A sniffer tool is a software or hardware device that can capture and analyze network traffic. In a switched Ethernet environment, where each port on a switch is connected to a single device, a sniffer tool can only see the traffic that is destined for or originated from the device it is attached to. However, an attacker can use various techniques to overcome this limitation and sniff the traffic of other devices on the same network. One of these techniques is MAC flooding, which exploits the finite memory of the switch's MAC address table.
The attacker sends a large number of frames with different source MAC addresses to the switch, which fills up the MAC address table and causes the switch to enter a fail-open mode, where it broadcasts all incoming frames to all ports, regardless of the destination MAC address. This way, the attacker can see all the traffic on the network and capture it with a sniffer tool.
The other options are less likely or less effective techniques for sniffing a switched Ethernet network.
Compromising physical security to plug into the network directly may allow the attacker to sniff the traffic of the device they are connected to, but not the traffic of other devices on the network. Using a Trojan horse with in-built sniffing capability may allow the attacker to sniff the traffic of the infected device, but not the traffic of other devices on the network, unless the Trojan horse also performs MAC flooding or other techniques to bypass the switch. Using passive sniffing, which involves listening to the network traffic without sending any packets, may provide significant stealth advantages, but it does not help the attacker to see the traffic of other devices on the network, unless the switch is already in fail-open mode or the attacker uses other techniques to induce it. References:
* Sniffing: A Beginners Guide In 4 Important Points
* How can I run a packet sniffer on a Router or Switch
* Detection of Sniffers in an Ethernet Network