300-425 Exam Dumps | A wireless engineer is using Ekahau Site Survey to validate that an existing wireless network is operating

<< Prev Question Next Question >>

Question 111/174

A wireless engineer is using Ekahau Site Survey to validate that an existing wireless network is operating as expected.
Which type of survey should be used to identify the end-to-end network performance?

A. spectrum analysis

B. passive

C. GPS assisted

D. active ping

Question List (174q): Question 1: An engineer must identify the network requirements for a com...; Question 2: An engineer is designing a high-density WLAN that must suppo...; Question 3: Which antenna type is best for covering a long corridor in a...; Question 4: A technician connects a Cisco Aironet 3700 Series access poi...; Question 5: Refer to the exhibit. During a post Mesh deployment survey, ...; Question 6: Refer to the exhibit. Which two statements about Cisco Prime...; Question 7: A customer has noticed that Client Band Select is enabled an...; Question 8: During a wireless site survey for a hospital, the client req...; Question 9: During a wireless design all APs are mapped to designated co...; Question 10: What is the recommended overlap percentage between adjacent ...; Question 11: A company has a Cisco WLC that runs AireOS 8.3 code. A WLAN ...; Question 12: An engineer added an AP to a deployment after a post-install...; Question 13: How does the environment affect the wireless network when co...; Question 14: An engineer is performing an AP-on-a-stick survey and finds ...; Question 15: A wireless engineer must assess constraints for a future WLA...; Question 16: An engineer is trying to determine the most cost-effective w...; Question 17: A network engineer is deploying Cisco 91301 APs on multiple ...; Question 18: Refer to the exhibit. An engineer is about to establish a mo...; Question 19: A customer called with a requirement that internal clients m...; Question 20: A 60,000-square foot outdoor area must be surveyed. The surv...; Question 21: A university requires coverage in large outdoor courtyards. ...; Question 22: Why is the 2.4 GHz band generally avoided in high-density en...; Question 23: Which feature must be incorporated into the network design t...; Question 24: An engineer has 35 access points plugged into a 48-port Cisc...; Question 25: An enterprise network administrator is asked to set up an ex...; Question 26: An engineer must repurpose a lab WLC appliance for use in th...; Question 27: An engineer is performing a predictive wireless design for a...; Question 28: A company has 10 access point licenses available on their ba...; Question 29: A university has three campus locations and the main data ce...; Question 30: An engineer designed a new wireless network for an enterpris...; Question 31: Which three pieces of equipment are needed to conduct a full...; Question 32: An engineer is upgrading the legacy APs to 802.11ac Wave 2 c...; Question 33: Refer to the exhibit. An engineer must design a mobility gro...; Question 34: Refer to the exhibit. A company has a foreign Cisco WLC name...; Question 35: An engineer is reducing the subnet size of the corporate WLA...; Question 36: A wireless deployment in a high-density environment is being...; Question 37: An engineer is implementing a wireless design for a service ...; Question 38: An engineer needs a budgetary number for the quantity of 911...; Question 39: A customer has two Cisco 550B WLCs that manage all the acces...; Question 40: A customer is concerned about mesh backhaul link security. W...; Question 41: Which design document contains detailed RF coverage maps, AP...; Question 42: What is the recommended overlap percentage for 2.4 GHz cover...; Question 43: An engineer is designing a wireless network in a historic bu...; Question 44: When conducting a site survey for real-time traffic over wir...; Question 45: Which three parameters are used by Cisco Prime Infrastructur...; Question 46: Campus users report a poor wireless experience. An engineer ...; Question 47: Drag and Drop Question Drag and drop the characteristics fro...; Question 48: APs in a remote office recently have been converted from loc...; Question 49: After the completion of a site survey with Ekahau Site Surve...; Question 50: An engineer must design a new wireless network for a hospita...; Question 51: Which frequency band provides the widest channel availabilit...; Question 52: A wireless engineer is hired to design a network for six bui...; Question 53: A customer purchases this Cisco equipment for a new branch o...; Question 54: A university lecture hall has a Cisco wireless high-density ...; Question 55: An engineer is planning