Valid H12-811_V1.0 Dumps shared by ExamDiscuss.com for Helping Passing H12-811_V1.0 Exam! ExamDiscuss.com now offer the newest H12-811_V1.0 exam dumps, the ExamDiscuss.com H12-811_V1.0 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com H12-811_V1.0 dumps with Test Engine here:
Access H12-811_V1.0 Dumps Premium Version
(352 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 18/132
An ACL rule is as follows. Which of the following IP addresses can be matched by the permit rule?
rule 5 permit ip source 10.0.2.0 0.0.254.255
rule 5 permit ip source 10.0.2.0 0.0.254.255
Correct Answer: C
Comprehensive Explanation: The wildcard mask 0.0.254.255 corresponds to a range of IP addresses where the second octet can vary between 2 and 4, and the third octet can vary between 0 and 255. This means the ACL rule matches IP addresses in the range 10.0.2.0 to 10.0.4.255. The only option that falls within this range is 10.0.4.5, making it the correct answer.
- Question List (132q)
- Question 1: In the following figure, all links are Ethernet links, and a...
- Question 2: If the transport-layer protocol is UDP, the value of the "Pr...
- Question 3: (Refer to the display startup command output shown in the fi...
- Question 4: Which of the following statements are true about the dynamic...
- Question 5: A network administrator wishes to assign an IP address to a ...
- Question 6: The country code configuration affects the actual transmissi...
- Question 7: Only one SSID can be bound to each radio of an AP....
- Question 8: A trunk interface allows frames from multiple VLANs includin...
- Question 9: Which of the following fields are included in an MPLS header...
- Question 10: When two switches are connected through link aggregation, wh...
- Question 11: What are the advantages of using DHCP to allocate IP address...
- Question 12: Loops may cause broadcast storms on a Layer 2 network....
- Question 13: An administrator wishes to manage the router in the remote b...
- Question 14: (Which of the following OSPF packets can be used to confirm ...
- Question 15: The following figure shows the display stp command output on...
- Question 16: For an Eth-Trunk in LACP mode, what is the default LACP syst...
- Question 17: If the application-layer protocol is Telnet, what is the val...
- Question 18: An ACL rule is as follows. Which of the following IP address...
- Question 19: Which of the following port numbers is used by the FTP contr...
- Question 20: In the case of Huawei routers, what is the "-i" parameter in...
- Question 21: Which of the following methods is not supported by the Versa...
- Question 22: A router in the backbone area has complete LSDBs of routers ...
- Question 23: Which of the following advantages is/are provided by inter-V...
- Question 24: Which of the following port states is not included in Rapid ...
- Question 25: Which of the following statements is true?...
- Question 26: Which of the following statements about encapsulation and de...
- Question 27: Which of the following IP addresses can be used by another h...
- Question 28: Which of the following is the default value of the Router De...
- Question 29: During STP calculation, the port cost is associated with the...
- Question 30: Refer to the following configuration of an interface on a sw...
- Question 31: The following figure shows the display interface Eth-Trunk 1...
- Question 32: Which of the following is not a common network layer in a mi...
- Question 33: SDN requires the control and forwarding planes to be separat...
- Question 34: < Huawei > system-view [Huawei]command-privilege level...
- Question 35: Trunk interfaces can send both tagged and untagged frames....
- Question 36: What is the protocol of the Router Advertisement (RA) packet...
- Question 37: How many port states are involved in RSTP?...
- Question 38: (An Eth-Trunk interface can be used only as a Layer 2 interf...
- Question 39: Which of the following IEEE 802.11 standards supports a theo...
- Question 40: According to the VTY user interface configuration shown in t...
- Question 41: Static NAT can only implement one-to-one mapping between pri...
- Question 42: Refer to the following configuration of an interface on a sw...
- Question 43: While inspecting packets in the network, a network administr...
- Question 44: Which of the following port statuses may exist on an STP-ena...
- Question 45: (An administrator cannot log in to a Huawei router through T...
- Question 46: When a host uses the stateless address autoconfiguration sol...
- Question 47: As shown in the figure, all switches run STP. Assume that th...
- Question 48: What is used as the data link-layer MAC address that identif...
- Question 49: (Loops may cause broadcast storms on a Layer 2 network.)...
- Question 50: Which is a valid EUI-64 address?...
- Question 51: Which of the following statements is true about root bridge ...
- Question 52: SNMP packets are transmitted by UDP....
- Question 53: (Which of the following routing protocols are dynamic routin...
- Question 54: On the VRP, when the mkdir test command is run, the system c...
- Question 55: Which of the following statements about the output on the ro...
- Question 56: The router that runs OSPF first enters the Full state and th...
- Question 57: Assuming that OSPF has been enabled on all routers in the fo...
- Question 58: The router that runs OSPF first enters the Full state and th...
- Question 59: Which of the following are features of the OSPF protocol?...
