Valid 300-420 Dumps shared by ExamDiscuss.com for Helping Passing 300-420 Exam! ExamDiscuss.com now offer the newest 300-420 exam dumps, the ExamDiscuss.com 300-420 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 300-420 dumps with Test Engine here:
Access 300-420 Dumps Premium Version
(341 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 32/45
Which feature is required for graceful restart to recover from a processor failure?
Correct Answer: A
- Question List (45q)
- Question 1: An engineer must design a VPN solution for a company that ha...
- Question 2: An engineer is looking for a standards-driven YANG model to ...
- Question 3: Which two BGP features will result in successful route excha...
- Question 4: Which control-plane technology allows the same subnet to exi...
- Question 5: Which two statements describe source trees in a multicast en...
- Question 6: Which two border nodes are available in the Cisco SD-Access ...
- Question 7: Which two best practices must be followed when designing an ...
- Question 8: Drag and drop the characteristics from the left onto the cor...
- Question 9: Which method will filter routes between EIGRP neighbors with...
- Question 10: A customer's current Layer 2 infrastructure is running Spann...
- Question 11: A company is running BGP on a single router, which has two c...
- Question 12: Which two routing protocols allow for unequal cost load bala...
- Question 13: At which layer does Cisco Express Forwarding use adjacency t...
- Question 14: A customer's environment includes hosts that support IPv6-on...
- Question 15: A large chain of stores currently uses MPLS-based T1 lines t...
- Question 16: Company A recently acquired another company. Users of the ne...
- Question 17: What is one function of the vSmart controller in an SD-WAN d...
- Question 18: What is the purpose of an edge node in an SD-Access network ...
- Question 19: (Exhibit) Refer to the exhibit. An architect is designing a ...
- Question 20: An enterprise customer has these requirements: * end-to-end ...
- Question 21: When a network is designed using IS-IS protocol, which two c...
- Question 22: Which design consideration must be made when dual vEdge rout...
- Question 23: Refer to the exhibit. (Exhibit) An engineer must optimize th...
- Question 24: Drag and drop the characteristics from the left onto the tel...
- Question 25: An engineer is designing an enterprise campus network. The L...
- Question 26: An engineer must propose a solution for a campus network tha...
- Question 27: An architect is designing a multicast solution for a network...
- Question 28: (Exhibit) Refer to the exhibit. An engineer must design an a...
- Question 29: Which design consideration must be made when using IPv6 over...
- Question 30: When a first hop redundancy solution is designed, which prot...
- Question 31: A network engineer must segregate three interconnected campu...
- 1 commentQuestion 32: Which feature is required for graceful restart to recover fr...
- Question 33: A customer is discussing QoS requirements with a network con...
- Question 34: (Exhibit) Refer to the exhibit. An architect must design a s...
- Question 35: Which QoS feature responds to network congestion by dropping...
- Question 36: (Exhibit) Refer to the exhibit. An architect must design an ...
- Question 37: What is the purpose of a Cisco SD-Access underlay network?...
- Question 38: An architect must address sustained congestion on the access...
- Question 39: Drag and drop the descriptions from the left onto the Cisco ...
- Question 40: Which two options can you use to configure an EIGRP stub rou...
- Question 41: (Exhibit) Refer to the exhibit. The connection between SW2 a...
- Question 42: A network administrator is troubleshooting a DMVPN setup bet...
- Question 43: Which common issue causes intermittent DMVPN tunnel flaps?...
- Question 44: Drag and drop the characteristics from the left onto the Yan...
- Question 45: What is an advantage of designing an out-of-band network man...
Recent Comments (The most recent comments are at the top.)
In Cisco networking devices, packet forwarding is provided by Cisco Express Forwarding.
Cisco Express Forwarding maintains the FIB and uses the FIB information that was current at the time of the switchover to continue forwarding packets during a switchover.
https://www.cisco.com/en/US/technologies/tk869/tk769/technologies_white_paper0900aecd801dc5e2.html
The ability to continue packet forwarding eliminates downtime during the switchover.