<< Prev Question Next Question >>

Question 39/126

Instructions
* This task does not require device configuration.
* Click Cisco Nexus 5548 to gain console access. No console or enable passwords are required.
* To access the multiple-choice questions, click the numbered boxes on the left of the top panel.
* There are four multiple-choice questions with this task.
Scenario
Customer is deploying Cisco Nexus 5548 switch with FCoE in their new data center, as shown in the topology diagram. ClickNexus 5548 icon to run show commands and answer the questions.


What is the status of FCoE license on Cisco Nexus 5548 switch?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (126q)
Question 1: Nexus_7k (config)# feature port-security Nexus_7k (config-if...
Question 2: Which statement about the implementation of Cisco TrustSec o...
Question 3: You are connecting a Cisco Nexus 2300 Series FEX to a Cisco ...
Question 4: Switch(config)# login block-for 60 attempts 10 within 180 Sw...
Question 5: When configuring HSPR on IPv6-enabled interfaces, which two ...
Question 6: Which feature enables NIV?
Question 7: Which two security features are only supported on the Cisco ...
Question 8: Which statement about the Layer 3 card on the Cisco Nexus 55...
Question 9: Instructions * This task does not require device configurati...
Question 10: You are configuring OTV between two data centers. On which i...
Question 11: Which of the following Cisco Nexus features is best managed ...
Question 12: Which two reasons explain why a server on VLAN 10 is unable ...
Question 13: By default it will take 10 seconds for authentication to fai...
Question 14: Which protocol is used to exchange MAC address reachability ...
Question 15: Which statement about scalability in Cisco OTV is true?...
Question 16: Which Cisco Nexus feature is best managed with DCNM-SAN?...
Question 17: What are two ways to configure the switch ID for Cisco Fabri...
Question 18: mac access-list mac-01 permit 11c0.0000.0000 0000.ffff.ffff ...
Question 19: Refer to the exhibit. Which statement based on these two out...
Question 20: Which statement about Cisco FabricPath is true?...
Question 21: Which two statements are true when performing a SPAN capture...
Question 22: Which two items are services that are provided by Cisco Fabr...
Question 23: You plan to configure authentication for OSPF. In which conf...
Question 24: Refer to the command below. When configuring an SVS connecti...
Question 25: What is the Overlay Transport Virtualization site VLAN used ...
Question 26: In the dynamic vNIC creation wizard, why are choices for Pro...
Question 27: Which information does the show fcns database command displa...
Question 28: You experience an issue on a Cisco Nexus 7700 Series switch....
Question 29: ipv6 access-list MY_ACL permit tcp 2001:cc1e:aaaa::/64 2001:...
Question 30: You have a Cisco Nexus 7700 Series switch on which the grace...
Question 31: What is an Overlay Transport Virtualization extended VLAN?...
Question 32: In policy-based routing, which action is taken for packets t...
Question 33: switch# configure terminal switch (config) # interface ether...
Question 34: You have two Fibre Channel switches that are connected via E...
Question 35: Which two statements about SAN zoning on Cisco Nexus switche...
Question 36: Which command should you run to enforce SNMP message encrypt...
Question 37: Which two options accurately describe the implementation of ...
Question 38: Which technology relies on STP as a failsafe mechanism?...
Question 39: Instructions * This task does not require device configurati...
Question 40: Which statement about RBAC user roles on a Cisco Nexus switc...
Question 41: switch (config)# spanning-tree port type edge bpdufilter def...
Question 42: What can be identified by running the switch# show install a...
Question 43: Which statement about SNMP support on Cisco Nexus switches i...
Question 44: (Exhibit) Refer to the exhibit. You have a suboptimal outbou...
Question 45: What is the default Fibre Channel interface type for an FCIP...
Question 46: After enabling strong, reversible 128-bit Advanced Encryptio...
Question 47: When configuring PIM to support an OTV implementation, which...
Question 48: Which command should you run to limit IS-IS LSP flooding on ...
Question 49: When connecting Cisco Nexus 5000 Series Switches to the VMwa...
Question 50: Which statement accurately describes MP-BGP EVPN?...
Question 51: Which statement about implementation of Cisco TrustSec on Ci...
Question 52: Which two items are required components of VN-Link in softwa...
Question 53: DRAG DROP Drag and drop the types of spanning tree ports fro...
Question 54: Which security feature is only supported on the Cisco Nexus ...
Question 55: What are two prerequisites to running the Smart Call Home fe...
Question 56: Which three VDC resources can be constrained with a resource...
Question 57: What is the purpose of the resequence command for ACLs?...
Question 58: Which two protocols can be used to back up the configuration...
Question 59: You configure STP on a switch that is attached to a Cisco Fa...
