<< Prev Question Next Question >>

Question 29/30

An existing server is transferred to a new location. When the iDRAC port is plugged into the network, it causes an IP conflict.
The technician is directed to change iDRAC settings via the LCD Front Panel Display.
There is NO option to make changes.
What is the most probable cause of this issue?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (30q)
Question 1: A technician deploys a server. The iDRAC was configured with...
Question 2: A technician wants to move memory from a few older system in...
Question 3: A technician is updating firmware on a Windows Server using ...
Question 4: A server needs to be configured with a six disk RAID 10 usin...
Question 5: A systemboard was replaced. After the replacement, the syste...
Question 6: A technician has a 13G system that is giving NO video to a c...
Question 7: Refer to the exhibit. (Exhibit) A technician it installing a...
Question 8: A technician needs to deploy a server into production. The t...
Question 9: A technician is tasked to perform a RAID Level Migration (RL...
Question 10: A technician creates two virtual disks and assigns a dedicat...
Question 11: Refer to the exhibit. (Exhibit) A technician tries to apply ...
Question 12: A technician sets up Automatic Updates via the iDRAC GUI to ...
Question 13: A technician needs to perform a RAID controller firmware upd...
Question 14: A technician needs to remotely update the iDRAC with Lifecyc...
Question 15: A PowerEdge server is running a hypervisor. The server must ...
Question 16: A technician needs to troubleshoot a server. The OS was oper...
Question 17: A technician in Portland, Oregon has been asked to update th...
Question 18: A technician needs to configure a server to PXE boot a serve...
Question 19: Which three steps must a technician take prior to replacing ...
Question 20: A server is configured with a RAID 5 Virtual Disk across 5 h...
Question 21: A technician has a server in production. The iDRAC SEL log i...
Question 22: A technician needs to set a server to always attempt PXE boo...
Question 23: A server has two 1100w power supplies. The system needs to e...
Question 24: A technician needs to add a server as a host to an existing ...
Question 25: How can a system administrator compare the currently install...
Question 26: A technician needs to configure a server to allow the OS to ...
Question 27: A server arrives without any RAID configuration. All firmwar...
Question 28: A technician is sent on-site to troubleshoot a server that r...
Question 29: An existing server is transferred to a new location. When th...
Question 30: A technician needs to initially configure a server from a ba...