<< Prev Question Next Question >>

Question 13/36

There are two 10Gbps dual-port NICs and one 40Gbps NIC installed on a 23800 Appliance in slots 1, 2 and 3 accordingly. Which interfaces should be connected to Orchestrator 1 for downlinks' intra- orchestrator redundancy when using two Orchestrators?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (36q)
Question 1: What cannot be learned from the output of lldpctl?...
Question 2: What can be learned from the output of sx_api_ports_dump.py ...
Question 3: What type of cluster can a Security Group can be compared to...
Question 4: What does asg monitor command do?...
Question 5: What is the throughput penalty of Security Group?...
Question 6: Maestro allows running commands globally in Expert mode by u...
Question 7: In a dual MHO environment, MHO1 and MHO2 are connected to th...
Question 8: How does HyperSync work in a Dual Site environment?...
Question 9: What Maestro component acts as a load balancer and network s...
Question 10: Do all MHOs need to be upgraded before starting the SGM upgr...
Question 11: Which distribution mode assigns packets to an SGM based sole...
Question 12: What will happen in case of NAT of the traffic passing throu...
Question 13: There are two 10Gbps dual-port NICs and one 40Gbps NIC insta...
Question 14: What is the purpose of g_tcpdump command?...
Question 15: What command should be used for collecting diagnostic inform...
Question 16: What cannot be a reason for "Failed to get remote orchestrat...
Question 17: During an upgrade, Is Multi-Version Clustering (MVC) support...
Question 18: What is a downlink interface used for?...
Question 19: Which command do you use to find bottlenecks in the system t...
Question 20: What happens if the SMO Master fails?...
Question 21: In a Maestro Dual Site environment, what is the definition o...
Question 22: For the MHO-175, which ports are Management ports?...
Question 23: What cannot be learned from the output of asg monitor comman...
Question 24: What is the Correction Layer?
Question 25: What kinds of transceivers are supported on Orchestrator MHO...
Question 26: There are two appliances within the same Security Group. One...
Question 27: What is the maximum number of Appliances within the same Sec...
Question 28: Possibilities for a failure in a single SGM of a Security Gr...
Question 29: What kinds of transceivers are supported on Orchestrator MHO...
Question 30: What does the lldpctl command do?...
Question 31: What is one benefit of a Dual MHO environment?...
Question 32: What is the difference between Dual-Site and Dual-Room?...
Question 33: The drop_monitor command is useful for...
Question 34: Where should sx_api_ports_dump.py command be ran?...
Question 35: Complete the sentence: Dual Orchestrators work as.______...
Question 36: Which licenses should be issued for the Orchestrator?...