Valid H12-811_V1.0 Dumps shared by ExamDiscuss.com for Helping Passing H12-811_V1.0 Exam! ExamDiscuss.com now offer the newest H12-811_V1.0 exam dumps, the ExamDiscuss.com H12-811_V1.0 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com H12-811_V1.0 dumps with Test Engine here:
Access H12-811_V1.0 Dumps Premium Version
(352 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 15/132
The following figure shows the display stp command output on an STP-enabled port - Ethernet 0/0/1.
Which of the following statements about the command output is false?
Which of the following statements about the command output is false?
Correct Answer: A
* Understanding Timers:
* Forward Delay Timer: Default value is 15 seconds, not 20 seconds.
* Max Age Timer: Default value is 20 seconds.
* Hello Timer: The default interval is 2 seconds for BPDU transmission.
* Switch Role:
* The output indicates that the switch is not the root bridge, confirming option D is correct.
* Conclusion:
* Statement A is incorrect as the Forward Delay timer is not 20 seconds.
References: HCIA-Datacom V1.0 Certification Guide, Chapter 8: Spanning Tree Protocol.
* Forward Delay Timer: Default value is 15 seconds, not 20 seconds.
* Max Age Timer: Default value is 20 seconds.
* Hello Timer: The default interval is 2 seconds for BPDU transmission.
* Switch Role:
* The output indicates that the switch is not the root bridge, confirming option D is correct.
* Conclusion:
* Statement A is incorrect as the Forward Delay timer is not 20 seconds.
References: HCIA-Datacom V1.0 Certification Guide, Chapter 8: Spanning Tree Protocol.
- Question List (132q)
- Question 1: In the following figure, all links are Ethernet links, and a...
- Question 2: If the transport-layer protocol is UDP, the value of the "Pr...
- Question 3: (Refer to the display startup command output shown in the fi...
- Question 4: Which of the following statements are true about the dynamic...
- Question 5: A network administrator wishes to assign an IP address to a ...
- Question 6: The country code configuration affects the actual transmissi...
- Question 7: Only one SSID can be bound to each radio of an AP....
- Question 8: A trunk interface allows frames from multiple VLANs includin...
- Question 9: Which of the following fields are included in an MPLS header...
- Question 10: When two switches are connected through link aggregation, wh...
- Question 11: What are the advantages of using DHCP to allocate IP address...
- Question 12: Loops may cause broadcast storms on a Layer 2 network....
- Question 13: An administrator wishes to manage the router in the remote b...
- Question 14: (Which of the following OSPF packets can be used to confirm ...
- Question 15: The following figure shows the display stp command output on...
- Question 16: For an Eth-Trunk in LACP mode, what is the default LACP syst...
- Question 17: If the application-layer protocol is Telnet, what is the val...
- Question 18: An ACL rule is as follows. Which of the following IP address...
- Question 19: Which of the following port numbers is used by the FTP contr...
- Question 20: In the case of Huawei routers, what is the "-i" parameter in...
- Question 21: Which of the following methods is not supported by the Versa...
- Question 22: A router in the backbone area has complete LSDBs of routers ...
- Question 23: Which of the following advantages is/are provided by inter-V...
- Question 24: Which of the following port states is not included in Rapid ...
- Question 25: Which of the following statements is true?...
- Question 26: Which of the following statements about encapsulation and de...
- Question 27: Which of the following IP addresses can be used by another h...
- Question 28: Which of the following is the default value of the Router De...
- Question 29: During STP calculation, the port cost is associated with the...
- Question 30: Refer to the following configuration of an interface on a sw...
- Question 31: The following figure shows the display interface Eth-Trunk 1...
- Question 32: Which of the following is not a common network layer in a mi...
- Question 33: SDN requires the control and forwarding planes to be separat...
- Question 34: < Huawei > system-view [Huawei]command-privilege level...
- Question 35: Trunk interfaces can send both tagged and untagged frames....
- Question 36: What is the protocol of the Router Advertisement (RA) packet...
- Question 37: How many port states are involved in RSTP?...
- Question 38: (An Eth-Trunk interface can be used only as a Layer 2 interf...
- Question 39: Which of the following IEEE 802.11 standards supports a theo...
- Question 40: According to the VTY user interface configuration shown in t...
- Question 41: Static NAT can only implement one-to-one mapping between pri...
- Question 42: Refer to the following configuration of an interface on a sw...
- Question 43: While inspecting packets in the network, a network administr...
- Question 44: Which of the following port statuses may exist on an STP-ena...
- Question 45: (An administrator cannot log in to a Huawei router through T...
- Question 46: When a host uses the stateless address autoconfiguration sol...
- Question 47: As shown in the figure, all switches run STP. Assume that th...
- Question 48: What is used as the data link-layer MAC address that identif...
- Question 49: (Loops may cause broadcast storms on a Layer 2 network.)...
- Question 50: Which is a valid EUI-64 address?...
- Question 51: Which of the following statements is true about root bridge ...
- Question 52: SNMP packets are transmitted by UDP....
- Question 53: (Which of the following routing protocols are dynamic routin...
- Question 54: On the VRP, when the mkdir test command is run, the system c...
