<< Prev Question Next Question >>

Question 22/75

An NSX administrator is using ping to check connectivity between VM1 running on ESXi1 to VM2 running on ESXi2. The ping tests fails. The administrator knows the maximum transmission unit size on the physical switch is 1600.
Which command does the administrator use to check the VMware kernel ports for tunnel end point communication?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (75q)
Question 1: What are two valid options when configuring the scope of a d...
Question 2: An NSX administrator would like to configure syslog for a KV...
Question 3: Which two BGP configuration parameters can be configured in ...
Question 4: Which two choices are solutions of the NSX portfolio (Choose...
Question 5: Which command is used to change the NSX CU administrator pas...
Question 6: When running nsxcli on an ESXi host, which command will show...
Question 7: An NSX administrator has configured a load balancer virtual ...
Question 8: Which CLI command would an administrator use to allow syslog...
Question 9: How many IPs are required when deploying a highly available ...
Question 10: Which command is used to set the NSX Manager's logging-level...
Question 11: An NSX administrator would like to export syslog events that...
Question 12: Which CLI command shows syslog on NSX Manager?...
Question 13: An NSX administrator would like to export syslog events that...
Question 14: An NSX administrator has configured a load balancer virtual ...
Question 15: A NSX-T Data Center administrator wants to ensure that any m...
Question 16: Which two statements describe the characteristics of an Edge...
Question 17: How many IPs are required when deploying a highly available ...
Question 18: An NSX Administrator has created a segment named WEB-LS from...
Question 19: When running nsxclion an ESXi host, which command will show ...
Question 20: A security administrator needs to configure a firewall rule ...
Question 21: What needs to be configured on a Tier-0 Gateway to make NSX ...
Question 22: An NSX administrator is using ping to check connectivity bet...
Question 23: Which CLI command shows syslog on NSX Manager?...
Question 24: Which CLI command would an administrator use to allow syslog...
Question 25: Refer to the exhibit. (Exhibit) Which NAT type must the NSX-...
Question 26: Which CLI command should be executed on a KVM hypervisor to ...
Question 27: Which two choices are prerequisites to configure NSX-T on VD...
Question 28: How is the RouterLink port created between a Tier-1 Gateway ...
Question 29: An NSX administrator would like to export syslog events that...
Question 30: Which CLI command shows syslog on NSX Manager?...
Question 31: Which two BGP configuration parameters can be configured in ...
Question 32: When deploying east-west network introspection, which Servic...
Question 33: Which command is used to display the network configuration o...
Question 34: What are three characteristics of a transport zone? (Choose ...
Question 35: What are two supported N-VDS modes? (Choose two.)...
Question 36: Which CLI command does an NSX administrator run on the NSX M...
Question 37: What are three NSX Manager roles? (Choose three.)...
Question 38: Which three can an administrator define in a transport node ...
Question 39: What is the most restrictive NSX-T built-in role which will ...
Question 40: Which three steps are required to create an IPsec VPN tunnel...
Question 41: What are the advantages of using a Tier-0 Gateway in ECMP mo...
Question 42: Which three teaming policy modes are supported by NSX-T Data...
Question 43: An NSX administrator has configured a KVM hypervisor as a tr...
Question 44: A customer has a network where BGP has been enabled and the ...
Question 45: An administrator has a requirement to have consistent policy...
Question 46: A customer has a network where BGP has been enabled and the ...
Question 47: Where are Distributed Firewall logs containing access decisi...
Question 48: An NSX administrator has configured a load balancer virtual ...
Question 49: What are two supported N-VDS modes? (Choose two.)...
Question 50: Which discovery protocol is supported for hypervisor transpo...
Question 51: An NSX administrator has configured a KVM hypervisor as a tr...
Question 52: Which two choices are prerequisites to configure NSX-T on VD...
Question 53: Which command is used to display the network configuration o...
Question 54: A customer is preparing to deploy VMware Kubernetes on an NS...
Question 55: Which two ports are used by a transport node to communicate ...
Question 56: An NSX administrator has deployed an NSX Edge on a bare-meta...
Question 57: Which statement Is true regarding the audit user account? (C...
Question 58: Which command is used to display the network configuration o...
Question 59: A DevOps user has deployed a Kubernetes Pod in vSphere. What...
Question 60: An NSX administrator has configured a KVM hypervisor as a tr...
Question 61: Which two commands does an NSX administrator use to check th...
Question 62: Which network virtualization technologies can be used with a...
Question 63: An NSX administrator is planning to deploy a multi-tier rout...
Question 64: An NSX administrator has deployed an NSX Edge on a bare-meta...
Question 65: An NSX administrator noticed that the nsxcli command times o...
Question 66: Which three protocols could an NSX administrator use to tran...
Question 67: What are the advantages of using a Tier-0 Gateway in ECMP mo...
Question 68: Which NSX CLI command is used to check the GENEVE tunnel sta...
Question 69: What are the advantages of using a Tier-0 Gateway in ECMP mo...
Question 70: How does the Traceflow tool identify issues in a network?...
Question 71: Which two commands are used to query the arp-table of a logi...
Question 72: Which CLI command shows syslog on NSX Manager?...
Question 73: Where are Distributed Firewall logs containing access decisi...
Question 74: Which CLI command is used to start the NSX Manager virtual m...
Question 75: An NSX Administrator has created a segment named WEB-LS from...