<< Prev Question Next Question >>

Question 14/45

A customer's environment includes hosts that support IPv6-only. Several of these hosts must communicate with a public web server that has only IPv4 domain name resolution. Which solution should the customer use in this environment?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (45q)
Question 1: An engineer must design a VPN solution for a company that ha...
Question 2: An engineer is looking for a standards-driven YANG model to ...
Question 3: Which two BGP features will result in successful route excha...
Question 4: Which control-plane technology allows the same subnet to exi...
Question 5: Which two statements describe source trees in a multicast en...
Question 6: Which two border nodes are available in the Cisco SD-Access ...
Question 7: Which two best practices must be followed when designing an ...
Question 8: Drag and drop the characteristics from the left onto the cor...
Question 9: Which method will filter routes between EIGRP neighbors with...
Question 10: A customer's current Layer 2 infrastructure is running Spann...
Question 11: A company is running BGP on a single router, which has two c...
Question 12: Which two routing protocols allow for unequal cost load bala...
Question 13: At which layer does Cisco Express Forwarding use adjacency t...
Question 14: A customer's environment includes hosts that support IPv6-on...
Question 15: A large chain of stores currently uses MPLS-based T1 lines t...
Question 16: Company A recently acquired another company. Users of the ne...
Question 17: What is one function of the vSmart controller in an SD-WAN d...
Question 18: What is the purpose of an edge node in an SD-Access network ...
Question 19: (Exhibit) Refer to the exhibit. An architect is designing a ...
Question 20: An enterprise customer has these requirements: * end-to-end ...
Question 21: When a network is designed using IS-IS protocol, which two c...
Question 22: Which design consideration must be made when dual vEdge rout...
Question 23: Refer to the exhibit. (Exhibit) An engineer must optimize th...
Question 24: Drag and drop the characteristics from the left onto the tel...
Question 25: An engineer is designing an enterprise campus network. The L...
Question 26: An engineer must propose a solution for a campus network tha...
Question 27: An architect is designing a multicast solution for a network...
Question 28: (Exhibit) Refer to the exhibit. An engineer must design an a...
Question 29: Which design consideration must be made when using IPv6 over...
Question 30: When a first hop redundancy solution is designed, which prot...
Question 31: A network engineer must segregate three interconnected campu...
1 commentQuestion 32: Which feature is required for graceful restart to recover fr...
Question 33: A customer is discussing QoS requirements with a network con...
Question 34: (Exhibit) Refer to the exhibit. An architect must design a s...
Question 35: Which QoS feature responds to network congestion by dropping...
Question 36: (Exhibit) Refer to the exhibit. An architect must design an ...
Question 37: What is the purpose of a Cisco SD-Access underlay network?...
Question 38: An architect must address sustained congestion on the access...
Question 39: Drag and drop the descriptions from the left onto the Cisco ...
Question 40: Which two options can you use to configure an EIGRP stub rou...
Question 41: (Exhibit) Refer to the exhibit. The connection between SW2 a...
Question 42: A network administrator is troubleshooting a DMVPN setup bet...
Question 43: Which common issue causes intermittent DMVPN tunnel flaps?...
Question 44: Drag and drop the characteristics from the left onto the Yan...
Question 45: What is an advantage of designing an out-of-band network man...