Valid 300-165 Dumps shared by ExamDiscuss.com for Helping Passing 300-165 Exam! ExamDiscuss.com now offer the newest 300-165 exam dumps, the ExamDiscuss.com 300-165 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 300-165 dumps with Test Engine here:

Access 300-165 Dumps Premium Version
(326 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 61/126

Which option must be enabled to implement manual MACsec?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (126q)
Question 1: Nexus_7k (config)# feature port-security Nexus_7k (config-if...
Question 2: Which statement about the implementation of Cisco TrustSec o...
Question 3: You are connecting a Cisco Nexus 2300 Series FEX to a Cisco ...
Question 4: Switch(config)# login block-for 60 attempts 10 within 180 Sw...
Question 5: When configuring HSPR on IPv6-enabled interfaces, which two ...
Question 6: Which feature enables NIV?
Question 7: Which two security features are only supported on the Cisco ...
Question 8: Which statement about the Layer 3 card on the Cisco Nexus 55...
Question 9: Instructions * This task does not require device configurati...
Question 10: You are configuring OTV between two data centers. On which i...
Question 11: Which of the following Cisco Nexus features is best managed ...
Question 12: Which two reasons explain why a server on VLAN 10 is unable ...
Question 13: By default it will take 10 seconds for authentication to fai...
Question 14: Which protocol is used to exchange MAC address reachability ...
Question 15: Which statement about scalability in Cisco OTV is true?...
Question 16: Which Cisco Nexus feature is best managed with DCNM-SAN?...
Question 17: What are two ways to configure the switch ID for Cisco Fabri...
Question 18: mac access-list mac-01 permit 11c0.0000.0000 0000.ffff.ffff ...
Question 19: Refer to the exhibit. Which statement based on these two out...
Question 20: Which statement about Cisco FabricPath is true?...
Question 21: Which two statements are true when performing a SPAN capture...
Question 22: Which two items are services that are provided by Cisco Fabr...
Question 23: You plan to configure authentication for OSPF. In which conf...
Question 24: Refer to the command below. When configuring an SVS connecti...
Question 25: What is the Overlay Transport Virtualization site VLAN used ...
Question 26: In the dynamic vNIC creation wizard, why are choices for Pro...
Question 27: Which information does the show fcns database command displa...
Question 28: You experience an issue on a Cisco Nexus 7700 Series switch....
Question 29: ipv6 access-list MY_ACL permit tcp 2001:cc1e:aaaa::/64 2001:...
Question 30: You have a Cisco Nexus 7700 Series switch on which the grace...
Question 31: What is an Overlay Transport Virtualization extended VLAN?...
Question 32: In policy-based routing, which action is taken for packets t...
Question 33: switch# configure terminal switch (config) # interface ether...
Question 34: You have two Fibre Channel switches that are connected via E...
Question 35: Which two statements about SAN zoning on Cisco Nexus switche...
Question 36: Which command should you run to enforce SNMP message encrypt...
Question 37: Which two options accurately describe the implementation of ...
Question 38: Which technology relies on STP as a failsafe mechanism?...
Question 39: Instructions * This task does not require device configurati...
Question 40: Which statement about RBAC user roles on a Cisco Nexus switc...
Question 41: switch (config)# spanning-tree port type edge bpdufilter def...
Question 42: What can be identified by running the switch# show install a...
Question 43: Which statement about SNMP support on Cisco Nexus switches i...
Question 44: (Exhibit) Refer to the exhibit. You have a suboptimal outbou...
Question 45: What is the default Fibre Channel interface type for an FCIP...
Question 46: After enabling strong, reversible 128-bit Advanced Encryptio...
Question 47: When configuring PIM to support an OTV implementation, which...
Question 48: Which command should you run to limit IS-IS LSP flooding on ...
Question 49: When connecting Cisco Nexus 5000 Series Switches to the VMwa...
Question 50: Which statement accurately describes MP-BGP EVPN?...
Question 51: Which statement about implementation of Cisco TrustSec on Ci...
Question 52: Which two items are required components of VN-Link in softwa...
Question 53: DRAG DROP Drag and drop the types of spanning tree ports fro...
Question 54: Which security feature is only supported on the Cisco Nexus ...
Question 55: What are two prerequisites to running the Smart Call Home fe...
Question 56: Which three VDC resources can be constrained with a resource...
Question 57: What is the purpose of the resequence command for ACLs?...
Question 58: Which two protocols can be used to back up the configuration...
Question 59: You configure STP on a switch that is attached to a Cisco Fa...
Question 60: Which option must be configured when you implement a vPC?...
