Valid 300-165 Dumps shared by ExamDiscuss.com for Helping Passing 300-165 Exam! ExamDiscuss.com now offer the newest 300-165 exam dumps, the ExamDiscuss.com 300-165 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 300-165 dumps with Test Engine here:
Access 300-165 Dumps Premium Version
(326 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 12/162
SW3#rollback running-config checkpoint
user-checkpoint-1 atomic
Refer to the exhibit. What is the result?
user-checkpoint-1 atomic
Refer to the exhibit. What is the result?
Correct Answer: D
Explanation/Reference:
Explanation:
When you roll back the running configuration, you can trigger an atomic rollback. An atomic rollback implements a rollback only if no errors occur.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/ system_management/503_n1_1/cisco_n5k_system_mgmt_cg_rel_503_n1_1_chapter11.pdf
Explanation:
When you roll back the running configuration, you can trigger an atomic rollback. An atomic rollback implements a rollback only if no errors occur.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/ system_management/503_n1_1/cisco_n5k_system_mgmt_cg_rel_503_n1_1_chapter11.pdf
- Question List (162q)
- Question 1: Which three attributes encompass a local user account on a C...
- Question 2: You experience an issue on a Cisco Nexus 7700 Series switch....
- Question 3: A VPC fails a Type 2 consistency check during implementation...
- Question 4: (Exhibit) Refer to the exhibit. What is the result of runnin...
- Question 5: You have two Fibre Channel switches that are connected via E...
- Question 6: Which two events automatically generate Cisco NX-OS checkpoi...
- Question 7: Refer to the exhibit. Which result of the configuration snip...
- Question 8: Which three types of interfaces are required when implementi...
- Question 9: Which feature must be enabled for Cisco TrustSec FC Link Enc...
- Question 10: Instructions * This task does not require device configurati...
- Question 11: You are implementing a Cisco FabricPath network. Which state...
- Question 12: SW3#rollback running-config checkpoint user-checkpoint-1 ato...
- Question 13: Refer to the exhibit. (Exhibit) Which statement about the Ne...
- Question 14: Refer to the exhibit. (Exhibit) What is the result when you ...
- Question 15: Which Cisco MDS feature needs to be enabled for Cisco TrustS...
- Question 16: Which two actions are required before FIPS is configured in ...
- Question 17: Which two features are required to implement a Layer 3 VXLAN...
- Question 18: Which statement regarding the implementation of Fibre Channe...
- Question 19: Refer to the exhibit. Which statement based on these two out...
- Question 20: What is the result when the configured RTT of an FCIP link i...
- Question 21: Which three VDC resources can be constrained with a resource...
- Question 22: Refer to the exhibit. Which three statements about the Cisco...
- Question 23: Which two statements are true when performing a SPAN capture...
- Question 24: Assuming hello PDU authentication has been disabled, which c...
- Question 25: Refer to the exhibit. (Exhibit) You must configure zones on ...
- Question 26: Which technology facilitates a nondisruptive upgrade on a Ci...
- Question 27: Which policy-map action performs congestion avoidance?...
- Question 28: Which statement about the implementation of Cisco TrustSec o...
- Question 29: Scenario The following four questions concern the Nexus 7010...
- Question 30: Which parameter is configurable when setting up logging on t...
- Question 31: Which two elements must be configured correctly for Cisco Tr...
- Question 32: Which two actions are required when configuring LISP virtual...
- Question 33: Which two reasons explain why a server on VLAN 10 is unable ...
- Question 34: Refer to the exhibit. (Exhibit) Which statement about the re...
- Question 35: Which statement about implementing fabric binding is true?...
- Question 36: What are two prerequisites to running the Smart Call Home fe...
- Question 37: Which FCoE component is responsible for the encapsulation an...
- Question 38: When configuring OSPF, which two network types will avoid th...
- Question 39: Which command should you run to limit IS-IS LSP flooding on ...
- Question 40: A Cisco Catalyst 6500 Series Switch suffers a supervisor fai...
- Question 41: What is the default Fibre Channel interface type for an FCIP...
- Question 42: (Exhibit) Refer to the exhibit. Which result does the config...
- Question 43: Which statement about core-edge SAN topology is true?...
- Question 44: (Exhibit) Refer to the exhibit. What does the diameter comma...
