<< Prev Question Next Question >>

Question 19/116

Which state does the OSPF protocol use to indicate that the neighbor relationship has been established?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (116q)
1 commentQuestion 1: Which of the following options does not belong to the SDN ne...
Question 2: Which of the following statements about VLANIF interfaces ar...
Question 3: RADIUS is a common protocol to implement AAA....
Question 4: Which of the following statements about the various versions...
Question 5: VRP does not support how to configure the router?...
2 commentQuestion 6: Which layers are not included in the TCP/IP model?...
Question 7: In the network shown in the figure below, the network admini...
Question 8: The MAC address table of the existing switches is shown in t...
Question 9: The administrator has configured the router as shown in the ...
Question 10: The transmission rate of an Eth-Trunk port in manual link ag...
Question 11: The two switches shown in the figure below have both enabled...
Question 12: Using a traditional landline to make a call is a way of netw...
Question 13: According to the command output as shown in the figure, the ...
Question 14: When a switch receives a unicast data frame with a VLAN tag,...
Question 15: The priority of the LACP protocol is shown in the figure. Sw...
Question 16: The administrator plans to implement route backup by configu...
Question 17: In the broadcast network shown in the figure, OSPF runs on f...
Question 18: The information shown in the figure is the port status infor...
Question 19: Which state does the OSPF protocol use to indicate that the ...
Question 20: After the network administrator uses the TracertRoute functi...
Question 21: The MAC address table of the existing switches is shown in t...
Question 22: What is the full name of the general routing platform VRP?...
Question 23: Only the WPA2-PSK security policy supports the use of TKIP f...
Question 24: If the administrator wants to update the VRP version of Huaw...
Question 25: An AR2200 router needs to restore the initial configuration,...
Question 26: The configuration information of a certain port of the switc...
Question 27: On the broadcast network, both DR and BDR use the multicast ...
Question 28: A company applies for a Class C IP address segment, but it m...
Question 29: In the network shown in the figure below, the host has an AR...
Question 30: Trunk port can allow multiple vlans to pass, including vlan ...
Question 31: On the VRP platform, the priority of the default protocol fo...
1 commentQuestion 32: In the figure below, all switches have enabled the STP proto...
Question 33: Which version of the SNMP protocol below supports encryption...
Question 34: Which of the following is not included in the VRP system log...
Question 35: Which of the following port states does not include the RSTP...
Question 36: The function of OSPF's hello message is ()....
Question 37: What kind of packets does the OSPF protocol use to describe ...
Question 38: Using the ACL shown in the figure on the router RTA to match...
Question 39: What is the role of link aggregation?...
Question 40: The switch becomes a logical switch after stacking and clust...
Question 41: It is used to identify wireless networks in WLAN. What disti...
Question 42: The following description of the specified port of the spann...
Question 43: AAA does not include which of the following....
Question 44: In the following options, the necessary technology to enable...
Question 45: Which field in the IPv6 header is similar to the TTL field i...
Question 46: As shown in the figure, the switch runs STP with default par...
Question 47: What command line views exist on the VRP operating platform?...
Question 48: On Huawei AR G3 series routers, what authorization modes doe...
Question 49: In the network shown in the figure below, when the 0SPF neig...
Question 50: The configuration information of a certain interface of the ...
Question 51: In the network shown in the figure below, the host logs in t...
Question 52: Which of the following IPv6 addresses is a link local addres...
Question 53: The function of telnet. read_very_eager in Telnet lib is to ...
Question 54: A company applies for a Class C IP address segment, which ne...
Question 55: When configuring the Telnet login user interface. The authen...
Question 56: The network structure and OSPF partition are shown in the fi...
Question 57: Which of the following statements are correct about the VLAN...
Question 58: When AP and AC are on different Layer 3 networks, what metho...
Question 59: If the Ethernet data frame Length/Type=0x0806, which of the ...
Question 60: Only one SSID can be bound to an AP radio....
Question 61: When the IPv4 protocol is used as the network layer protocol...
1 commentQuestion 62: The output information of a certain router is shown in the f...
Question 63: Which encryption algorithm used by WLAN has the highest secu...
Question 64: A host must configure a gateway to communicate with other ho...
Question 65: What is the command for configuring the data forwarding mode...
Question 66: In PPP, when the two ends of the communication detect that t...
Question 67: The link aggregation interface can only be used as a Layer 2...
Question 68: How many types of data flows with different service levels c...
Question 69: Telnetlib is a module that implements the Telnet protocol th...
Question 70: How many bits are there in the VLAN ID in the VLAN frame for...
Question 71: By default, it takes at least 30s for the port status in the...
Question 72: By default, what is the RouterDeadInterval of the OSPF proto...
Question 73: The network administrator finds that a certain port of the s...
Question 74: What is the total length of the port ID in the spanning tree...
Question 75: Which of the following types of addresses are not included i...
Question 76: What is the total length of the interface identifier of the ...
Question 77: The switch is connected to the host. What is the common port...
Question 78: The network administrator hopes to be able to effectively us...
Question 79: What are the stable states of OSPF neighbor relationship?...
Question 80: What is the range of VLAN ID users can use?...
Question 81: What kind of message does the OSPF protocol use to confirm t...
Question 82: The user cannot configure the VLAN ID to 0....
Question 83: The CAPWAP control tunnel and data tunnel transmission adopt...
Question 84: What are the functions of OSPF protocol DR and BDR?...
Question 85: When planning a campus network, which of the following mask ...
Question 86: If the ipv4 address of a host in the LAN is 192.168.1.1/30, ...
Question 87: If the broadcast address of a network is 172.16.1.255, then ...
Question 88: What is correct about the dynamic MAC address table?...
Question 89: The login timeout period in the VRP system can only be set u...
Question 90: An ACL is essentially a packet filter. Only when the ACL is ...
Question 91: Which of the following statements about link aggregation in ...
Question 92: Which of the following working modes does Huawei Enterprise ...
Question 93: The CAPWAP protocol specifies the communication standard bet...
Question 94: What kind of packets does the OSPF protocol use to request L...
Question 95: Which of the following statements about static routing in Hu...
Question 96: A company has 50 private IP addresses. The administrator use...
Question 97: Which of the following messages are used for IPv6 stateless ...
Question 98: The administrator configures OSPF on a router, but the loopb...
Question 99: When Huawei switches run STP, the priority of the switch is ...
Question 100: In order to realize the network layer function on the VLANIF...
Question 101: Which of the following are not characteristics of a small ca...
Question 102: When we search for accessible wireless networks on our lapto...
Question 103: What kind of packets does the OSPF protocol use to discover ...
Question 104: When building a campus network, which of the following proto...
Question 105: If a windows host is started for the first time, if it uses ...
Question 106: Which of the following descriptions of OSPF DD packets and L...
Question 107: What is correct about the SNMP protocol?...
Question 108: Which of the following IPv6 addresses is a multicast address...
Question 109: An existing switch is connected to a designated port through...
Question 110: Which information of the data frame is used by the VLANIF in...
Question 111: The MAC address table of a certain switch is shown in the fi...
Question 112: What to do when the Trunk port sends data frames?...
Question 113: Which of the following fields does the MPLS header include?...
Question 114: The mask length is 12 bits can be expressed as?...
Question 115: What is the main function of the dynamic routing protocol?...
Question 116: Which of the following parameters is used in LCP negotiation...