<< Prev Question Next Question >>

Question 63/80

Which two Cisco data center devices can participate in Cisco FabricPath? (Choose two.)

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (80q)
Question 1: What two addresses are defined under RFC 1918? (Choose two.)...
Question 2: Which type of WAN connection do you use for a low-latency ap...
Question 3: What will extend a trust boundary (there is switch interface...
Question 4: Refer to the exhibit. (Exhibit) Which result is true if a cl...
Question 5: Which is part of the Prepare phase of PPDIOO?...
Question 6: which QoS level should VOIPset be configured on WLC ?...
Question 7: For a VLAN that requires 70 hosts, which subnet is the most ...
Question 8: A network engineer is using the traditional switched hierarc...
Question 9: Which tool captures network traffic, decodes the protocols i...
Question 10: Which two devices support context virtualization? (Choose tw...
Question 11: An engineer is trying to collect information about the custo...
Question 12: Multicast has been enabled and configured in the Enterprise,...
Question 13: Which design enables easy and flexible scaling in the Cisco ...
Question 14: Cisco Identity-Based Networking Services relies heavily on t...
Question 15: As you assign QoS priorities, which Cisco tool can you use t...
Question 16: What tool would you use to decode protocols?...
Question 17: What is a benefit of IPv6 over IPv4 addresses?...
Question 18: Which advantage of using Spanning Tree Protocol is true?...
Question 19: Which option is an example of a fixed two-level hierarchical...
Question 20: Which three functions of a wireless LAN controller in an ent...
Question 21: An organization must decide which routing protocol to use th...
Question 22: Which feature enables the VRRP-enabled router to regain the ...
Question 23: In which phase of the Cisco Design Lifecycle would you ident...
Question 24: Which two states are RSTP port states? (Choose two.)...
Question 25: Your company uses OSPF for internal routing. The company wil...
Question 26: Which type of router connects to two different OSPF areas?...
Question 27: A network engineer is tasked with summarizing the routes to ...
Question 28: You want to gather as much detail as possible during a netwo...
Question 29: Which option is a benefit of the modular approach to network...
Question 30: What information should be utilized to identify network appl...
Question 31: Refer to the exhibit. (Exhibit) You are designing routing be...
Question 32: A network design engineer is seeking a dynamic routing proto...
Question 33: While designing a remote access VPN, a customer has requeste...
Question 34: Which two mechanisms are used by distance vector protocols t...
Question 35: Which layer of the OSI model when included in the access lay...
Question 36: A customer is questioning the additional infrastructure that...
Question 37: What describes the link performance?...
Question 38: Which value must you configure on a Microsoft DHCP server so...
Question 39: Which statement about using VSS on a pair of switches is tru...
Question 40: Refer to exhibit. (Exhibit) Based on the following output fr...
Question 41: Which three sources does a network designer use to collect i...
Question 42: An organization is redesigning a 3-tier hierarchical network...
Question 43: Which two major campus design models does the cisco unified ...
Question 44: Which statement describes an advantage of the Layer 2 access...
Question 45: Drag and drop the phases of the lifecycle of a standard netw...
Question 46: What should be considered when scaling EIGRP (Choose three)?...
Question 47: Traditionally, the DMZ exist between which two locations? (C...
Question 48: Which VPN tunneling technology supports IP multicast?...
Question 49: Which benefit of hiding network information by using aggrega...
Question 50: Which statement correctly describes queuing in environments ...
Question 51: Which design feature must be considered when the WAN bandwid...
Question 52: Which statement is true concerning the data center access la...
Question 53: Which routing protocol feature do you use when scaling a net...
Question 54: Refer to the exhibit. (Exhibit) Where should routes in the r...
Question 55: An engineer is designing a disaster recovery solution to avo...
Question 56: An engineer wants to ensure that the Spanning Tree topology ...
Question 57: When designing changes to an existing network which tow opti...
Question 58: Which two options are benefits of utilizing the Cisco Lifecy...
Question 59: What is the VLAN subnet that can handle 60 hosts?...
Question 60: Which two features are benefits of a modular network design"...
Question 61: According to fundamental design principles, which location i...
Question 62: You want to gather as much detail as possible during a netwo...
Question 63: Which two Cisco data center devices can participate in Cisco...
Question 64: Which virtualization solution provides redundancy using a pa...
Question 65: How many switches can be combined into a single network elem...
Question 66: What is the benefit of VLSM?
Question 67: Which option best describes the high-level design document?...
Question 68: What are two advantages of a modular design (Choose two)?...
Question 69: Which Cisco security mechanism has the attributes listed bel...
Question 70: Which feature must be configured on a switch port that conne...
Question 71: Which IPv6 feature enables routing to distribute connection ...
Question 72: What is the benefit of using VLSM?...
Question 73: Which protocol is used for voice bearer traffic?...
Question 74: Which scenario is the best example of a single-homed connect...
Question 75: A network engineer is designing a solution that will monitor...
Question 76: An engineer is designing a hierarchical LAN design for an en...
Question 77: Which statement about using STP in a redundant - link scenar...
Question 78: What Routing Protocol is clasfull...
Question 79: Which RFC defines the IPv6 standard?...
Question 80: What are two important aspects to consider when looking at b...