Valid 200-310 Dumps shared by ExamDiscuss.com for Helping Passing 200-310 Exam! ExamDiscuss.com now offer the newest 200-310 exam dumps, the ExamDiscuss.com 200-310 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 200-310 dumps with Test Engine here:

Access 200-310 Dumps Premium Version
(392 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 8/80

A network engineer is using the traditional switched hierarchical design. The client has asked to increase uplink utilization from the access layer to the distribution. How can the engineer attain this new requirement without adding new physical connections?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (80q)
Question 1: What two addresses are defined under RFC 1918? (Choose two.)...
Question 2: Which type of WAN connection do you use for a low-latency ap...
Question 3: What will extend a trust boundary (there is switch interface...
Question 4: Refer to the exhibit. (Exhibit) Which result is true if a cl...
Question 5: Which is part of the Prepare phase of PPDIOO?...
Question 6: which QoS level should VOIPset be configured on WLC ?...
Question 7: For a VLAN that requires 70 hosts, which subnet is the most ...
Question 8: A network engineer is using the traditional switched hierarc...
Question 9: Which tool captures network traffic, decodes the protocols i...
Question 10: Which two devices support context virtualization? (Choose tw...
Question 11: An engineer is trying to collect information about the custo...
Question 12: Multicast has been enabled and configured in the Enterprise,...
Question 13: Which design enables easy and flexible scaling in the Cisco ...
Question 14: Cisco Identity-Based Networking Services relies heavily on t...
Question 15: As you assign QoS priorities, which Cisco tool can you use t...
Question 16: What tool would you use to decode protocols?...
Question 17: What is a benefit of IPv6 over IPv4 addresses?...
Question 18: Which advantage of using Spanning Tree Protocol is true?...
Question 19: Which option is an example of a fixed two-level hierarchical...
Question 20: Which three functions of a wireless LAN controller in an ent...
Question 21: An organization must decide which routing protocol to use th...
Question 22: Which feature enables the VRRP-enabled router to regain the ...
Question 23: In which phase of the Cisco Design Lifecycle would you ident...
Question 24: Which two states are RSTP port states? (Choose two.)...
Question 25: Your company uses OSPF for internal routing. The company wil...
Question 26: Which type of router connects to two different OSPF areas?...
Question 27: A network engineer is tasked with summarizing the routes to ...
Question 28: You want to gather as much detail as possible during a netwo...
Question 29: Which option is a benefit of the modular approach to network...
Question 30: What information should be utilized to identify network appl...
Question 31: Refer to the exhibit. (Exhibit) You are designing routing be...
Question 32: A network design engineer is seeking a dynamic routing proto...
Question 33: While designing a remote access VPN, a customer has requeste...
Question 34: Which two mechanisms are used by distance vector protocols t...
Question 35: Which layer of the OSI model when included in the access lay...
Question 36: A customer is questioning the additional infrastructure that...
Question 37: What describes the link performance?...
Question 38: Which value must you configure on a Microsoft DHCP server so...
Question 39: Which statement about using VSS on a pair of switches is tru...
Question 40: Refer to exhibit. (Exhibit) Based on the following output fr...
Question 41: Which three sources does a network designer use to collect i...
Question 42: An organization is redesigning a 3-tier hierarchical network...
Question 43: Which two major campus design models does the cisco unified ...
Question 44: Which statement describes an advantage of the Layer 2 access...
Question 45: Drag and drop the phases of the lifecycle of a standard netw...
Question 46: What should be considered when scaling EIGRP (Choose three)?...
Question 47: Traditionally, the DMZ exist between which two locations? (C...
Question 48: Which VPN tunneling technology supports IP multicast?...
Question 49: Which benefit of hiding network information by using aggrega...
Question 50: Which statement correctly describes queuing in environments ...
Question 51: Which design feature must be considered when the WAN bandwid...
Question 52: Which statement is true concerning the data center access la...
Question 53: Which routing protocol feature do you use when scaling a net...
Question 54: Refer to the exhibit. (Exhibit) Where should routes in the r...
Question 55: An engineer is designing a disaster recovery solution to avo...
Question 56: An engineer wants to ensure that the Spanning Tree topology ...
Question 57: When designing changes to an existing network which tow opti...
Question 58: Which two options are benefits of utilizing the Cisco Lifecy...
Question 59: What is the VLAN subnet that can handle 60 hosts?...
Question 60: Which two features are benefits of a modular network design"...
Question 61: According to fundamental design principles, which location i...
Question 62: You want to gather as much detail as possible during a netwo...
Question 63: Which two Cisco data center devices can participate in Cisco...
Question 64: Which virtualization solution provides redundancy using a pa...
Question 65: How many switches can be combined into a single network elem...
Question 66: What is the benefit of VLSM?
Question 67: Which option best describes the high-level design document?...
Question 68: What are two advantages of a modular design (Choose two)?...
Question 69: Which Cisco security mechanism has the attributes listed bel...
Question 70: Which feature must be configured on a switch port that conne...
Question 71: Which IPv6 feature enables routing to distribute connection ...
Question 72: What is the benefit of using VLSM?...
Question 73: Which protocol is used for voice bearer traffic?...
Question 74: Which scenario is the best example of a single-homed connect...
Question 75: A network engineer is designing a solution that will monitor...
Question 76: An engineer is designing a hierarchical LAN design for an en...
Question 77: Which statement about using STP in a redundant - link scenar...
Question 78: What Routing Protocol is clasfull...
Question 79: Which RFC defines the IPv6 standard?...
Question 80: What are two important aspects to consider when looking at b...