Valid 300-165 Dumps shared by ExamDiscuss.com for Helping Passing 300-165 Exam! ExamDiscuss.com now offer the newest 300-165 exam dumps, the ExamDiscuss.com 300-165 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 300-165 dumps with Test Engine here:
Access 300-165 Dumps Premium Version
(326 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 89/162
Instructions
* This task does not require device configuration.
* Click Cisco Nexus 5548 to gain console access. No console or enable passwords are required.
* To access the multiple-choice questions, click the numbered boxes on the left of the top panel.
* There are four multiple-choice questions with this task.
Scenario
Customer is deploying Cisco Nexus 5548 switch with FCoE in their new data center, as shown in the topology diagram. ClickNexus 5548 icon to run show commands and answer the questions.
What is the status of FCoE license on Cisco Nexus 5548 switch?
* This task does not require device configuration.
* Click Cisco Nexus 5548 to gain console access. No console or enable passwords are required.
* To access the multiple-choice questions, click the numbered boxes on the left of the top panel.
* There are four multiple-choice questions with this task.
Scenario
Customer is deploying Cisco Nexus 5548 switch with FCoE in their new data center, as shown in the topology diagram. ClickNexus 5548 icon to run show commands and answer the questions.
What is the status of FCoE license on Cisco Nexus 5548 switch?
Correct Answer: C
- Question List (162q)
- Question 1: Which three attributes encompass a local user account on a C...
- Question 2: You experience an issue on a Cisco Nexus 7700 Series switch....
- Question 3: A VPC fails a Type 2 consistency check during implementation...
- Question 4: (Exhibit) Refer to the exhibit. What is the result of runnin...
- Question 5: You have two Fibre Channel switches that are connected via E...
- Question 6: Which two events automatically generate Cisco NX-OS checkpoi...
- Question 7: Refer to the exhibit. Which result of the configuration snip...
- Question 8: Which three types of interfaces are required when implementi...
- Question 9: Which feature must be enabled for Cisco TrustSec FC Link Enc...
- Question 10: Instructions * This task does not require device configurati...
- Question 11: You are implementing a Cisco FabricPath network. Which state...
- Question 12: SW3#rollback running-config checkpoint user-checkpoint-1 ato...
- Question 13: Refer to the exhibit. (Exhibit) Which statement about the Ne...
- Question 14: Refer to the exhibit. (Exhibit) What is the result when you ...
- Question 15: Which Cisco MDS feature needs to be enabled for Cisco TrustS...
- Question 16: Which two actions are required before FIPS is configured in ...
- Question 17: Which two features are required to implement a Layer 3 VXLAN...
- Question 18: Which statement regarding the implementation of Fibre Channe...
- Question 19: Refer to the exhibit. Which statement based on these two out...
- Question 20: What is the result when the configured RTT of an FCIP link i...
- Question 21: Which three VDC resources can be constrained with a resource...
- Question 22: Refer to the exhibit. Which three statements about the Cisco...
- Question 23: Which two statements are true when performing a SPAN capture...
- Question 24: Assuming hello PDU authentication has been disabled, which c...
- Question 25: Refer to the exhibit. (Exhibit) You must configure zones on ...
- Question 26: Which technology facilitates a nondisruptive upgrade on a Ci...
- Question 27: Which policy-map action performs congestion avoidance?...
- Question 28: Which statement about the implementation of Cisco TrustSec o...
- Question 29: Scenario The following four questions concern the Nexus 7010...
- Question 30: Which parameter is configurable when setting up logging on t...
- Question 31: Which two elements must be configured correctly for Cisco Tr...
- Question 32: Which two actions are required when configuring LISP virtual...
- Question 33: Which two reasons explain why a server on VLAN 10 is unable ...
- Question 34: Refer to the exhibit. (Exhibit) Which statement about the re...
- Question 35: Which statement about implementing fabric binding is true?...
- Question 36: What are two prerequisites to running the Smart Call Home fe...
- Question 37: Which FCoE component is responsible for the encapsulation an...
- Question 38: When configuring OSPF, which two network types will avoid th...
- Question 39: Which command should you run to limit IS-IS LSP flooding on ...
- Question 40: A Cisco Catalyst 6500 Series Switch suffers a supervisor fai...
- Question 41: What is the default Fibre Channel interface type for an FCIP...
- Question 42: (Exhibit) Refer to the exhibit. Which result does the config...
