An engineer configures monitoring on SW1 and enters the show command to verify operation.
What does the output confirm?

Correct Answer: D
SW1 has been configured with the following commands:
SW1(config)#monitor session 1 source remote vlan 50
SW1(config)#monitor session 2 source interface fa0/14
SW1(config)#monitor session 2 destination interface fa0/15
The session 1 on SW1 was configured for Remote SPAN (RSPAN) while session 2 was configured for local SPAN. For RSPAN we need to configure the destination port to complete the configuration.
Note: In fact we cannot create such a session like session 1 because if we only configure Source RSPAN VLAN 50 (with the command monitor session 1 source remote vlan 50) then we will receive a Type: Remote Source Session (not Remote Destination Session).