200-105 Exam Dumps | Which commands are required to properly configure a router to run OSPF and to add network 192.168.16.0/24

Home
Cisco
Interconnecting Cisco Networking Devices Part 2 (ICND2 v3.0)
Cisco.200-105.v2018-06-15.q139
Question 1

Valid 200-105 Dumps shared by ExamDiscuss.com for Helping Passing 200-105 Exam! ExamDiscuss.com now offer the newest 200-105 exam dumps, the ExamDiscuss.com 200-105 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 200-105 dumps with Test Engine here:

Access 200-105 Dumps Premium Version
(775 Q&As Dumps, 35%OFF Special Discount Code: freecram)

Next Question >>

Question 1/139

Which commands are required to properly configure a router to run OSPF and to add network
192.168.16.0/24 to OSPF area 0? (Choose two.)

A. Router(config)# router ospf 0

B. Router(config)# router ospf 1

C. Router(config)# router ospf area 0

D. Router(config-router)# network 192.168.16.0 0.0.0.255 0

E. Router(config-router)# network 192.168.16.0 0.0.0.255 area 0

F. Router(config-router)# network 192.168.16.0 255.255.255.0 area 0

Correct Answer: B,E

Explanation/Reference:
Explanation:
In the router ospf command, the Process ID ranges from 1 to 65535 so, "0" is an invalid number - B is correct but, A is not correct. To configure OSPF, we need a wildcard in the "network" statement, not a subnet mask. We also need to assign an area to this process - E is correct. OSPF area ranges from 0 to
4294967295.
Sample OSPF Configuration Commands
Router(config)# router ospf 1
Router(config-router)# network 192.168.16.0 0.0.0.255 area 0