- Question 43: Which statement about core-edge SAN topology is true?...
- Question 44: (Exhibit) Refer to the exhibit. What does the diameter comma...
- Question 45: When configuring PIM on a Cisco Nexus 7000 Series switch, wh...
- Question 46: How is a dynamic vNIC allocated?...
- Question 47: (Exhibit) Refer to the exhibit. Which type of domain does th...
- Question 48: Which two statements about VRRP are true? (Choose two.)...
- Question 49: You have two Cisco Nexus 7700 Series switches named SwitchA ...
- Question 50: Refer to the exhibit. How does Switch 1 route traffic to the...
- Question 51: Which protocol is used to exchange MAC address reachability ...
- Question 52: Which option is a restriction of the unified ports on the Ci...
- Question 53: (Exhibit) Refer to the exhibit. Which action do you take to ...
- Question 54: Which command allows a Cisco Nexus 7000 Series Switch to rec...
- Question 55: After enabling strong, reversible 128-bit Advanced Encryptio...
- Question 56: You are configuring QoS on a Cisco Nexus 5000 Series switch....
- Question 57: (Exhibit) Refer to the exhibit. Which corrective action is t...
- Question 58: N7K-1(config)# feature vpc N7K-1(config)# vpc domain 113 N7K...
- Question 59: What are two ways to configure the switch ID for Cisco Fabri...
- Question 60: Refer to the exhibit. Which corrective action is taken to re...
- Question 61: How does addition of bandwidth between spine and leaf switch...
- Question 62: Refer to the exhibit. (Exhibit) Which command configures a s...
- Question 63: In OTV, how are the VLANs split when a site has two edge dev...
- Question 64: Which two statements about SAN zoning on Cisco Nexus switche...
- Question 65: (Exhibit) Customer has configured fabricpath allocate-delay ...
- Question 66: Refer to the exhibit. (Exhibit) You must ensure that the vPC...
- Question 67: Instructions * This task does not require device configurati...
- Question 68: Which technology relies on STP as a failsafe mechanism?...
- Question 69: You have two roles that are associated to the same user. Whi...
- Question 70: You have a Cisco FabricPath network. You must extend the net...
- Question 71: Refer to the exhibit. (Exhibit) You configure two switches n...
- Question 72: Which option shows how to configure an ERSPAN Type III sourc...
- Question 73: You are configuring OTV between two data centers. On which i...
- Question 74: Which three options are capabilities of the Cisco Nexus 7000...
- Question 75: Which three items must be configured in the port profile cli...
- Question 76: N7k# show ip lisp locator-table DataCenter Information appli...
- Question 77: Which issue does DCB address?
- Question 78: Which action limits the maximum number of routes that are al...
- Question 79: Which option must be configured when you implement a vPC?...
- Question 80: (Exhibit) On a Cisco Nexus7000 switches what is true regardi...
- Question 81: In Any Source Multicast groups, which multicast enabled devi...
- Question 82: Which statement about the Layer 3 card on the Cisco Nexus 55...
- Question 83: Which four options are capabilities of the Cisco Nexus 5000 ...
- Question 84: (Exhibit) FabricPath switch- id is 25 and load-balance is co...
- Question 85: Which technology is required in the underlay to facilitate r...
- Question 86: Refer to the exhibit. What is the maximum IPv6 unicast route...
- Question 87: Which three options are CallHome predefined destination prof...
- Question 88: Which four statements about reserved VLANs in Cisco NX-OS ar...
- Question 89: Instructions * This task does not require device configurati...
- Question 90: Which of the following Cisco Nexus features is best managed ...
- Question 91: Which feature enables NIV?
- Question 92: (Exhibit) Refer to the exhibit. Which statement about the co...
- Question 93: Refer to the exhibit. This multilayer Cisco Nexus switch had...
- Question 94: (Exhibit) Refer to the exhibit. Which option is the result o...
- Question 95: You must configure Microsoft Network Load Balancing in unica...
- Question 96: Which item represents the process that allows FCoE multihop ...
- Question 97: (Exhibit) Refer to the exhibit. What is the result of the co...
- Question 98: Fibre Channel IDs are dynamically assigned to which objects?...
- Question 99: Which two statements about Cisco Nexus 7000 line cards are t...
- Question 100: You have a vPC configuration with two functional peers and t...
- Question 101: Which three options are capabilities of the Cisco Nexus 7000...
