Valid 2V0-41.23 Dumps shared by ExamDiscuss.com for Helping Passing 2V0-41.23 Exam! ExamDiscuss.com now offer the newest 2V0-41.23 exam dumps, the ExamDiscuss.com 2V0-41.23 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 2V0-41.23 dumps with Test Engine here:
Access 2V0-41.23 Dumps Premium Version
(109 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 7/52
An NSX administrator wants to create a Tler-0 Gateway to support equal cost multi-path (ECMP) routing.
Which failover detection protocol must be used to meet this requirement?
Which failover detection protocol must be used to meet this requirement?
Correct Answer: A
Explanation
According to the VMware NSX 4.x Professional documents and tutorials, BFD is a failover detection protocol that provides fast and reliable detection of link failures between two routing devices. BFD can be used with ECMP routing to monitor the health of the ECMP paths and trigger a route change in case of a failure12. BFD is supported by both BGP and OSPF routing protocols in NSX-T3. BFD can also be configured with different timers to achieve different detection times3.
According to the VMware NSX 4.x Professional documents and tutorials, BFD is a failover detection protocol that provides fast and reliable detection of link failures between two routing devices. BFD can be used with ECMP routing to monitor the health of the ECMP paths and trigger a route change in case of a failure12. BFD is supported by both BGP and OSPF routing protocols in NSX-T3. BFD can also be configured with different timers to achieve different detection times3.
- Question List (52q)
- Question 1: Where does an administrator configure the VLANs used In VRF ...
- Question 2: A company security policy requires all users to log Into app...
- Question 3: Which two are requirements for FQDN Analysis? (Choose two.)...
- Question 4: An administrator is configuring service insertion for Networ...
- Question 5: An administrator needs to download the support bundle for NS...
- Question 6: What can the administrator use to identify overlay segments ...
- Question 7: An NSX administrator wants to create a Tler-0 Gateway to sup...
- Question 8: Which two statements are correct about East-West Malware Pre...
- Question 9: Which three DHCP Services are supported by NSX? (Choose thre...
- Question 10: An NSX administrator is using ping to check connectivity bet...
- Question 11: What needs to be configured on a Tler-0 Gateway lo make NSX ...
- Question 12: Which steps are required to activate Malware Prevention on t...
- Question 13: When running nsxcli on an ESXi host, which command will show...
- Question 14: What are the four types of role-based access control (RBAC) ...
- Question 15: Which three of the following describe the Border Gateway Rou...
- Question 16: Which two statements are true about IDS Signatures? (Choose ...
- Question 17: Refer to the exhibit. Which two items must be configured to ...
- Question 18: Which two BGP configuration parameters can be configured in ...
- Question 19: Which table on an ESXi host is used to determine the locatio...
- Question 20: Which of the following settings must be configured in an NSX...
- Question 21: Which two of the following are used to configure Distributed...
- Question 22: Which three protocols could an NSX administrator use to tran...
- Question 23: Which CLI command would an administrator use to allow syslog...
- Question 24: Which CLI command is used for packet capture on the ESXi Nod...
- Question 25: Refer to the exhibit. An administrator configured NSX Advanc...
- Question 26: Which CLI command does an NSX administrator run on the NSX M...
- Question 27: An NSX administrator is reviewing syslog and notices that Di...
- Question 28: Which two commands does an NSX administrator use to check th...
- Question 29: Which two of the following features are supported for the St...
- Question 30: What are two valid options when configuring the scope of a d...
- Question 31: In which VPN type are the Virtual Tunnel interfaces (VTI) us...
- Question 32: Which of the two following characteristics about NAT64 are t...
- Question 33: Which troubleshooting step will resolve an error with code 1...
- Question 34: An administrator has been tasked with implementing the SSL c...
- Question 35: Which two statements are true for IPSec VPN? (Choose two.)...
- Question 36: When a stateful service is enabled for the first lime on a T...
- Question 37: Which two are supported by L2 VPN clients? (Choose two.)...
- Question 38: When collecting support bundles through NSX Manager, which f...
- Question 39: What are two supported host switch modes? (Choose two.)...
- Question 40: Which Is the only supported mode In NSX Global Manager when ...
- Question 41: An administrator has connected two virtual machines on the s...
- Question 42: An NSX administrator has deployed a single NSX Manager node ...
- Question 43: An NSX administrator is creating a Tier-1 Gateway configured...
- Question 44: What needs to be configured on a Tler-0 Gateway lo make NSX ...
- Question 45: What are tour NSX built-in rote-based access control (RBAC) ...
- Question 46: Which is an advantages of a L2 VPN In an NSX 4.x environment...
- Question 47: A security administrator needs to configure a firewall rule ...
- Question 48: Where is the insertion point for East-West network introspec...
- Question 49: An NSX administrator Is treating a NAT rule on a Tler-0 Gate...
- Question 50: Which VPN type must be configured before enabling a L2VPN?...
- Question 51: The security administrator turns on logging for a firewall r...
- Question 52: Which three data collection sources are used by NSX Network ...
