Next Question >>

Question 1/35

You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining.
Your FIRST preferred course of action is to:

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (35q)
Question 1: You are the NACE Inspector on a tank lining project where a ...
Question 2: You are the NACE Inspector on a 5000 sq. ft. job where SSPC ...
Question 3: What is the minimum spot measurement value allowed by SSPC-P...
Question 4: Owners hire NACE Inspectors' with the expectation that:...
Question 5: According to SSPC PA 2 a Spot Measurement is:...
Question 6: What is the minimum recommended distance away from an edge t...
Question 7: Inspector's daily reports are used: Select All That Apply...
Question 8: Conventional spray is a good choice when:...
Question 9: The initial steel condition is important to the NACE Inspect...
Question 10: Stripe coats are generally applied to:...
Question 11: ISO ST 3 is described as:
Question 12: Inspection documentation is important because:...
Question 13: An Inspector should change position when:...
Question 14: If the specifier does not identify a restriction level in ac...
Question 15: Common errors that can produce inaccurate readings when usin...
Question 16: Which is a component that supplies most of the features and ...
Question 17: The least effective method of surface cleaning is most likel...
Question 18: A NACE Coating Inspector is permitted to transport coating m...
Question 19: ISO SA 2.5 is defined as:
Question 20: If a Thermoset coating is heated it will:...
Question 21: What is used to determine compressed air cleanliness?...
Question 22: The primary difference between Non-Convertible vs. Convertib...
Question 23: NACE SP 0178 is a standard for:...
Question 24: When using the ISO comparator in accordance with ISO 8503, i...
Question 25: The form of corrosion that has the largest potential for une...
Question 26: ISO SA 3 is directly equivalent to:...
Question 27: NACE Level 1 Inspectors have been trained to perform:...
Question 28: Due to a previous premature coating failure the owner has re...
Question 29: Passivation can best be described as:...
Question 30: SSPC SP 1 identifies the use of:...
Question 31: ASTM Standards are applicable:
Question 32: If the project specification DOES NOT state the specific DFT...
Question 33: Check abrasive blast pressure with a...
Question 34: Relative humidity is
2 commentQuestion 35: A successful coating inspector must be able to...