- Question 102: Which two items are features that are available in VN-Link i...
- Question 103: Refer to the exhibit. Which two commands are missing from th...
- Question 104: Which two advantages does FabricPath have over Spanning Tree...
- Question 105: (Exhibit) Refer to the exhibit. Which statement regarding th...
- Question 106: (Exhibit) Refer to the exhibit. Which two statements about t...
- Question 107: Which statement accurately describes an EPLD upgrade on supe...
- Question 108: Which statement about Cisco FabricPath is true?...
- Question 109: In Cisco Nexus 7000 Series Switches, which three statements ...
- Question 110: Which statement accurately describes the implementation of F...
- Question 111: When configuring PIM to support an OTV implementation, which...
- Question 112: Which feature must be configured before you can implement a ...
- Question 113: You plant to configure a SAN zone set. Which two facts shoul...
- Question 114: Which two benefits are realized when deploying Cisco Catalys...
- Question 115: Refer to the exhibit. What is the effect of the bind interfa...
- Question 116: ipv6 access-list MY_ACL permit tcp 2001:cc1e:aaaa::/64 2001:...
- Question 117: Which GLBL load-balancing method ensures that a client is al...
- Question 118: Your customer wants to use distinct security policies for di...
- Question 119: Which statement about the MPLS feature set is true?...
- Question 120: You have a switch that is operating in NPV mode. The interfa...
- Question 121: Refer to the exhibit. Which statement about STP on the vPC i...
- Question 122: Instructions * This task does not require device configurati...
- Question 123: If you are using NAT in your data center, which load balanci...
- Question 124: Which statement describes what happens if a new EPLD version...
- Question 125: (Exhibit) What is effect of the command "fabric path load-ba...
- Question 126: Which statement about vPC loop avoidance is true?...
- Question 127: Which two RFCs are supported by Cisco NX-OS devices for OSPF...
- Question 128: You plan to configure authentication for OSPF. In which conf...
- Question 129: Which SCSI terminology is used to describe source and destin...
- Question 130: switch# configure terminal switch (config) # interface ether...
- Question 131: What configuration is required when implementing FCoE?...
- Question 132: Which two options should you consider when you configure a S...
- Question 133: Which Cisco NX-OS feature allows transparent Layer 2 extensi...
- Question 134: What is the Overlay Transport Virtualization site VLAN used ...
- Question 135: Which command is used to associate EID-to-RLOC for a LISP si...
- Question 136: You plan to implement the OSPF protocol whithin the data cen...
- Question 137: Which two security features are only supported on the Cisco ...
- Question 138: Which two options are limitations of NetFlow Version 5? (Cho...
- Question 139: Switch(config)# login block-for 60 attempts 10 within 180 Sw...
- Question 140: Which option must be enabled to implement manual MACsec?...
- Question 141: What is an Overlay Transport Virtualization extended VLAN?...
- Question 142: You have a Cisco FabricPath network. You must implement vPC+...
- Question 143: Which situation must you consider when you add a remote RADI...
- Question 144: You enable the HSRP feature on a Cisco Nexus 7000 Series swi...
- Question 145: Which three parameters can be set when configuring a Cisco M...
- Question 146: Which statement about electronic programmable logic device i...
- Question 147: Which two functions are enabled when you set up vPC+ at the ...
- Question 148: Which three options of encryption are supported in PIM hello...
- Question 149: How does an FCoE end node acquire its FCoE MAC address?...
- Question 150: What is the grace period in a graceful restart situation?...
- Question 151: Which command should you ran to distribute NTP configuration...
- Question 152: Which two statements are true when implementing fabric bindi...
- Question 153: Which two PIM modes on a Cisco Nexus 7000 Series switch requ...
- Question 154: (Exhibit) Refer to the exhibit. The configuration belongs to...
- Question 155: When implementing Cisco Adapter FEX, which setting on the vi...
- Question 156: On a Cisco Nexus 7000 Series router, witch statement about H...
- Question 157: Which features must be enabled to implement manual MACsec?...
- Question 158: Which two items are services that are provided by Cisco Fabr...
- Question 159: Between which two types of ports does FIP establish Fibre Ch...
- Question 160: Within the vPC configuration of the 7K's the command peer-ga...
- Question 161: The Connectivity Management Processor monitors the active su...
- Question 162: Which task must be done before a zone set takes effect?...
