200-105 Exam Dumps | Refer to the exhibit. Assuming that the entire network topology is shown, what is the operational status

Home
Cisco
Interconnecting Cisco Networking Devices Part 2 (ICND2 v3.0)
Cisco.200-105.v2018-06-25.q97
Question 73

Valid 200-105 Dumps shared by ExamDiscuss.com for Helping Passing 200-105 Exam! ExamDiscuss.com now offer the newest 200-105 exam dumps, the ExamDiscuss.com 200-105 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 200-105 dumps with Test Engine here:

Access 200-105 Dumps Premium Version
(775 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 73/97

Refer to the exhibit. Assuming that the entire network topology is shown, what is the operational status of the interfaces of R2 as indicated by the command output shown?

A. One interface has a problem.

B. Two interfaces have problems.

C. The interfaces are functioning correctly.

D. The operational status of the interfaces cannot be determined from the output shown.

Correct Answer: C

Explanation/Reference:
Explanation:
R2 has setup with two interface s0/1 and fa0/0 and both are interfaces configured with IP address and up.
"show ip interface brief" showing the status of R2 interfaces.

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (97q): Question 1: What does the frame-relay interface-dlci command configure?...; Question 2: The following configuration is applied to a Layer 2 Switch: ...; Question 3: What occurs on a Frame Relay network when the CIR is exceede...; Question 4: Which command allows you to verify the encapsulation type (C...; Question 5: Which two statements about using the CHAP authentication mec...; Question 6: Hotspot Question (Exhibit) If required, what password should...; Question 7: Which protocol is an open standard protocol framework that i...; Question 8: The command show frame-relay map gives the following output:...; Question 9: Refer to the exhibit. Why has this switch not been elected t...; Question 10: Hotspot Question (Exhibit) To allow or prevent load balancin...; Question 11: Which two statements describe the process identifier that is...; Question 12: The output of the show frame-relay pvc command shows "PVC ST...; Question 13: Which command enables IPv6 forwarding on a Cisco router?...; Question 14: Which two statistics appear in show frame-relay map output? ...; Question 15: Lab - OSPF (Exhibit); Question 16: Lab - CLI Configuration (Exhibit) Attention: In practical ex...; Question 17: The internetwork infrastructure of company XYZ consists of a...; Question 18: Which statement is true, as relates to classful or classless...; Question 19: At which layer of the OSI model is RSTP used to prevent loop...; Question 20: What is the advantage of using a multipoint interface instea...; Question 21: Which Layer 2 protocol encapsulation type supports synchrono...; Question 22: What are three reasons that an organization with multiple br...; Question 23: What are two drawbacks of implementing a link-state routing ...; Question 24: Lab - NAT A network associate is configuring a router for th...; Question 25: What are three characteristics of the OSPF routing protocol?...; Question 26: Refer to the exhibit. Given the output from the show ip eigr...; Question 27: Which two options are valid WAN connectivity methods? (Choos...; Question 28: Which parameter would you tune to affect the selection of a ...; Question 29: Drag and Drop Question Drag the Frame Relay acronym on the l...; Question 30: What does a router do if it has no EIGRP feasible successor ...; Question 31: Which commands are required to properly configure a router t...; Question 32: Refer to the exhibit. The network is converged. After link-s...; Question 33: Which port state is introduced by Rapid-PVST?...; Question 34: What is the purpose of Inverse ARP?...; Question 35: Hotspot Question (Exhibit) OSPF is configured using default ...; Question 36: A network administrator needs to configure a serial link bet...; Question 37: Drag and Drop Question Drag the description on the left to t...; Question 38: What is the default administrative distance of OSPF?...; Question 39: Refer to the exhibit. Hosts in network 192.168.2.0 are unabl...; Question 40: Hotspot Question (Exhibit) R1 is configured with the default...; Question 41: Which parameter or parameters are used to calculate OSPF cos...; Question 42: Refer to the exhibit. Which two statements are true