- Question 45: When configuring PIM on a Cisco Nexus 7000 Series switch, wh...
- Question 46: How is a dynamic vNIC allocated?...
- Question 47: (Exhibit) Refer to the exhibit. Which type of domain does th...
- Question 48: Which two statements about VRRP are true? (Choose two.)...
- Question 49: You have two Cisco Nexus 7700 Series switches named SwitchA ...
- Question 50: Refer to the exhibit. How does Switch 1 route traffic to the...
- Question 51: Which protocol is used to exchange MAC address reachability ...
- Question 52: Which option is a restriction of the unified ports on the Ci...
- Question 53: (Exhibit) Refer to the exhibit. Which action do you take to ...
- Question 54: Which command allows a Cisco Nexus 7000 Series Switch to rec...
- Question 55: After enabling strong, reversible 128-bit Advanced Encryptio...
- Question 56: You are configuring QoS on a Cisco Nexus 5000 Series switch....
- Question 57: (Exhibit) Refer to the exhibit. Which corrective action is t...
- Question 58: N7K-1(config)# feature vpc N7K-1(config)# vpc domain 113 N7K...
- Question 59: What are two ways to configure the switch ID for Cisco Fabri...
- Question 60: Refer to the exhibit. Which corrective action is taken to re...
- Question 61: How does addition of bandwidth between spine and leaf switch...
- Question 62: Refer to the exhibit. (Exhibit) Which command configures a s...
- Question 63: In OTV, how are the VLANs split when a site has two edge dev...
- Question 64: Which two statements about SAN zoning on Cisco Nexus switche...
- Question 65: (Exhibit) Customer has configured fabricpath allocate-delay ...
- Question 66: Refer to the exhibit. (Exhibit) You must ensure that the vPC...
- Question 67: Instructions * This task does not require device configurati...
- Question 68: Which technology relies on STP as a failsafe mechanism?...
- Question 69: You have two roles that are associated to the same user. Whi...
- Question 70: You have a Cisco FabricPath network. You must extend the net...
- Question 71: Refer to the exhibit. (Exhibit) You configure two switches n...
- Question 72: Which option shows how to configure an ERSPAN Type III sourc...
- Question 73: You are configuring OTV between two data centers. On which i...
- Question 74: Which three options are capabilities of the Cisco Nexus 7000...
- Question 75: Which three items must be configured in the port profile cli...
- Question 76: N7k# show ip lisp locator-table DataCenter Information appli...
- Question 77: Which issue does DCB address?
- Question 78: Which action limits the maximum number of routes that are al...
- Question 79: Which option must be configured when you implement a vPC?...
- Question 80: (Exhibit) On a Cisco Nexus7000 switches what is true regardi...
- Question 81: In Any Source Multicast groups, which multicast enabled devi...
- Question 82: Which statement about the Layer 3 card on the Cisco Nexus 55...
- Question 83: Which four options are capabilities of the Cisco Nexus 5000 ...
- Question 84: (Exhibit) FabricPath switch- id is 25 and load-balance is co...
- Question 85: Which technology is required in the underlay to facilitate r...
- Question 86: Refer to the exhibit. What is the maximum IPv6 unicast route...
- Question 87: Which three options are CallHome predefined destination prof...
- Question 88: Which four statements about reserved VLANs in Cisco NX-OS ar...
- Question 89: Instructions * This task does not require device configurati...
- Question 90: Which of the following Cisco Nexus features is best managed ...
- Question 91: Which feature enables NIV?
- Question 92: (Exhibit) Refer to the exhibit. Which statement about the co...
- Question 93: Refer to the exhibit. This multilayer Cisco Nexus switch had...
- Question 94: (Exhibit) Refer to the exhibit. Which option is the result o...
- Question 95: You must configure Microsoft Network Load Balancing in unica...
- Question 96: Which item represents the process that allows FCoE multihop ...
- Question 97: (Exhibit) Refer to the exhibit. What is the result of the co...
- Question 98: Fibre Channel IDs are dynamically assigned to which objects?...
- Question 99: Which two statements about Cisco Nexus 7000 line cards are t...
- Question 100: You have a vPC configuration with two functional peers and t...
- Question 101: Which three options are capabilities of the Cisco Nexus 7000...
- Question 102: Which two items are features that are available in VN-Link i...