- Question 60: (Which of the following statements is true about active inte...
- Question 61: If a device running STP receives an RSTP configuration BPDU,...
- Question 62: If the packet matches the deny rule in an ACL, the packet is...
- Question 63: On the VRP CLI, files cannot be permanently deleted using th...
- Question 64: Which of the following states indicates that the OSPF neighb...
- Question 65: Assuming all STP enabled switches have the same bridge prior...
- Question 66: Which of the following parameters is used to elect the root ...
- Question 67: Which of the following BIDs cannot be contained in a configu...
- Question 68: (Which of the following statements about IPv6 anycast addres...
- Question 69: According to the one-armed routing configurations shown in t...
- Question 70: The IP address 192.168.1.127/25 represents a ( ) address....
- Question 71: On a Layer 2 WLAN, STAs use an AC as their gateway....
- Question 72: Which of the following descriptions regarding the TTL field ...
- Question 73: When an AP and an AC are located on different Layer 3 networ...
- Question 74: Which of the following operations are mandatory to restore t...
- Question 75: What is the default lease time of the IP address allocated b...
- Question 76: Which of the following statements is true about the Forward ...
- Question 77: In RSTP mode, both alternate and backup ports cannot forward...
- Question 78: Which of the following mask lengths is recommended for devic...
- Question 79: If the value of the "Type/Length" field of an Ethernet data ...
- Question 80: Which of the following is a link-state routing protocol?...
- Question 81: What is the number range of an advanced ACL?...
- Question 82: Which of the following port states is not included in Rapid ...
- Question 83: When the ACL in the following figure is configured on a Teln...
- Question 84: Which of the following packets is used by OSPF to describe i...
- Question 85: (Network Functions Virtualization (NFV) implements software-...
- Question 86: What are the advantages of OSPF?...
- Question 87: On Huawei routers, which of the following is the default pre...
- Question 88: On the network shown in the figure, Host A and Host B cannot...
- Question 89: VLAN 4095 is reserved for system use and VLAN 1 cannot be de...
- Question 90: In STP, the bridge ID on the switching network is as follows...
- Question 91: telnetlib is a module provided by Python to implement the Te...
- Question 92: (The IP addresses of VLANIF interfaces on the same switch mu...
- Question 93: Which of the following is not included in the routing table?...
- Question 94: Which of the following methods is not used for logging in to...
- Question 95: Which of the following network types does OSPF support?...
- Question 96: An ACL is essentially a packet filter. An ACL takes effect o...
- Question 97: As specified by the RSTP protocol, when a root port fails, w...
- Question 98: In RSTP, a backup port can replace a faulty root port....
- Question 99: (If a routing table contains multiple routes to the same des...
- Question 100: What is the length range of an Ethernet_II frame that contai...
- Question 101: On the VRP platform, which of the following parameters can b...
- Question 102: What function does Ctrl+Z have in the VRP system?...
- Question 103: Dynamic routing protocols can automatically adapt to network...
- Question 104: If AAA authentication is used on Huawei devices and the remo...
- Question 105: What is the protocol number of OSPF at the network layer?...
- Question 106: When both ends running PPP protocol detect that the physical...
- Question 107: After the administrator performs the configuration shown in ...
- Question 108: Which of the following commands sets the data forwarding mod...
- Question 109: The TCP protocol uses the three-way handshake mechanism to e...
- Question 110: A company applies for a class C IP address for subnetting. I...
- Question 111: An administrator wishes to configure a floating static route...
- Question 112: Refer to the display startup command output shown in the fig...
- Question 113: Network devices running SNMP can proactively report traps to...
- Question 114: What packet types are included in DHCP?...
- Question 115: (Each network device running SNMP runs an agent process loca...
- Question 116: On the network shown in the figure, the router receives a da...
- Question 117: When a switch receives a unicast data frame, if the destinat...
- Question 118: The authentication, authorization, and accounting schemes an...
- Question 119: IPv6 uses NS and NA packets to perform duplicate address det...
- Question 120: Which of the following IPv4 addresses can be directly used b...
- Question 121: Which of the following commands can switch a view from the s...
- Question 122: A routing entry contains multiple fields. Which of the follo...
- Question 123: Assume that an OSPF-enabled router has no loopback interface...
- Question 124: On the Huawei VRP, what is the default preference of differe...
- Question 125: If the broadcast address of a network is 172.16.1.255, which...
- Question 126: Which of the following statements about switches is false?...
- Question 127: As shown in the figure, the host has ARP cache. Host A sends...
- Question 128: If the network administrator assigns the IPv4 address 192.16...
- Question 129: The Priority field in a VLAN tag can be used to identify the...
- Question 130: Network Address and Port Translation (NAPT) allows multiple ...
- Question 131: (What is the main function of a dynamic routing protocol?)...
- Question 132: Refer to the following configuration of an interface on a sw...
