Valid HPE6-A85 Dumps shared by ExamDiscuss.com for Helping Passing HPE6-A85 Exam! ExamDiscuss.com now offer the newest HPE6-A85 exam dumps, the ExamDiscuss.com HPE6-A85 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com HPE6-A85 dumps with Test Engine here:
Access HPE6-A85 Dumps Premium Version
(104 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 7/51
When measuring signal strength, dBm is commonly used and 0 dBm corresponds to 1 mW power.
What does -20 dBm correspond to?
What does -20 dBm correspond to?
Correct Answer: B
dBm is a unit of power that measures the ratio of a given power level to 1 mW. The formula to convert dBm to mW is: P(mW) = 1mW * 10^(P(dBm)/10). Therefore, -20 dBm corresponds to 0.01 mW, as follows: P(mW) = 1mW * 10^(-20/10) = 0.01 mW References: https://www.rapidtables.com/convert/power/dBm_to_mW.html
- Question List (51q)
- Question 1: Based on the "show ip route" output on an Aruba CX 8325, wha...
- Question 2: You need to drop excessive broadcast traffic on ingress to a...
- Question 3: What is indicated by a flashing amber global status indicato...
- Question 4: When performing live firmware upgrades on Aruba APs. Which t...
- Question 5: Which part of the WPA Key Hierarchy is used to encrypt and/o...
- Question 6: After having configured the edge switch uplink as requested ...
- Question 7: When measuring signal strength, dBm is commonly used and 0 d...
- Question 8: What is used by network devices to send error and operationa...
- Question 9: When would you bond multiple 20MHz wide 802.11 channels?...
- Question 10: Review the configuration below. (Exhibit) Why would you conf...
- Question 11: Refer to the exhibit. (Exhibit) In the given topology, a pai...
- Question 12: Which statement is true for a device with a MAC address of B...
- Question 13: A hospital uses a lot of mobile equipment for the diagnosis ...
- Question 14: Based on the "snow ip route" output on an AruDaCX 8400. what...
- Question 15: Describe the purpose of the administrative distance...
- Question 16: What are the main characteristics of the 6 GHz band?...
- Question 17: You put in a few show commands on switches EDGE1 and CORE1 t...
- Question 18: Which Protocol Data Unit (PDU) represents the data link laye...
- Question 19: You need to troubleshoot an Aruba CX 6300F switch that fails...
- Question 20: A network technician is troubleshooting one new AP at a bran...
- Question 21: What happens when the signal from an AP weakens by being abs...
- Question 22: Which type of device type and group persona is required to m...
- Question 23: How does a single Aruba CX 6300M switch configuration use L3...
- Question 24: An AP signal strength of .0000001 milliwatts equals how many...
- Question 25: When using the network check page in Central, what kind of t...
- Question 26: What does WPA3-Personal use as the source to generate a diff...
- Question 27: How does the Aruba Mobility Controller handle Layer 3 mobil...
- Question 28: Which statement is correct when comparing 5 GHz and 6 GHz ch...
- Question 29: You have physical access to an Aruba CX-Switch with unknown/...
- Question 30: Two independent ArubaOS-CX 6300 switches with Spanning Tree ...
- Question 31: What is the ideal mounting position for a typical Aruba indo...
- Question 32: List the WPA 4-Way Handshake functions in the correct order....
- Question 33: Match each AAA service with its correct definition (Matches ...
- Question 34: What is indicated by a solid amber radio status LED on an Ar...
- Question 35: You need to troubleshoot an Aruba CX 6200 4-node VSF stack s...
- Question 36: A customer has just implemented user and device certificates...
- Question 37: A network technician is verifying that a customer successful...
- Question 38: You have been asked to onboard a new Aruba 6300M in a custom...
- Question 39: Which Protocol Data Unit (PDU) represents the network layer ...
- Question 40: What can be done to dynamically set the PoE Priority on a sw...
- Question 41: A client connects to an Aruba AP in tunnel mode and is assig...
- Question 42: Describe the functionality of ARP....
- Question 43: Match the phase of message processing with the Open Systems ...
- Question 44: You are in a meeting with a customer where you are asked to ...
- Question 45: DRAG DROP Match the most cost-effective option for cabling e...
- Question 46: Which of the following statements are true regarding the co...
- Question 47: What is the recommended UXI monitoring solution in large log...
- Question 48: A hacker has altered a user's 3-Way Handshake in order to ga...
- Question 49: What will perform a hard reset of an Aruba CX switch?...
- Question 50: What is an advantage of using Layer 2 MAC authentication?...
- Question 51: What is the correct command to add a static route to a class...
