<< Prev Question Next Question >>

Question 26/36

There are two appliances within the same Security Group. One of them is connected by One downlink only, another one by Two downlinks. Assuming there's no NAT and no VPN, what would be proportion of traffic distribution done by Orchestrator?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (36q)
Question 1: What cannot be learned from the output of lldpctl?...
Question 2: What can be learned from the output of sx_api_ports_dump.py ...
Question 3: What type of cluster can a Security Group can be compared to...
Question 4: What does asg monitor command do?...
Question 5: What is the throughput penalty of Security Group?...
Question 6: Maestro allows running commands globally in Expert mode by u...
Question 7: In a dual MHO environment, MHO1 and MHO2 are connected to th...
Question 8: How does HyperSync work in a Dual Site environment?...
Question 9: What Maestro component acts as a load balancer and network s...
Question 10: Do all MHOs need to be upgraded before starting the SGM upgr...
Question 11: Which distribution mode assigns packets to an SGM based sole...
Question 12: What will happen in case of NAT of the traffic passing throu...
Question 13: There are two 10Gbps dual-port NICs and one 40Gbps NIC insta...
Question 14: What is the purpose of g_tcpdump command?...
Question 15: What command should be used for collecting diagnostic inform...
Question 16: What cannot be a reason for "Failed to get remote orchestrat...
Question 17: During an upgrade, Is Multi-Version Clustering (MVC) support...
Question 18: What is a downlink interface used for?...
Question 19: Which command do you use to find bottlenecks in the system t...
Question 20: What happens if the SMO Master fails?...
Question 21: In a Maestro Dual Site environment, what is the definition o...
Question 22: For the MHO-175, which ports are Management ports?...
Question 23: What cannot be learned from the output of asg monitor comman...
Question 24: What is the Correction Layer?
Question 25: What kinds of transceivers are supported on Orchestrator MHO...
Question 26: There are two appliances within the same Security Group. One...
Question 27: What is the maximum number of Appliances within the same Sec...
Question 28: Possibilities for a failure in a single SGM of a Security Gr...
Question 29: What kinds of transceivers are supported on Orchestrator MHO...
Question 30: What does the lldpctl command do?...
Question 31: What is one benefit of a Dual MHO environment?...
Question 32: What is the difference between Dual-Site and Dual-Room?...
Question 33: The drop_monitor command is useful for...
Question 34: Where should sx_api_ports_dump.py command be ran?...
Question 35: Complete the sentence: Dual Orchestrators work as.______...
Question 36: Which licenses should be issued for the Orchestrator?...