- Question 55: Which of the following statements about the output on the ro...
- Question 56: The router that runs OSPF first enters the Full state and th...
- Question 57: Assuming that OSPF has been enabled on all routers in the fo...
- Question 58: The router that runs OSPF first enters the Full state and th...
- Question 59: Which of the following are features of the OSPF protocol?...
- Question 60: (Which of the following statements is true about active inte...
- Question 61: If a device running STP receives an RSTP configuration BPDU,...
- Question 62: If the packet matches the deny rule in an ACL, the packet is...
- Question 63: On the VRP CLI, files cannot be permanently deleted using th...
- Question 64: Which of the following states indicates that the OSPF neighb...
- Question 65: Assuming all STP enabled switches have the same bridge prior...
- Question 66: Which of the following parameters is used to elect the root ...
- Question 67: Which of the following BIDs cannot be contained in a configu...
- Question 68: (Which of the following statements about IPv6 anycast addres...
- Question 69: According to the one-armed routing configurations shown in t...
- Question 70: The IP address 192.168.1.127/25 represents a ( ) address....
- Question 71: On a Layer 2 WLAN, STAs use an AC as their gateway....
- Question 72: Which of the following descriptions regarding the TTL field ...
- Question 73: When an AP and an AC are located on different Layer 3 networ...
- Question 74: Which of the following operations are mandatory to restore t...
- Question 75: What is the default lease time of the IP address allocated b...
- Question 76: Which of the following statements is true about the Forward ...
- Question 77: In RSTP mode, both alternate and backup ports cannot forward...
- Question 78: Which of the following mask lengths is recommended for devic...
- Question 79: If the value of the "Type/Length" field of an Ethernet data ...
- Question 80: Which of the following is a link-state routing protocol?...
- Question 81: What is the number range of an advanced ACL?...
- Question 82: Which of the following port states is not included in Rapid ...
- Question 83: When the ACL in the following figure is configured on a Teln...
- Question 84: Which of the following packets is used by OSPF to describe i...
- Question 85: (Network Functions Virtualization (NFV) implements software-...
- Question 86: What are the advantages of OSPF?...
- Question 87: On Huawei routers, which of the following is the default pre...
- Question 88: On the network shown in the figure, Host A and Host B cannot...
- Question 89: VLAN 4095 is reserved for system use and VLAN 1 cannot be de...
- Question 90: In STP, the bridge ID on the switching network is as follows...
- Question 91: telnetlib is a module provided by Python to implement the Te...
- Question 92: (The IP addresses of VLANIF interfaces on the same switch mu...
- Question 93: Which of the following is not included in the routing table?...
- Question 94: Which of the following methods is not used for logging in to...
- Question 95: Which of the following network types does OSPF support?...
- Question 96: An ACL is essentially a packet filter. An ACL takes effect o...
- Question 97: As specified by the RSTP protocol, when a root port fails, w...
- Question 98: In RSTP, a backup port can replace a faulty root port....
- Question 99: (If a routing table contains multiple routes to the same des...
- Question 100: What is the length range of an Ethernet_II frame that contai...
- Question 101: On the VRP platform, which of the following parameters can b...
- Question 102: What function does Ctrl+Z have in the VRP system?...
- Question 103: Dynamic routing protocols can automatically adapt to network...
- Question 104: If AAA authentication is used on Huawei devices and the remo...
- Question 105: What is the protocol number of OSPF at the network layer?...
- Question 106: When both ends running PPP protocol detect that the physical...
- Question 107: After the administrator performs the configuration shown in ...
- Question 108: Which of the following commands sets the data forwarding mod...
- Question 109: The TCP protocol uses the three-way handshake mechanism to e...
- Question 110: A company applies for a class C IP address for subnetting. I...
- Question 111: An administrator wishes to configure a floating static route...
- Question 112: Refer to the display startup command output shown in the fig...
- Question 113: Network devices running SNMP can proactively report traps to...
- Question 114: What packet types are included in DHCP?...
- Question 115: (Each network device running SNMP runs an agent process loca...
- Question 116: On the network shown in the figure, the router receives a da...
- Question 117: When a switch receives a unicast data frame, if the destinat...
- Question 118: The authentication, authorization, and accounting schemes an...
- Question 119: IPv6 uses NS and NA packets to perform duplicate address det...
- Question 120: Which of the following IPv4 addresses can be directly used b...
- Question 121: Which of the following commands can switch a view from the s...
- Question 122: A routing entry contains multiple fields. Which of the follo...
- Question 123: Assume that an OSPF-enabled router has no loopback interface...
- Question 124: On the Huawei VRP, what is the default preference of differe...
- Question 125: If the broadcast address of a network is 172.16.1.255, which...
- Question 126: Which of the following statements about switches is false?...
- Question 127: As shown in the figure, the host has ARP cache. Host A sends...
- Question 128: If the network administrator assigns the IPv4 address 192.16...
- Question 129: The Priority field in a VLAN tag can be used to identify the...
- Question 130: Network Address and Port Translation (NAPT) allows multiple ...
- Question 131: (What is the main function of a dynamic routing protocol?)...
- Question 132: Refer to the following configuration of an interface on a sw...
