Valid 2V0-41.24 Dumps shared by ExamDiscuss.com for Helping Passing 2V0-41.24 Exam! ExamDiscuss.com now offer the newest 2V0-41.24 exam dumps, the ExamDiscuss.com 2V0-41.24 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 2V0-41.24 dumps with Test Engine here:
Access 2V0-41.24 Dumps Premium Version
(128 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 25/61
Which command is used to display the network configuration of the Tunnel Endpoint (TEP) IP on a bare metal transport node?
Correct Answer: D
The ifconfig command is used to display the network configuration of interfaces, including the Tunnel Endpoint (TEP) IP on a bare metal transport node. This command provides details about IP addresses, subnet masks, and other network settings for each interface on the node.
- Question List (61q)
- Question 1: Which three DHCP Services are supported by NSX? (Choose thre...
- Question 2: An NSX administrator is creating a Tier-1 Gateway configured...
- Question 3: A customer has experienced a disaster. Which statement descr...
- Question 4: Which two tools are used for centralized logging in VMware N...
- Question 5: A customer is planning to utilize NSX-T Data Center security...
- Question 6: Which two BGP configuration parameters can be configured in ...
- Question 7: What are two valid BGP Attributes that can be used to influe...
- Question 8: Which three of the following describe the Border Gateway Rou...
- Question 9: What are three NSX Manager roles? (Choose three.)...
- Question 10: Which VPN type must be configured before enabling an L2VPN?...
- Question 11: An NSX administrator is troubleshooting a connectivity issue...
- Question 12: Which command on ESXi is used to verify the Local Control Pl...
- Question 13: What are four NSX built-in role-based access control (RBAC) ...
- Question 14: An administrator has a requirement to have consistent policy...
- Question 15: Which two choices are use cases for Distributed Intrusion De...
- Question 16: How is the RouterLink port created between a Tier-1 Gateway ...
- Question 17: An NSX administrator is reviewing syslog and notices that Di...
- Question 18: Which two of the following features are supported for the St...
- Question 19: Which choice is a valid insertion point for North-South netw...
- Question 20: Which steps are required to activate Malware Prevention on t...
- Question 21: An NSX administrator would like to create an L2 segment with...
- Question 22: A customer has a network where BGP has been enabled and the ...
- Question 23: Where does an administrator configure the VLANs used in VRF ...
- Question 24: Which troubleshooting step will resolve an error with code 1...
- Question 25: Which command is used to display the network configuration o...
- Question 26: Which two statements describe the characteristics of an Edge...
- Question 27: Which two logical router components span across all transpor...
- Question 28: An administrator has been tasked with implementing the SSL c...
- Question 29: Which of the two following characteristics about NAT64 are t...
- Question 30: Which three selections are capabilities of Network Topology?...
- Question 31: An administrator has connected two virtual machines on the s...
- Question 32: In an NSX environment, an administrator is observing low thr...
- Question 33: A customer is preparing to deploy a VMware Kubernetes soluti...
- Question 34: Which two steps must an NSX administrator take to integrate ...
- Question 35: Which NSX CLI command is used to change the authentication p...
- Question 36: Which tool could be used to configure BGP on a Tier-0 Gatewa...
- Question 37: Which three NSX Edge components are used for North-South Mal...
- Question 38: Which statement is true about an alarm in a Suppressed state...
- Question 39: Which table on an ESXi host is used to determine the locatio...
- Question 40: Which two are requirements for FQDN Analysis? (Choose two.)...
- Question 41: Which of the following exist only on Tler-1 Gateway firewall...
- Question 42: Hotspot Question Refer to the exhibit. Which two items must ...
- Question 43: What needs to be configured on a Tier-0 Gateway to make NSX ...
- Question 44: An administrator needs to download the support bundle for NS...
- Question 45: An administrator needs to encrypt file transfers between two...
- Question 46: Which command is used to set the NSX Manager's logging-level...
- Question 47: What are the four types of role-based access control (RBAC) ...
- Question 48: What should an NSX administrator check to verify that VMware...
- Question 49: An NSX administrator is creating a NAT rule on a Tier-0 Gate...
- Question 50: Which three data collection sources are used by NSX Network ...
- Question 51: Which CLI command on NSX Manager and NSX Edge is used to cha...
- Question 52: Which component is required to use VMware Distributed vSwitc...
- Question 53: Which three solutions does the software-defined data center ...
- Question 54: Which two are supported by L2 VPN clients? (Choose two.)...
- Question 55: Which two statements are true about IDS Signatures? (Choose ...
- Question 56: Which two choices are solutions offered by the VMware NSX po...
- Question 57: Where in the NSX UI would an administrator set the time attr...
- Question 58: Drag and Drop Question Match the NSX Intelligence recommenda...
- Question 59: Which of the following statements is true regarding the use ...
- Question 60: What are two functions of the Service Engines in NSX Advance...
- Question 61: Which two statements are correct about East-West Malware Pre...
