<< Prev Question

Question 34/34

You are deploying a new SC9000 system running Storage Center OS 7.2. At which drive size does the system require you to begin running dual redundancy on both SSDs and HDDs?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (34q)
Question 1: Which command is used to set the eth0 IP address on an SC402...
Question 2: A customer is facing poor performance on all synchronously r...
Question 3: Which best practices should be followed when using iSCSI to ...
Question 4: Why would the Key Management Server (KMS) Settings page appe...
Question 5: A company is using an SC4020 array and the storage administr...
Question 6: You are about to perform the post-setup tasks with the Stora...
Question 7: How much memory does the Dell Storage Manager (DSM) Virtual ...
Question 8: Which method can be used to identify the server HBA WWN?...
Question 9: What is the maximum memory supported on a single SC9000 cont...
Question 10: To achieve redundancy, how many connections from the same SC...
Question 11: During the initial installation of a new SC9000 Storage Cent...
Question 12: Which SC Series array feature simplifies iSCSI connectivity ...
1 commentQuestion 13: When an RS-232 serial cable is connected between a service l...
Question 14: A customer notices a volume is using an above average amount...
Question 15: A customer wants to configure a threshold alert definition. ...
Question 16: A customer wants to add an SC420 and an SC200 to a SC7020 st...
Question 17: What is the purpose of the Dell Storage Manager (DSM) Server...
Question 18: You are deploying a new SCv2020 system with four additional ...
Question 19: When configuring an SC Series array, why should a 4 MB data ...
Question 20: A customer is concerned they are over utilizing their 7K dri...
Question 21: Which 64-bit server operating systems are compatible with th...
Question 22: You are implementing a front-end connection in Legacy Port M...
Question 23: Assume a storage administrator is using the recommended stor...
Question 24: A customer is using an SC8000 array with three chained SC220...
Question 25: Based on documented best practices, which options may need t...
Question 26: Which component of the Dell Storage Manager (DSM) Suite's on...
Question 27: When installing an SC Series array, the customer indicated t...
Question 28: You have implemented two SC Series systems at a customer sit...
Question 29: How many SC420 enclosures can be supported by the SC7020 con...
Question 30: You are testing a new SC7020 storage array. You decided to d...
Question 31: Which SC Series licenses are applied at the factory?...
Question 32: When performing the initial configuration on an SC9000 throu...
Question 33: While setting up replication, you see an option for "Replica...
Question 34: You are deploying a new SC9000 system running Storage Center...