<< Prev Question Next Question >>

Question 4/30

A server needs to be configured with a six disk RAID 10 using 3 TB drives.
What should be the available array size in this configuration?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (30q)
Question 1: A technician deploys a server. The iDRAC was configured with...
Question 2: A technician wants to move memory from a few older system in...
Question 3: A technician is updating firmware on a Windows Server using ...
Question 4: A server needs to be configured with a six disk RAID 10 usin...
Question 5: A systemboard was replaced. After the replacement, the syste...
Question 6: A technician has a 13G system that is giving NO video to a c...
Question 7: Refer to the exhibit. (Exhibit) A technician it installing a...
Question 8: A technician needs to deploy a server into production. The t...
Question 9: A technician is tasked to perform a RAID Level Migration (RL...
Question 10: A technician creates two virtual disks and assigns a dedicat...
Question 11: Refer to the exhibit. (Exhibit) A technician tries to apply ...
Question 12: A technician sets up Automatic Updates via the iDRAC GUI to ...
Question 13: A technician needs to perform a RAID controller firmware upd...
Question 14: A technician needs to remotely update the iDRAC with Lifecyc...
Question 15: A PowerEdge server is running a hypervisor. The server must ...
Question 16: A technician needs to troubleshoot a server. The OS was oper...
Question 17: A technician in Portland, Oregon has been asked to update th...
Question 18: A technician needs to configure a server to PXE boot a serve...
Question 19: Which three steps must a technician take prior to replacing ...
Question 20: A server is configured with a RAID 5 Virtual Disk across 5 h...
Question 21: A technician has a server in production. The iDRAC SEL log i...
Question 22: A technician needs to set a server to always attempt PXE boo...
Question 23: A server has two 1100w power supplies. The system needs to e...
Question 24: A technician needs to add a server as a host to an existing ...
Question 25: How can a system administrator compare the currently install...
Question 26: A technician needs to configure a server to allow the OS to ...
Question 27: A server arrives without any RAID configuration. All firmwar...
Question 28: A technician is sent on-site to troubleshoot a server that r...
Question 29: An existing server is transferred to a new location. When th...
Question 30: A technician needs to initially configure a server from a ba...