FreeCram
  1. Home
  2. EMC
  3. Specialist - Implementation Engineer, PowerProtect DD Exam
  4. EMC.DES-DD23.v2023-06-14.q26
  5. Question 24
<< Prev Question Next Question >>

Question 24/26

Which command is used to start the initial CLI configuration wizard?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (26q)
Question 1: A storage administrator finished the zoning between the Powe...
Question 2: Backup administrators have noticed slow backups on the AIX e...
Question 3: What rule must be followed during an upgrade procedure with ...
Question 4: What are some key benefits of performing backups and recover...
Question 5: What is the correct sequence of operations used by the Power...
Question 6: What is a requirement to use the PowerProtect DD HA feature?...
Question 7: A backup administrator is tasked with monitoring PowerProtec...
Question 8: What happens to the data when it is moved from the active ti...
Question 9: What can be used to monitor system utilization?...
Question 10: What are some possible network bottlenecks for a PowerProtec...
Question 11: What is the maximum capacity for a DDVE?...
Question 12: Which component of PowerProtect DD is Data Invulnerability A...
Question 13: Refer to the exhibit. (Exhibit) Match each action to its cal...
Question 14: A customer needs an upgrade on their DD6900 to use HA. Which...
Question 15: A PowerProtect DD appliance with two expansion shelves is be...
Question 16: A customer needs an upgrade on their DD6900 to use HA. Which...
Question 17: A backup administrator is tasked with verifying the compress...
Question 18: A customer needs a backup system to protect 100 TB of missio...
Question 19: Which command is used to check if NFS is enabled?...
Question 20: When the PowerProtect DD system boots up for the first time,...
Question 21: When using CIFS from a PowerProtect DD system, what should b...
Question 22: An administrator has retained snapshots for a single MTree a...
Question 23: What is the preferred method to ensure backups are protected...
Question 24: Which command is used to start the initial CLI configuration...
Question 25: What is a requirement to use the PowerProtect DD HA feature?...
Question 26: When using the DD VTL Tape Out to Cloud feature, which statu...