- Question 103: Refer to the exhibit. Which two commands are missing from th...
- Question 104: Which two advantages does FabricPath have over Spanning Tree...
- Question 105: (Exhibit) Refer to the exhibit. Which statement regarding th...
- Question 106: (Exhibit) Refer to the exhibit. Which two statements about t...
- Question 107: Which statement accurately describes an EPLD upgrade on supe...
- Question 108: Which statement about Cisco FabricPath is true?...
- Question 109: In Cisco Nexus 7000 Series Switches, which three statements ...
- Question 110: Which statement accurately describes the implementation of F...
- Question 111: When configuring PIM to support an OTV implementation, which...
- Question 112: Which feature must be configured before you can implement a ...
- Question 113: You plant to configure a SAN zone set. Which two facts shoul...
- Question 114: Which two benefits are realized when deploying Cisco Catalys...
- Question 115: Refer to the exhibit. What is the effect of the bind interfa...
- Question 116: ipv6 access-list MY_ACL permit tcp 2001:cc1e:aaaa::/64 2001:...
- Question 117: Which GLBL load-balancing method ensures that a client is al...
- Question 118: Your customer wants to use distinct security policies for di...
- Question 119: Which statement about the MPLS feature set is true?...
- Question 120: You have a switch that is operating in NPV mode. The interfa...
- Question 121: Refer to the exhibit. Which statement about STP on the vPC i...
- Question 122: Instructions * This task does not require device configurati...
- Question 123: If you are using NAT in your data center, which load balanci...
- Question 124: Which statement describes what happens if a new EPLD version...
- Question 125: (Exhibit) What is effect of the command "fabric path load-ba...
- Question 126: Which statement about vPC loop avoidance is true?...
- Question 127: Which two RFCs are supported by Cisco NX-OS devices for OSPF...
- Question 128: You plan to configure authentication for OSPF. In which conf...
- Question 129: Which SCSI terminology is used to describe source and destin...
- Question 130: switch# configure terminal switch (config) # interface ether...
- Question 131: What configuration is required when implementing FCoE?...
- Question 132: Which two options should you consider when you configure a S...
- Question 133: Which Cisco NX-OS feature allows transparent Layer 2 extensi...
- Question 134: What is the Overlay Transport Virtualization site VLAN used ...
- Question 135: Which command is used to associate EID-to-RLOC for a LISP si...
- Question 136: You plan to implement the OSPF protocol whithin the data cen...
- Question 137: Which two security features are only supported on the Cisco ...
- Question 138: Which two options are limitations of NetFlow Version 5? (Cho...
- Question 139: Switch(config)# login block-for 60 attempts 10 within 180 Sw...
- Question 140: Which option must be enabled to implement manual MACsec?...
- Question 141: What is an Overlay Transport Virtualization extended VLAN?...
- Question 142: You have a Cisco FabricPath network. You must implement vPC+...
- Question 143: Which situation must you consider when you add a remote RADI...
- Question 144: You enable the HSRP feature on a Cisco Nexus 7000 Series swi...
- Question 145: Which three parameters can be set when configuring a Cisco M...
- Question 146: Which statement about electronic programmable logic device i...
- Question 147: Which two functions are enabled when you set up vPC+ at the ...
- Question 148: Which three options of encryption are supported in PIM hello...
- Question 149: How does an FCoE end node acquire its FCoE MAC address?...
- Question 150: What is the grace period in a graceful restart situation?...
- Question 151: Which command should you ran to distribute NTP configuration...
- Question 152: Which two statements are true when implementing fabric bindi...
- Question 153: Which two PIM modes on a Cisco Nexus 7000 Series switch requ...
- Question 154: (Exhibit) Refer to the exhibit. The configuration belongs to...
- Question 155: When implementing Cisco Adapter FEX, which setting on the vi...
- Question 156: On a Cisco Nexus 7000 Series router, witch statement about H...
- Question 157: Which features must be enabled to implement manual MACsec?...
- Question 158: Which two items are services that are provided by Cisco Fabr...
- Question 159: Between which two types of ports does FIP establish Fibre Ch...
- Question 160: Within the vPC configuration of the 7K's the command peer-ga...
- Question 161: The Connectivity Management Processor monitors the active su...
- Question 162: Which task must be done before a zone set takes effect?...
