<< Prev Question Next Question >>

Question 27/34

When installing an SC Series array, the customer indicated that they want the controller configured to provide the maximum amount of storage space. You discover that the storage controller was shipped with twelve 900 GB drives and twelve 1.8 TB drives of the same type.
Which redundancy level can be selected to provide the maximum amount of storage?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (34q)
Question 1: Which command is used to set the eth0 IP address on an SC402...
Question 2: A customer is facing poor performance on all synchronously r...
Question 3: Which best practices should be followed when using iSCSI to ...
Question 4: Why would the Key Management Server (KMS) Settings page appe...
Question 5: A company is using an SC4020 array and the storage administr...
Question 6: You are about to perform the post-setup tasks with the Stora...
Question 7: How much memory does the Dell Storage Manager (DSM) Virtual ...
Question 8: Which method can be used to identify the server HBA WWN?...
Question 9: What is the maximum memory supported on a single SC9000 cont...
Question 10: To achieve redundancy, how many connections from the same SC...
Question 11: During the initial installation of a new SC9000 Storage Cent...
Question 12: Which SC Series array feature simplifies iSCSI connectivity ...
1 commentQuestion 13: When an RS-232 serial cable is connected between a service l...
Question 14: A customer notices a volume is using an above average amount...
Question 15: A customer wants to configure a threshold alert definition. ...
Question 16: A customer wants to add an SC420 and an SC200 to a SC7020 st...
Question 17: What is the purpose of the Dell Storage Manager (DSM) Server...
Question 18: You are deploying a new SCv2020 system with four additional ...
Question 19: When configuring an SC Series array, why should a 4 MB data ...
Question 20: A customer is concerned they are over utilizing their 7K dri...
Question 21: Which 64-bit server operating systems are compatible with th...
Question 22: You are implementing a front-end connection in Legacy Port M...
Question 23: Assume a storage administrator is using the recommended stor...
Question 24: A customer is using an SC8000 array with three chained SC220...
Question 25: Based on documented best practices, which options may need t...
Question 26: Which component of the Dell Storage Manager (DSM) Suite's on...
Question 27: When installing an SC Series array, the customer indicated t...
Question 28: You have implemented two SC Series systems at a customer sit...
Question 29: How many SC420 enclosures can be supported by the SC7020 con...
Question 30: You are testing a new SC7020 storage array. You decided to d...
Question 31: Which SC Series licenses are applied at the factory?...
Question 32: When performing the initial configuration on an SC9000 throu...
Question 33: While setting up replication, you see an option for "Replica...
Question 34: You are deploying a new SC9000 system running Storage Center...