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (139q): Question 1: Which commands are required to properly configure a router t...; Question 2: What information does a router running a link-state protocol...; Question 3: Refer to the exhibit. The company uses EIGRP as the routing ...; Question 4: Refer to the exhibit. What three actions will the switch tak...; Question 5: When a router undergoes the exchange protocol within OSPF, i...; Question 6: Which two are advantages of static routing when compared to ...; Question 7: Refer to the exhibit. Given the output for this command, if ...; Question 8: Which protocol is an open standard protocol framework that i...; Question 9: Below is the configuration of the R1 router: R1(config)# ip ...; Question 10: You are configuring the localhost/nitunetwp office. In parti...; Question 11: Which two statistics appear in show frame-relay map output? ...; Question 12: Which three statements about RSTP are true? (Choose three.)...; Question 13: Which one of these is a valid HSRP Virtual Mac Address?...; Question 14: The internetwork infrastructure of company XYZ consists of a...; Question 15: What command visualizes the general NetFlow data on the comm...; Question 16: Exhibit: (Exhibit) Study the exhibit carefully. You need to ...; Question 17: Hotspot Question (Exhibit) If required, what password should...; Question 18: Which two states are the port states when RSTP has converged...; Question 19: What does a router do if it has no EIGRP feasible successor ...; Question 20: Refer to the exhibit. The show interfaces serial 0/1 command...; Question 21: Which PPP subprotocol negotiates authentication options?...; Question 22: What command is used to verify the DLCI destination address ...; Question 23: Frame Relay Sim: type show frame-relay map and show running-...; Question 24: Which port state is introduced by Rapid-PVST?...; Question 25: Refer to the exhibit. A network associate has configured OSP...; Question 26: What is one benefit of PVST+?; Question 27: Hotspot Question (Exhibit) To allow or prevent load balancin...; Question 28: The output of the show frame-relay pvc command shows "PVC ST...; Question 29: Refer to the exhibit, Host A pings interface S0/0 on router ...; Question 31: Refer to the exhibit. Which two statements are true about th...; Question 32: Which two options are valid WAN connectivity methods? (Choos...; Question 33: Which two of these statements regarding RSTP are correct? (C...; Question 34: Which parameter or parameters are used to calculate OSPF cos...; Question 35: What are three reasons to collect NetFlow data on a company ...; Question 36: The following configuration is applied to a Layer 2 Switch (...; Question 37: Frame Relay Sim: type show frame-relay map and show running-...; Question 38: Hotspot Question (Exhibit) A static map to the S-AMER locati...; Question 39: Which two statements about using the CHAP authentication mec...; Question 40: Refer to the exhibit. RTA is configured with a basic configu...; Question 41: Refer to the exhibit. A technician has configured the FastEt...; Question 42: Refer to the exhibit. Given the output from the show ip eigr...; Question 43: What are three factors a network administrator must consider...; Question 44: What are three reasons that an organization with multiple br...; Question 45: Refer to the exhibit. The output that is shown is generated ...; Question 46: Refer to the exhibit. Which two statements are true about in...; Question 47: Refer to the exhibit. Each of these four switches has been c...; Question 48: Refer to the exhibit. The network associate is configuring O...; Question 49: Users have been complaining that their Frame Relay connectio...; Question 50: Which command is used to enable CHAP authentication, with PA...; Question 51: What are three benefits of GLBP? (Choose three)...; Question 52: Which term describes a spanning-tree network that has all sw...; Question 53: Refer to the exhibit. From R1, a network administrator is ab...; Question 54: Hotspot Question (Exhibit) After the network has converged, ...; Question 55: What are two drawbacks of implementing a link-state routing ...; Question 56: A network administrator needs to configure a serial link bet...; Question 57: Refer to the exhibit. Which of these correctly describes the...; Question 58: Frame Relay Sim: type show frame-relay map and show running-...; Question 59: Hotspot Question (Exhibit) OSPF is configured using default ...; Question 60: What is the default maximum number of equal-cost paths that ...; Question 61: Which three statements about HSRP operation are true? (Choos...; Question 62: Which statements are true about EIGRP successor routes? (Cho...; Question 63: The network administrator has been asked to give reasons for...; Question 64: Which of these represents an IPv6 link-local address?...; Question 65: What is the result of issuing the frame-relay map ip 192.168...; Question 66: Refer to the exhibit. The Lakeside Company has the internetw...; Question 67: What are the three things that the NetFlow uses to consider ...; Question 68: Refer to the exhibit. Which switch provides the spanning-tre...; Question 69: Refer to the exhibit. What information about the interfaces ...; Question 70: Refer to the exhibit. A packet with a source IP address of 1...; Question 71: Two offices are displayed below: (Exhibit) You work as a net...; Question 72: Which Layer 2 protocol encapsulation type supports synchrono...; Question 73: The command show frame-relay map gives the following output:...; Question 74: What are the benefit of using Netflow? (Choose three.)...; Question 75: Which three of these statements regarding 802.1Q trunking ar...; Question 76: Refer to the exhibit. Given the output shown from this Cisco...; Question 77: Refer to the exhibit. How will the router handle a packet de...; Question 78: What are three benefits of GLBP? (Choose three.)...; Question 79: Which parameter would you tune to affect the selection of a ...; Question 80: Drag the term on the left to its definition on the right (no...; Question 81: Lab - NAT A network associate is configuring a router for th...; Question 82: What are two characteristics of Frame Relay point-to-point s...; Question 83: Which protocol provides a method of sharing VLAN configurati...; Question 84: Which encapsulation type is a Frame Relay encapsulation type...; Question 85: What are three characteristics of the OSPF routing protocol?...; Question 86: Which type of EIGRP route entry describes a feasible success...; Question 87: As a CCNA candidate, you need to know EIGRP very well. Which...; Question 88: A technician pastes the configurations in the exhibit into t...; Question 89: Frame Relay Sim: type show frame-relay map and show running-...; Question 90: Lab - OSPF A sporting goods manufacturer has decided to netw...; Question 91: What can be done to secure the virtual terminal interfaces o...; Question 92: Refer to the exhibit. C-router is to be used as a "router-on...; Question 93: Refer to the exhibit. Assume that all of the router interfac...; Question 94: In a GLBP network, who is responsible for the arp request?...; Question 95: Drag and Drop Select and Place: (Exhibit)...; Question 96: What can be done to Frame Relay to resolve split-horizon iss...; Question 97: A router is running three routing processes: RIP, OSPF, and ...; Question 98: What is the default administrative distance of OSPF?...; Question 99: Drag item on left to match item on right Select and Place: (...; Question 100: Refer to the exhibit. Why has this switch not been elected t...; Question 101: Refer to the exhibit. Assuming that the entire network topol...; Question 102: Refer to the exhibit. Which statement describes DLCI 17? (Ex...; Question 103: Which two statements describe the process identifier that is...; Question 104: In the Frame Relay network, which IP addresses would be assi...; Question 105: Hotspot Question (Exhibit) What would be the destination Lay...; Question 106: You work as a network administrator for your corporation, yo...; Question 107: Refer to the exhibit. Assume that all router interfaces are ...; Question 108: What occurs on a Frame Relay network when the CIR is exceede...; Question 109: What Cisco IOS feature can be enabled to pinpoint an applica...; Question 110: Which one of these is a valid HSRP Virtual Mac Address?...; Question 111: In GLBP, which router will respond to client ARP requests?...; Question 112: What is the purpose of LCP?; Question 113: Match the categories with the appropriate router output line...; Question 114: Refer to the exhibit. When running EIGRP, what is required f...; Question 115: Full Lab Here We don't have enough information about this si...; Question 116: Which command is used to display the collection of OSPF link...; Question 117: Refer to the exhibit. Based on the exhibited routing table, ...; Question 118: What is the advantage of using a multipoint interface instea...; Question 119: Which command allows you to verify the encapsulation type (C...; Question 120: Refer to the exhibit. What commands must be configured on th...; Question 121: What are three reasons to collect Netflow data on a company ...; Question 122: A network administrator is troubleshooting an EIGRP problem ...; Question 123: The command frame-relay map ip 10.121.16.8 102 broadcast was...; Question 124: What Netflow component can be applied to an interface to tra...; Question 125: Hotspot Question (Exhibit) R1 is configured with the default...; Question 126: What are the benefit of using Netflow? (Choose three)...; Question 127: Which statement describes VRRP object tracking?...; Question 128: At which layer of the OSI model is RSTP used to prevent loop...; Question 129: A network administrator needs to configure port security on ...; Question 130: What are two characteristics of a switch that is configured ...; Question 131: Refer to the exhibit. At the end of an RSTP election process...; Question 132: Which feature does PPP use to encapsulate multiple protocols...; Question 133: Which three statements are typical characteristics of VLAN a...; Question 134: Which statement is true, as relates to classful or classless...; Question 135: The above provides some descriptions, while the below provid...; Question 136: Refer to the exhibit. Which WAN protocol is being used? (Exh...; Question 137: It has become necessary to configure an existing serial inte...; Question 138: A router receives information about network 192.168.10.0/24 ...; Question 139: Which command enables IPv6 forwarding on a Cisco router?...

[×]

Download PDF File

Enter your email address to download Cisco.200-105.v2018-06-15.q139.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 1/139

LEAVE A REPLY

Download PDF File