a wireless deployment with two membe...; Question 56: Which UDP port numbers are used for exchange mobility packet...; Question 57: A hospital wireless environment was designed with these char...; Question 58: A customer is transitioning the wireless network from a lega...; Question 59: A customer currently is migrating the old wireless infrastru...; Question 60: The wireless survey report shows APs staggered throughout a ...; Question 61: An engineer must perform a pre deployment site survey. For a...; Question 62: In a high-density stadium deployment, which two design consi...; Question 63: A network engineer must configure mobility between two Cisco...; Question 64: Which two factors influence the roaming decision of a wirele...; Question 65: Which Wi-Fi 6 feature allows multiple clients to share the s...; Question 66: An engineer in a branch office that does not have a wired ba...; Question 67: An engineer has deployed a group of APs in an auditorium and...; Question 68: A wireless consultant reviewing the installation of an old w...; Question 69: A customer has determined that a cable run for a low-through...; Question 70: An engineer is designing a wireless network to support nigh ...; Question 71: A network engineer must design a new Cisco wireless solution...; Question 72: An engineer is designing a network deployment for a technolo...; Question 73: A network engineer is managing a wireless network for a larg...; Question 74: A customer has two Cisco wireless controllers named WLC-A an...; Question 75: Which statement about AP failover priority for access points...; Question 76: A network engineer is working on a design for a wireless net...; Question 77: A company wants to replace its existing PBX system with a ne...; Question 78: Which statement about the 9800 Series Wireless Controller mo...; Question 79: A customer has a Wi-Fi network that is designed to support v...; Question 80: An engineer working for an enterprise deployed multiple Cisc...; Question 81: A school deploys a Cisco wireless infrastructure in its clas...; Question 82: Which metric best indicates client experience in a WLAN desi...; Question 83: A wireless engineer is utilizing the voice readiness tool in...; Question 84: An engineer must design a wireless voice network and is audi...; Question 85: An engineer has performed a predictive site survey for high-...; Question 86: A network engineer must design a new wireless solution for a...; Question 87: What is the purpose of Cisco Band Select?...; Question 88: Refer to the exhibit. An enterprise is using wireless as the...; Question 89: You are designing a WLAN for 50 branch offices that require ...; Question 90: What is the main advantage of using directional antennas in ...; Question 91: A customer uses a Cisco Catalyst 9800 Series wireless contro...; Question 92: Refer to the exhibit. An engineer is about to establish a mo...; Question 93: A customer has multiple WGBs located around a warehouse to s...; Question 94: Which wireless survey type is performed without APs installe...; Question 95: Which two statements are correct about 5 GHz WLAN compared t...; Question 96: A wireless network consists of: - three 8500 Series controll...; Question 97: Refer to the exhibit. A customer is deploying a Greenfield 8...; Question 98: An enterprise is using two wireless controllers to support t...; Question 99: An engineer must install an outdoor wireless network for an ...; Question 100: A customer must migrate an existing small branch office depl...; Question 101: An engineer must create a multicampus architecture wireless ...; Question 102: A warehouse has metal shelving that reflects RF signals. Whi...; Question 103: A wireless engineer is performing a post verification of a w...; Question 104: A wireless engineer is designing a wireless network to suppo...; Question 105: A wireless engineer is preparing for a meeting with a custom...; Question 106: An engineer must deploy a wireless network in an open-plan e...; Question 107: An enterprise is using a Cisco AireOS controller and Wi-Fi 6...; Question 108: What is the attenuation value of a human body on a wireless ...; Question 109: An engineer configured the optimized client roaming on Cisco...; Question 110: A network engineer configures mobility between Cisco WLCs at...; Question 111: A wireless engineer is using Ekahau Site Survey to validate ...; Question 112: A university lecture hall has high client density. Which ant...; Question 113: What is the primary purpose of a validation survey?...; Question 114: Which antenna type is most appropriate for covering a long h...; Question 115: Which solution benefits from signal attenuation and provides...; Question 