Explanation/Reference:
Explanation:
Verifying the Configuration: Example
In the following example, the show mpls l2transport vc command shows the following information (in bold) about the VCs:
VC 101 has been assigned a preferred path called Tunnel1. The default path is disabled because the

preferred path specified that the default path should not be used if the preferred path fails. VC 150 has been assigned an IP address of a loopback address on PE2. The default path can be used

if the preferred path fails.
Router# show mpls l2transport vc detail
Local interfacE. Gi0/0/0.1 up, line protocol up, Eth VLAN 222 up Destination address: 10.16.16.16, VC ID.
101, VC status: up Preferred path: Tunnel1, active
Default path: disabled
Tunnel label: 3, next hop point2point
Output interfacE. Tu1, imposed label stack {17 16}
Create timE. 00:27:31, last status change timE. 00:27:31 Signaling protocol: LDP, peer 10.16.16.16:0 up MPLS VC labels: local 25, remote 16
Group ID. local 0, remote 6
MTU: local 1500, remote 1500
Remote interface description:
Sequencing: receive disabled, send disabled
VC statistics:
packet totals: receive 10, send 10
byte totals: receive 1260, send 1300
packet drops: receive 0, send 0
ReferencE.
http://www.cisco.com/c/en/us/td/docs/ios/12_2sr/12_2sra/feature/guide/srtunsel.html#wp1057815