Question 60: Which option must be configured when you implement a vPC?...
Question 61: Which option must be enabled to implement manual MACsec?...
Question 62: Without having access to Fabric Path show commands, how can ...
Question 63: Which features must be enabled to implement manual MACsec?...
Question 64: Which two types of traffic are carried over a vPC peer link ...
Question 65: Which statement about electronic programmable logic device i...
Question 66: Which three selections represent implementations of Cisco VN...
Question 67: Which two statements about SAN zoning on Cisco Nexus switche...
Question 68: On a Cisco Nexus 7000 Series router, witch statement about H...
Question 69: You have a Cisco MDS 9000 Series Switch that uses port chann...
Question 70: You plan to implement the OSPF protocol whithin the data cen...
Question 71: Which two issues explain why a packet is not being routed as...
Question 72: Which command configures the aging for VLAN 100 to 500 minut...
Question 73: Which implicit rules are applied to all IPv6 ACLs?...
Question 74: You create a checkpoint on a Cisco Nexus 7700 Series switch....
Question 75: Which policy-map action performs congestion avoidance?...
Question 76: You have a Cisco FabricPath network. You must implement vPC+...
Question 77: Which two statements about Cisco Nexus 7000 line cards are t...
Question 78: N7K-1(config)# feature vpc N7K-1(config)# vpc domain 113 N7K...
Question 79: Which statement is true if password-strength checking is ena...
Question 80: Which two options should you consider when you configure a S...
Question 81: Which two options can be used for link aggregation when you ...
Question 82: Which technology is required in the underlay to facilitate r...
Question 83: You have a Cisco FabricPath network. You must extend the net...
Question 84: Which two Cisco Nexus platforms support Adapter FEX? (Choose...
Question 85: What are two requirements for configuring SAN device aliases...
Question 86: You have two Cisco Nexus 7700 Series switches named SwitchA ...
Question 87: What is the grace period in a graceful restart situation?...
Question 88: When you configure LISP, which two components must be config...
Question 89: When configuring OSPF, which two network types will avoid th...
Question 90: Which two features are required to implement a Layer 3 VXLAN...
Question 91: Instructions * This task does not require device configurati...
Question 92: (Exhibit) Refer to the exhibit. Which corrective action is t...
Question 93: Which statement accurately describes the implementation of F...
Question 94: SW3#rollback running-config checkpoint user-checkpoint-1 ato...
Question 95: (Exhibit) Refer to the exhibit. What does the diameter comma...
Question 96: Which statement about RADIUS configuration distribution usin...
Question 97: When a local RBAC user account has the same name as a remote...
Question 98: Which GLBP load-balancing algorithm ensures that a client is...
Question 99: Which two statements are true when implementing fabric bindi...
Question 100: You have a Cisco Nexus 5000 Series switch. Port security is ...
Question 101: DRAG DROP Drag and drop the LISP devices from the left onto ...
Question 102: What is the result when the configured RTT of an FCIP link i...
Question 103: Which statement about enhanced zoning on Cisco Multilayer Di...
Question 104: N7k-1# show running-config fabricpath ... fabricpath switch-...
Question 105: Which action limits the maximum number of routes that are al...
Question 106: You are configuring QoS on a Cisco Nexus 5000 Series switch....
Question 107: Which option is a restriction of the unified ports on the Ci...
Question 108: How is a dynamic vNIC allocated?...
Question 109: Which command should you ran to distribute NTP configuration...
Question 110: N7k(config)# logging logfile LOGFILES Refer to the exhibit. ...
Question 111: Which LISP component provides connectivity between LISP and ...
Question 112: Which statement explains why a Cisco UCS 6200 Fabric Interco...
Question 113: Instructions * This task does not require device configurati...
Question 114: N7k# show ip lisp locator-table DataCenter Information appli...
Question 115: Which three items must be configured in the port profile cli...
Question 116: Which Cisco MDS feature needs to be enabled for Cisco TrustS...
Question 117: Fibre Channel IDs are dynamically assigned to which objects?...
Question 118: Which command sequence correctly enables Adapter FEX on Nexu...
Question 119: Which GLBL load-balancing method ensures that a client is al...
Question 120: Which two Nexus family linecards allow the configuration of ...
Question 121: The Connectivity Management Processor monitors the active su...
Question 122: Which command allows a Cisco Nexus 7000 Series Switch to rec...
Question 123: A Cisco Nexus 2000 Series Fabric Extender is connected to tw...
Question 124: Which three Cisco UCS C-Series CNAs support Adapter FEX? (Ch...
Question 125: Which interface is used for vPC keepalives on both 7000's?...
Question 126: switch(config)# snmp-server user all enforcePriv Refer to th...