116: What is the recommended cell overlap for WLAN design that su...; Question 117: An engineer must perform a predictive design for a wireless ...; Question 118: During a post deployment site survey, issues are found with ...; Question 119: A university wants to deploy a high density of APs in an are...; Question 120: An engineer must assess an existing company WLAN to determin...; Question 121: A university has three campus locations and the main data ce...; Question 122: When a wireless survey is conducted at a customer facility, ...; Question 123: A wireless engineer must optimize RF performance for multipl...; Question 124: Which two criteria must be considered when conducting an out...; Question 125: Users who leave the office with a wireless headset must be a...; Question 126: When designing for high-density environments such as stadium...; Question 127: A customer has determined that aesthetics is a primary conce...; Question 128: A customer designs a Cisco wireless environment to provide c...; Question 129: An engineer is designing a wireless network for a manufactur...; Question 130: A customer is planning to replace older access points with C...; Question 131: Why is Dynamic Frequency Selection (DFS) important in WLAN d...; Question 132: A company has three Cisco WLCs that are joined as a mobility...; Question 133: A shopping mall wants to track customer movement patterns us...; Question 134: A wireless engineer is hired to design a network for a techn...; Question 135: An engineer is designing a point-to-multipoint mesh network....; Question 136: A network engineer is working on a predictive WLAN design. T...; Question 137: The CIO of a company wants to start tracking inventory in th...; Question 138: During a client roaming event, which device is responsible f...; Question 139: Which two considerations must a network engineer have when p...; Question 140: A customer has this wireless design: - two Cisco Catalyst 98...; Question 141: What is the main purpose of conducting a post-deployment sit...; Question 142: An engineer is designing the physical infrastructure for an ...; Question 143: A wireless engineer is hired to troubleshoot wireless networ...; Question 144: An engineer designs a new wireless network that uses a Cisco...; Question 145: A wireless engineer must design mobility between two buildin...; Question 146: A customer has a Cisco wireless network that supports VoWLAN...; Question 147: A customer is deploying an 802.11ac network on a floor to su...; Question 148: Which antenna type is most appropriate for outdoor Wi-Fi cov...; Question 149: Which Cisco wireless feature is designed to help balance the...; Question 150: A wireless engineer is designing a wireless network for a ca...; Question 151: An engineer is performing an active survey of a network that...; Question 152: An engineer must perform a predictive design for a wireless ...; Question 153: A customer is looking for a network design with Cisco Hyperl...; Question 154: An AP is receiving 802.11 packets on its 802.11a radio with ...; Question 155: A network engineer configures mobility between Cisco WLCs at...; Question 156: While performing an AP-on-a-stick survey with a cell boundar...; Question 157: An engineer at a global enterprise organization must ensure ...; Question 158: An enterprise has moved most services to the cloud, includin...; Question 159: A wireless engineer is designing a wireless network to suppo...; Question 160: A hospital has a Cisco Catalyst 9800 Series Wireless Control...; Question 161: Refer to the exhibit A wireless consultant is performing an ...; Question 162: An engineer must perform a Layer 2 survey for a mining facil...; Question 163: An engineer has performed a post-deployment site survey and ...; Question 164: Which authentication method is most scalable for enterprise ...; Question 165: An engineer must optimize client roaming after noticing that...; Question 166: An engineer must ensure that the new wireless LAN deployment...; Question 167: An engineer is designing a wireless network for a small airp...; Question 168: A wireless network requires location tracking for assets. Wh...; Question 169: An engineer is estimating the loss between two floors of an ...; Question 170: An engineer is designing a new wireless network. Based on th...; Question 171: A company has deployed a centralized wireless architecture a...; Question 172: During a wireless design, why should DFS (Dynamic Frequency ...; Question 173: An engineer must design AP placements for a new branch offic...; Question 174: A stadium deployment requires handling a very high number of...

Question 111/174

LEAVE A REPLY

Download PDF File