpctl?...; Question 2: What can be learned from the output of sx_api_ports_dump.py ...; Question 3: What type of cluster can a Security Group can be compared to...; Question 4: What does asg monitor command do?...; Question 5: What is the throughput penalty of Security Group?...; Question 6: Maestro allows running commands globally in Expert mode by u...; Question 7: In a dual MHO environment, MHO1 and MHO2 are connected to th...; Question 8: How does HyperSync work in a Dual Site environment?...; Question 9: What Maestro component acts as a load balancer and network s...; Question 10: Do all MHOs need to be upgraded before starting the SGM upgr...; Question 11: Which distribution mode assigns packets to an SGM based sole...; Question 12: What will happen in case of NAT of the traffic passing throu...; Question 13: There are two 10Gbps dual-port NICs and one 40Gbps NIC insta...; Question 14: What is the purpose of g_tcpdump command?...; Question 15: What command should be used for collecting diagnostic inform...; Question 16: What cannot be a reason for "Failed to get remote orchestrat...; Question 17: During an upgrade, Is Multi-Version Clustering (MVC) support...; Question 18: What is a downlink interface used for?...; Question 19: Which command do you use to find bottlenecks in the system t...; Question 20: What happens if the SMO Master fails?...; Question 21: In a Maestro Dual Site environment, what is the definition o...; Question 22: For the MHO-175, which ports are Management ports?...; Question 23: What cannot be learned from the output of asg monitor comman...; Question 24: What is the Correction Layer?; Question 25: What kinds of transceivers are supported on Orchestrator MHO...; Question 26: There are two appliances within the same Security Group. One...; Question 27: What is the maximum number of Appliances within the same Sec...; Question 28: Possibilities for a failure in a single SGM of a Security Gr...; Question 29: What kinds of transceivers are supported on Orchestrator MHO...; Question 30: What does the lldpctl command do?...; Question 31: What is one benefit of a Dual MHO environment?...; Question 32: What is the difference between Dual-Site and Dual-Room?...; Question 33: The drop_monitor command is useful for...; Question 34: Where should sx_api_ports_dump.py command be ran?...; Question 35: Complete the sentence: Dual Orchestrators work as.______...; Question 36: Which licenses should be issued for the Orchestrator?...

[×]

Download PDF File

Enter your email address to download CheckPoint.156-836.v2024-06-27.q36.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 30/36

LEAVE A REPLY

Download PDF File