<< Prev Question Next Question >>

Question 7/26

A backup administrator is tasked with monitoring PowerProtect DD capacity metrics. The administrator is backing up 2 TB of data daily with a reduction rate at 5x. After data reduction, subsequent full backups compress down to 100 GB.
The initial backup requires 400 GB with a 10 percent increase in the data each day. Each incremental backup is 200 GB. After data reduction, each incremental backup is 20 GB.
What is the weekly burn rate (GB) after six daily incremental backups and one weekly backup?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (26q)
Question 1: A storage administrator finished the zoning between the Powe...
Question 2: Backup administrators have noticed slow backups on the AIX e...
Question 3: What rule must be followed during an upgrade procedure with ...
Question 4: What are some key benefits of performing backups and recover...
Question 5: What is the correct sequence of operations used by the Power...
Question 6: What is a requirement to use the PowerProtect DD HA feature?...
Question 7: A backup administrator is tasked with monitoring PowerProtec...
Question 8: What happens to the data when it is moved from the active ti...
Question 9: What can be used to monitor system utilization?...
Question 10: What are some possible network bottlenecks for a PowerProtec...
Question 11: What is the maximum capacity for a DDVE?...
Question 12: Which component of PowerProtect DD is Data Invulnerability A...
Question 13: Refer to the exhibit. (Exhibit) Match each action to its cal...
Question 14: A customer needs an upgrade on their DD6900 to use HA. Which...
Question 15: A PowerProtect DD appliance with two expansion shelves is be...
Question 16: A customer needs an upgrade on their DD6900 to use HA. Which...
Question 17: A backup administrator is tasked with verifying the compress...
Question 18: A customer needs a backup system to protect 100 TB of missio...
Question 19: Which command is used to check if NFS is enabled?...
Question 20: When the PowerProtect DD system boots up for the first time,...
Question 21: When using CIFS from a PowerProtect DD system, what should b...
Question 22: An administrator has retained snapshots for a single MTree a...
Question 23: What is the preferred method to ensure backups are protected...
Question 24: Which command is used to start the initial CLI configuration...
Question 25: What is a requirement to use the PowerProtect DD HA feature?...
Question 26: When using the DD VTL Tape Out to Cloud feature, which statu...