<< Prev Question Next Question >>

Question 20/116

After the network administrator uses the TracertRoute function on the router device, in the data packet sent by the router, the value of the Protocol field in the IPv4 header is?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (116q)
1 commentQuestion 1: Which of the following options does not belong to the SDN ne...
Question 2: Which of the following statements about VLANIF interfaces ar...
Question 3: RADIUS is a common protocol to implement AAA....
Question 4: Which of the following statements about the various versions...
Question 5: VRP does not support how to configure the router?...
2 commentQuestion 6: Which layers are not included in the TCP/IP model?...
Question 7: In the network shown in the figure below, the network admini...
Question 8: The MAC address table of the existing switches is shown in t...
Question 9: The administrator has configured the router as shown in the ...
Question 10: The transmission rate of an Eth-Trunk port in manual link ag...
Question 11: The two switches shown in the figure below have both enabled...
Question 12: Using a traditional landline to make a call is a way of netw...
Question 13: According to the command output as shown in the figure, the ...
Question 14: When a switch receives a unicast data frame with a VLAN tag,...
Question 15: The priority of the LACP protocol is shown in the figure. Sw...
Question 16: The administrator plans to implement route backup by configu...
Question 17: In the broadcast network shown in the figure, OSPF runs on f...
Question 18: The information shown in the figure is the port status infor...
Question 19: Which state does the OSPF protocol use to indicate that the ...
Question 20: After the network administrator uses the TracertRoute functi...
Question 21: The MAC address table of the existing switches is shown in t...
Question 22: What is the full name of the general routing platform VRP?...
Question 23: Only the WPA2-PSK security policy supports the use of TKIP f...
Question 24: If the administrator wants to update the VRP version of Huaw...
Question 25: An AR2200 router needs to restore the initial configuration,...
Question 26: The configuration information of a certain port of the switc...
Question 27: On the broadcast network, both DR and BDR use the multicast ...
Question 28: A company applies for a Class C IP address segment, but it m...
Question 29: In the network shown in the figure below, the host has an AR...
Question 30: Trunk port can allow multiple vlans to pass, including vlan ...
Question 31: On the VRP platform, the priority of the default protocol fo...
1 commentQuestion 32: In the figure below, all switches have enabled the STP proto...
Question 33: Which version of the SNMP protocol below supports encryption...
Question 34: Which of the following is not included in the VRP system log...
Question 35: Which of the following port states does not include the RSTP...
Question 36: The function of OSPF's hello message is ()....
Question 37: What kind of packets does the OSPF protocol use to describe ...
Question 38: Using the ACL shown in the figure on the router RTA to match...
Question 39: What is the role of link aggregation?...
Question 40: The switch becomes a logical switch after stacking and clust...
Question 41: It is used to identify wireless networks in WLAN. What disti...
Question 42: The following description of the specified port of the spann...
Question 43: AAA does not include which of the following....
Question 44: In the following options, the necessary technology to enable...
Question 45: Which field in the IPv6 header is similar to the TTL field i...
Question 46: As shown in the figure, the switch runs STP with default par...
Question 47: What command line views exist on the VRP operating platform?...
Question 48: On Huawei AR G3 series routers, what authorization modes doe...
Question 49: In the network shown in the figure below, when the 0SPF neig...
Question 50: The configuration information of a certain interface of the ...
Question 51: In the network shown in the figure below, the host logs in t...
Question 52: Which of the following IPv6 addresses is a link local addres...
Question 53: The function of telnet. read_very_eager in Telnet lib is to ...
Question 54: A company applies for a Class C IP address segment, which ne...
Question 55: When configuring the Telnet login user interface. The authen...
Question 56: The network structure and OSPF partition are shown in the fi...
Question 57: Which of the following statements are correct about the VLAN...
Question 58: When AP and AC are on different Layer 3 networks, what metho...
Question 59: If the Ethernet data frame Length/Type=0x0806, which of the ...
Question 60: Only one SSID can be bound to an AP radio....
Question 61: When the IPv4 protocol is used as the network layer protocol...
1 commentQuestion 62: The output information of a certain router is shown in the f...
Question 63: Which encryption algorithm used by WLAN has the highest secu...
Question 64: A host must configure a gateway to communicate with other ho...
Question 65: What is the command for configuring the data forwarding mode...
Question 66: In PPP, when the two ends of the communication detect that t...
Question 67: The link aggregation interface can only be used as a Layer 2...
Question 68: How many types of data flows with different service levels c...
Question 69: Telnetlib is a module that implements the Telnet protocol th...
Question 70: How many bits are there in the VLAN ID in the VLAN frame for...
Question 71: By default, it takes at least 30s for the port status in the...
Question 72: By default, what is the RouterDeadInterval of the OSPF proto...
Question 73: The network administrator finds that a certain port of the s...
Question 74: What is the total length of the port ID in the spanning tree...
Question 75: Which of the following types of addresses are not included i...
Question 76: What is the total length of the interface identifier of the ...
Question 77: The switch is connected to the host. What is the common port...
Question 78: The network administrator hopes to be able to effectively us...
Question 79: What are the stable states of OSPF neighbor relationship?...
Question 80: What is the range of VLAN ID users can use?...
Question 81: What kind of message does the OSPF protocol use to confirm t...
Question 82: The user cannot configure the VLAN ID to 0....
Question 83: The CAPWAP control tunnel and data tunnel transmission adopt...
Question 84: What are the functions of OSPF protocol DR and BDR?...
Question 85: When planning a campus network, which of the following mask ...
Question 86: If the ipv4 address of a host in the LAN is 192.168.1.1/30, ...
Question 87: If the broadcast address of a network is 172.16.1.255, then ...
Question 88: What is correct about the dynamic MAC address table?...
Question 89: The login timeout period in the VRP system can only be set u...
Question 90: An ACL is essentially a packet filter. Only when the ACL is ...
Question 91: Which of the following statements about link aggregation in ...
Question 92: Which of the following working modes does Huawei Enterprise ...
Question 93: The CAPWAP protocol specifies the communication standard bet...
Question 94: What kind of packets does the OSPF protocol use to request L...
Question 95: Which of the following statements about static routing in Hu...
Question 96: A company has 50 private IP addresses. The administrator use...
Question 97: Which of the following messages are used for IPv6 stateless ...
Question 98: The administrator configures OSPF on a router, but the loopb...
Question 99: When Huawei switches run STP, the priority of the switch is ...
Question 100: In order to realize the network layer function on the VLANIF...
Question 101: Which of the following are not characteristics of a small ca...
Question 102: When we search for accessible wireless networks on our lapto...
Question 103: What kind of packets does the OSPF protocol use to discover ...
Question 104: When building a campus network, which of the following proto...
Question 105: If a windows host is started for the first time, if it uses ...
Question 106: Which of the following descriptions of OSPF DD packets and L...
Question 107: What is correct about the SNMP protocol?...
Question 108: Which of the following IPv6 addresses is a multicast address...
Question 109: An existing switch is connected to a designated port through...
Question 110: Which information of the data frame is used by the VLANIF in...
Question 111: The MAC address table of a certain switch is shown in the fi...
Question 112: What to do when the Trunk port sends data frames?...
Question 113: Which of the following fields does the MPLS header include?...
Question 114: The mask length is 12 bits can be expressed as?...
Question 115: What is the main function of the dynamic routing protocol?...
Question 116: Which of the following parameters is used in LCP negotiation...