Valid H12-811_V1.0 Dumps shared by ExamDiscuss.com for Helping Passing H12-811_V1.0 Exam! ExamDiscuss.com now offer the newest H12-811_V1.0 exam dumps, the ExamDiscuss.com H12-811_V1.0 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com H12-811_V1.0 dumps with Test Engine here:
Access H12-811_V1.0 Dumps Premium Version
(352 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 21/132
(Which of the following is a dynamic IGP routing protocol?)
Correct Answer: D
* Dynamic IGP Routing Protocols:
* OSPF (Open Shortest Path First): A dynamic IGP that uses link-state information for routing within an autonomous system.
* Analysis of Options:
* Option A: "Static" refers to manually configured routes, not dynamic.
* Option B: "BGP" is a dynamic routing protocol but an EGP, not an IGP.
* Option C: "Direct" refers to routes learned from directly connected networks and is not dynamic.
* Option D: "OSPF" is a dynamic IGP, making it the correct choice.
* Correct Answer:The dynamic IGP routing protocol is D (OSPF).
* OSPF (Open Shortest Path First): A dynamic IGP that uses link-state information for routing within an autonomous system.
* Analysis of Options:
* Option A: "Static" refers to manually configured routes, not dynamic.
* Option B: "BGP" is a dynamic routing protocol but an EGP, not an IGP.
* Option C: "Direct" refers to routes learned from directly connected networks and is not dynamic.
* Option D: "OSPF" is a dynamic IGP, making it the correct choice.
* Correct Answer:The dynamic IGP routing protocol is D (OSPF).
- Question List (132q)
- Question 1: VLAN 4095 is reserved for system use and VLAN 1 cannot be de...
- Question 2: Which of the following VRP commands can be used to enter are...
- Question 3: A company applies for a class C IP address for subnetting. I...
- Question 4: Refer to the following VLAN configurations on a Huawei switc...
- Question 5: Which of the following statements about the commands shown i...
- Question 6: Wi-Fi 6 is also known as the IEEE 802.11ax standard....
- Question 7: When a router is powered on, the router reads the configurat...
- Question 8: For an Eth-Trunk in LACP mode, what is the default LACP syst...
- Question 9: If the application-layer protocol is Telnet, what is the val...
- Question 10: Which of the following is not a characteristic of small camp...
- Question 11: Only the WPA2-PSK security policy supports TKIP data encrypt...
- Question 12: To provide the information about the IP addresses that a use...
- Question 13: Which of the following network types are supported by OSPF?...
- Question 14: On the command line interface of Huawei AR routers, the role...
- Question 15: If the network administrator assigns the IPv4 address 192.16...
- Question 16: Which of the following port states is not included in Rapid ...
- Question 17: Which of the following network parameters can be allocated u...
- Question 18: Which of the following statements is true about link aggrega...
- Question 19: Which of the following commands sets the data forwarding mod...
- Question 20: UDP does not guarantee data transmission reliability and doe...
- Question 21: (Which of the following is a dynamic IGP routing protocol?)...
- Question 22: Which of the following is NOT an open API of Huawei controll...
- Question 23: By referring to the network structure and OSPF areas shown i...
- Question 24: If the packet matches the deny rule in an ACL, the packet is...
- Question 25: Which of the following MAC addresses cannot be used as the M...
- Question 26: Which of the following protocols can be used to prevent Laye...
- Question 27: The TCP protocol uses the three-way handshake mechanism to e...
- Question 28: With what kind of routers does a DRother router exchange lin...
- Question 29: When the ACL in the following figure is configured on a Teln...
- Question 30: The following figure shows the configuration of a sub-interf...
- Question 31: If the value of the "Type/Length" field of an Ethernet data ...
- Question 32: Which of the following fields are contained in an ARP packet...
- Question 33: Which of the following is not a common network layer in a mi...
- Question 34: On an STP-enabled switch, a port in the forwarding state can...
- Question 35: You can run the user-interface maximum-vty command to config...
- Question 36: Which of the following configurations can prevent Host A and...
- Question 37: Which of the following methods can be used to add APs on an ...
- Question 38: Which of the following statements about static routes on Hua...
- Question 39: When the "delete vrpcfg.zip" command is run on the Huawei VR...
- Question 40: (Which of the following methods can be used to assign servic...
- Question 41: On the VRP CLI, files cannot be permanently deleted using th...
- Question 42: The rules in an ACL may overlap. If packets match the rules ...
- Question 43: Which of the following statements about the routing table sh...
- Question 44: Which of the following statements about switches is false?...
- Question 45: What are the advantages of OSPF?...
- Question 46: Which of the following sources of routes can be obtained by ...
- Question 47: After a switch restarts, static MAC address entries saved on...
- Question 48: For STP, the default root path cost of the root bridge is 0....
- Question 49: The priority of static routes cannot be manually specified....
- Question 50: (The administrator performs the configuration shown in the f...
- Question 51: Refer to the graphic: 00e0-fc99-9999 is a specific host MAC ...
- Question 52: Which of the following descriptions regarding the TTL field ...
- Question 53: Which of the following is not a type of OSPF LSA?...
- Question 54: What is the total length of the port ID in STP?...