about th...; Question 43: What information does a router running a link-state protocol...; Question 44: Refer to the exhibit. Each of these four switches has been c...; Question 45: Refer to the exhibit. The Lakeside Company has the internetw...; Question 46: Refer to the exhibit. Based on the exhibited routing table, ...; Question 47: Refer to the exhibit. The network associate is configuring O...; Question 48: Refer to the exhibit. Which two statements are true about in...; Question 49: Which two are advantages of static routing when compared to ...; Question 50: Hotspot Question (Exhibit) What would be the destination Lay...; Question 51: What can be done to secure the virtual terminal interfaces o...; Question 52: Refer to the exhibit. What three actions will the switch tak...; Question 53: Which encapsulation type is a Frame Relay encapsulation type...; Question 54: Which command is used to display the collection of OSPF link...; Question 55: What can be done to Frame Relay to resolve split-horizon iss...; Question 56: Which three of these statements regarding 802.1Q trunking ar...; Question 57: What is the default maximum number of equal-cost paths that ...; Question 58: Refer to the exhibit. The output that is shown is generated ...; Question 59: Refer to the exhibit. Assume that all router interfaces are ...; Question 60: Refer to the exhibit. A technician has configured the FastEt...; Question 61: Which two states are the port states when RSTP has converged...; Question 62: Refer to the exhibit. How will the router handle a packet de...; Question 63: Which two of these statements regarding RSTP are correct? (C...; Question 64: Which statements are true about EIGRP successor routes? (Cho...; Question 65: Refer to the exhibit. What information about the interfaces ...; Question 66: The internetwork infrastructure of company XYZ consists of a...; Question 67: Refer to the exhibit. A network associate has configured OSP...; Question 68: A router is running three routing processes: RIP, OSPF, and ...; Question 69: Refer to the exhibit. RTA is configured with a basic configu...; Question 70: Drag and Drop Question Drag each description on the left to ...; Question 71: What command is used to verify the DLCI destination address ...; Question 72: Refer to the exhibit. Which switch provides the spanning-tre...; Question 73: Refer to the exhibit. Assuming that the entire network topol...; Question 74: Refer to the exhibit. When running EIGRP, what is required f...; Question 75: Which three statements about RSTP are true? (Choose three.)...; Question 76: Refer to the exhibit. C-router is to be used as a "router-on...; Question 77: Lab - VTP Configuration A new switch is being added to the R...; Question 78: Lab - Access List Simulation (Exhibit)...; Question 79: Refer to the exhibit. Which of these correctly describes the...; Question 80: Hotspot Question (Exhibit) A static map to the S-AMER locati...; Question 81: Refer to the exhibit. Given the output for this command, if ...; Question 82: What is the result of issuing the frame-relay map ip 192.168...; Question 83: What is one benefit of PVST+?; Question 84: Hotspot Question (Exhibit) After the network has converged, ...; Question 85: Which three statements are typical characteristics of VLAN a...; Question 86: Hotspot Question (Exhibit) Which connection uses the default...; Question 87: At which layer of the OSI model does PPP perform?...; Question 88: Refer to the exhibit. At the end of an RSTP election process...; Question 89: Refer to the exhibit. Assume that all of the router interfac...; Question 90: Refer to the exhibit. Given the output shown from this Cisco...; Question 91: What are two characteristics of Frame Relay point-to-point s...; Question 92: Refer to the exhibit. What commands must be configured on th...; Question 93: A technician pastes the configurations in the exhibit into t...; Question 94: Which command is used to enable CHAP authentication, with PA...; Question 95: Which PPP subprotocol negotiates authentication options?...; Question 96: Which type of EIGRP route entry describes a feasible success...; Question 97: Refer to the exhibit. Which WAN protocol is being used? (Exh...

[×]

Download PDF File

Enter your email address to download Cisco.200-105.v2018-06-25.q97.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 73/97

LEAVE A REPLY

Download PDF File