Question 61: Which option must be enabled to implement manual MACsec?...
Question 62: Without having access to Fabric Path show commands, how can ...
Question 63: Which features must be enabled to implement manual MACsec?...
Question 64: Which two types of traffic are carried over a vPC peer link ...
Question 65: Which statement about electronic programmable logic device i...
Question 66: Which three selections represent implementations of Cisco VN...
Question 67: Which two statements about SAN zoning on Cisco Nexus switche...
Question 68: On a Cisco Nexus 7000 Series router, witch statement about H...
Question 69: You have a Cisco MDS 9000 Series Switch that uses port chann...
Question 70: You plan to implement the OSPF protocol whithin the data cen...
Question 71: Which two issues explain why a packet is not being routed as...
Question 72: Which command configures the aging for VLAN 100 to 500 minut...
Question 73: Which implicit rules are applied to all IPv6 ACLs?...
Question 74: You create a checkpoint on a Cisco Nexus 7700 Series switch....
Question 75: Which policy-map action performs congestion avoidance?...
Question 76: You have a Cisco FabricPath network. You must implement vPC+...
Question 77: Which two statements about Cisco Nexus 7000 line cards are t...
Question 78: N7K-1(config)# feature vpc N7K-1(config)# vpc domain 113 N7K...
Question 79: Which statement is true if password-strength checking is ena...
Question 80: Which two options should you consider when you configure a S...
Question 81: Which two options can be used for link aggregation when you ...
Question 82: Which technology is required in the underlay to facilitate r...
Question 83: You have a Cisco FabricPath network. You must extend the net...
Question 84: Which two Cisco Nexus platforms support Adapter FEX? (Choose...
Question 85: What are two requirements for configuring SAN device aliases...
Question 86: You have two Cisco Nexus 7700 Series switches named SwitchA ...
Question 87: What is the grace period in a graceful restart situation?...
Question 88: When you configure LISP, which two components must be config...
Question 89: When configuring OSPF, which two network types will avoid th...
Question 90: Which two features are required to implement a Layer 3 VXLAN...
Question 91: Instructions * This task does not require device configurati...
Question 92: (Exhibit) Refer to the exhibit. Which corrective action is t...
Question 93: Which statement accurately describes the implementation of F...
Question 94: SW3#rollback running-config checkpoint user-checkpoint-1 ato...
Question 95: (Exhibit) Refer to the exhibit. What does the diameter comma...
Question 96: Which statement about RADIUS configuration distribution usin...
Question 97: When a local RBAC user account has the same name as a remote...
Question 98: Which GLBP load-balancing algorithm ensures that a client is...
Question 99: Which two statements are true when implementing fabric bindi...
Question 100: You have a Cisco Nexus 5000 Series switch. Port security is ...
Question 101: DRAG DROP Drag and drop the LISP devices from the left onto ...
Question 102: What is the result when the configured RTT of an FCIP link i...
Question 103: Which statement about enhanced zoning on Cisco Multilayer Di...
Question 104: N7k-1# show running-config fabricpath ... fabricpath switch-...
Question 105: Which action limits the maximum number of routes that are al...
Question 106: You are configuring QoS on a Cisco Nexus 5000 Series switch....
Question 107: Which option is a restriction of the unified ports on the Ci...
Question 108: How is a dynamic vNIC allocated?...
Question 109: Which command should you ran to distribute NTP configuration...
Question 110: N7k(config)# logging logfile LOGFILES Refer to the exhibit. ...
Question 111: Which LISP component provides connectivity between LISP and ...
Question 112: Which statement explains why a Cisco UCS 6200 Fabric Interco...
Question 113: Instructions * This task does not require device configurati...
Question 114: N7k# show ip lisp locator-table DataCenter Information appli...
Question 115: Which three items must be configured in the port profile cli...
Question 116: Which Cisco MDS feature needs to be enabled for Cisco TrustS...
Question 117: Fibre Channel IDs are dynamically assigned to which objects?...
Question 118: Which command sequence correctly enables Adapter FEX on Nexu...
Question 119: Which GLBL load-balancing method ensures that a client is al...
Question 120: Which two Nexus family linecards allow the configuration of ...
Question 121: The Connectivity Management Processor monitors the active su...
Question 122: Which command allows a Cisco Nexus 7000 Series Switch to rec...
Question 123: A Cisco Nexus 2000 Series Fabric Extender is connected to tw...
Question 124: Which three Cisco UCS C-Series CNAs support Adapter FEX? (Ch...
Question 125: Which interface is used for vPC keepalives on both 7000's?...
Question 126: switch(config)# snmp-server user all enforcePriv Refer to th...