- Question 55: Refer to the display startup command output shown in the fig...
- Question 56: On the network shown in the figure, VLAN 2 is created on SWA...
- Question 57: What is the length range of an Ethernet_II frame that contai...
- Question 58: Refer to the captured three packets shown in the figure. Whi...
- Question 59: Which SNMP version focuses on two main aspects, namely secur...
- Question 60: On the VRP, when the mkdir test command is run, the system c...
- Question 61: As shown in the figure, RTA uses NAT and has an address pool...
- Question 62: Which of the following statements are true about transport-l...
- Question 63: A Layer 2 ACL can match information such as the source MAC a...
- Question 64: Which of the following parameters is not contained in STP co...
- Question 65: (Each network device running SNMP runs an agent process loca...
- Question 66: It is advised to assign static IP addresses to servers durin...
- Question 67: Refer to the following configuration of an interface on a sw...
- Question 68: (By default, in the SNMP protocol, which port number is used...
- Question 69: In RSTP, an edge port becomes a common STP port after receiv...
- Question 70: During STP calculation, the port cost is associated with the...
- Question 71: Which of the following statements about hybrid interfaces is...
- Question 72: In STP, the bridge ID on the switching network is as follows...
- Question 73: Fit APs can provide wireless services independently of an AC...
- Question 74: A router in the backbone area has complete LSDBs of routers ...
- Question 75: (Which of the following routing protocols are dynamic routin...
- Question 76: When an AP and an AC are located on different Layer 3 networ...
- Question 77: Which is a valid EUI-64 address?...
- Question 78: On the network shown in the figure, router A adopts link agg...
- Question 79: After the administrator performs the configuration shown in ...
- Question 80: Which of the following operations are mandatory to restore t...
- Question 81: The network administrator has decided to configure link aggr...
- Question 82: Assuming that OSPF has been enabled on all routers in the fo...
- Question 83: As shown in the figure, all switches run STP. Assume that th...
- Question 84: (ICMP packets do not contain port numbers. Therefore, NAPT c...
- Question 85: What is the protocol number of OSPF at the network layer?...
- Question 86: On Huawei AR G3 Series routers, which authentication modes d...
- Question 87: (An administrator cannot log in to a Huawei router through T...
- Question 88: While inspecting packets in the network, a network administr...
- Question 89: What is the default lease time of the IP address allocated b...
- Question 90: In STP, which of the following items may affect the selectio...
- Question 91: < Huawei > system-view [Huawei]command-privilege level...
- Question 92: Which of the following parameters is used to elect the root ...
- Question 93: The following configuration commands implement route backup ...
- Question 94: How many bytes are there in a basic IPv6 header?...
- Question 95: Which of the following advantages is/are provided by inter-V...
- Question 96: A trunk interface allows frames from multiple VLANs includin...
- Question 97: When a switch receives a unicast data frame, if the destinat...
- Question 98: Which of the following parts compose SNMP?...
- Question 99: As shown in the figure, the configuration of Router A is as ...
- Question 100: Which of the following is a valid default route configuratio...
- Question 101: According to OSI reference model, which layer is responsible...
- Question 102: RADIUS is a common protocol for implementing AAA....
- Question 103: An administrator wishes to configure a floating static route...
- Question 104: Refer to the network diagram. (Exhibit) Which of the followi...
- Question 105: When a host uses the IP address 192.168.1.2 to access the In...
- Question 106: Network devices running SNMP can proactively report traps to...
- Question 107: The load balancing modes at both ends of an Eth-Trunk can be...
- Question 108: Which of the following is a link-state routing protocol?...
- Question 109: Which of the following ACLs can match the transport layer po...
- Question 110: Which of the following parameters is used to elect the root ...
- Question 111: (Which of the following descriptions regarding the STP forwa...
- Question 112: On the network shown in the figure, Host A and Host B cannot...
- Question 113: Only one SSID can be bound to each radio of an AP....
- Question 114: (An Eth-Trunk interface can be used only as a Layer 2 interf...
- Question 115: (You can run the "pwd" and "dir" commands on the Versatile R...
- Question 116: The following figure shows the display interface Eth-Trunk 1...
- Question 117: Network Address and Port Translation (NAPT) allows multiple ...
- Question 118: Which of the following packets are exchanged between STAs an...
- Question 119: Which of the following OSPF packets can be sent to request t...
- Question 120: How many VLANs are created when using the following commands...
- Question 121: According to the VTY user interface configuration shown in t...
- Question 122: In RSTP, a backup port can replace a faulty root port....
- Question 123: The network administrator performs the configuration shown i...
- Question 124: The data link layer uses PPP encapsulation. The IP addresses...
- Question 125: Which of the following is the default port number of the Tel...
- Question 126: Which of the following traffic can be filtered by an advance...
- Question 127: VLANs can be assigned based on service types during campus n...
- Question 128: Trunk interfaces can send both tagged and untagged frames....
- Question 129: The tree topology is a hierarchical star topology, facilitat...
- Question 130: Loops may cause broadcast storms on a Layer 2 network....
- Question 131: A switch receives a unicast data frame with a VLAN tag but c...
- Question 132: In the case of Huawei routers, what is the "-i" parameter in...
