<< Prev Question Next Question >>

Question 34/35

Relative humidity is

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (35q)
Question 1: You are the NACE Inspector on a tank lining project where a ...
Question 2: You are the NACE Inspector on a 5000 sq. ft. job where SSPC ...
Question 3: What is the minimum spot measurement value allowed by SSPC-P...
Question 4: Owners hire NACE Inspectors' with the expectation that:...
Question 5: According to SSPC PA 2 a Spot Measurement is:...
Question 6: What is the minimum recommended distance away from an edge t...
Question 7: Inspector's daily reports are used: Select All That Apply...
Question 8: Conventional spray is a good choice when:...
Question 9: The initial steel condition is important to the NACE Inspect...
Question 10: Stripe coats are generally applied to:...
Question 11: ISO ST 3 is described as:
Question 12: Inspection documentation is important because:...
Question 13: An Inspector should change position when:...
Question 14: If the specifier does not identify a restriction level in ac...
Question 15: Common errors that can produce inaccurate readings when usin...
Question 16: Which is a component that supplies most of the features and ...
Question 17: The least effective method of surface cleaning is most likel...
Question 18: A NACE Coating Inspector is permitted to transport coating m...
Question 19: ISO SA 2.5 is defined as:
Question 20: If a Thermoset coating is heated it will:...
Question 21: What is used to determine compressed air cleanliness?...
Question 22: The primary difference between Non-Convertible vs. Convertib...
Question 23: NACE SP 0178 is a standard for:...
Question 24: When using the ISO comparator in accordance with ISO 8503, i...
Question 25: The form of corrosion that has the largest potential for une...
Question 26: ISO SA 3 is directly equivalent to:...
Question 27: NACE Level 1 Inspectors have been trained to perform:...
Question 28: Due to a previous premature coating failure the owner has re...
Question 29: Passivation can best be described as:...
Question 30: SSPC SP 1 identifies the use of:...
Question 31: ASTM Standards are applicable:
Question 32: If the project specification DOES NOT state the specific DFT...
Question 33: Check abrasive blast pressure with a...
Question 34: Relative humidity is
2 commentQuestion 35: A successful coating inspector must be able to...