<< Prev Question Next Question >>

Question 15/37

After an Implementation Engineer installs a new FlashArray and runs health checks, they see that Phonehome and Remote Assist are NOT working correctly.
Which outbound port needs to be open for all management ports (physical and virtual)?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (37q)
Question 1: Before installing array rails, where should the cage nuts be...
Question 2: A customer has ordered several FlashArrays and wants to have...
Question 3: Before leaving the site after an install, who is required to...
Question 4: A customer needs to have arrays installed and configured wit...
Question 5: When executing a FlashArray upgrade from the FA-405 to a FA-...
Question 6: After performing a hardware upgrade from an //M20R2 to a //X...
Question 7: What command will view NVRAM install and update status?...
Question 8: Which PCIe slot supports 4-port FC cards on FlashArray//XL?...
Question 9: In a situation where iSCSI cards need to be re-used during a...
Question 10: Which enablement feature will cause Mirrored Write statistic...
Question 11: For FlashArray//XL, which PCIe card slot is reserved for con...
Question 12: An Implementation Engineer is scheduled to install a FlashAr...
Question 13: An Implementation Engineer is performing a capacity consolid...
Question 14: For FlashArray//XL, which 2 PCIe slots should be used for DF...
Question 15: After an Implementation Engineer installs a new FlashArray a...
Question 16: When installing the first DirectFlash Shelf on a FlashArray/...
Question 17: An Implementation Engineer is planning to add a DirectFlash ...
Question 18: If drives need to be relocated within an array for an XFORM ...
Question 19: A customer has filled out the Installation Workbook. The man...
Question 20: At the completion of an upgrade, which command is used to se...
Question 21: An Implementation Engineer is beginning a controller upgrade...
Question 22: What is the rack unit height of a FlashArray//XL?...
Question 23: What is the redundancy of the FlashArray//XL PSUs?...
Question 24: A data pack has been installed and the puredrive list comman...
Question 25: An Implementation Engineer performs a controller upgrade. Wh...
Question 26: Which command should an Implementation Engineer use to allow...
Question 27: In a situation where FC cards need to be re-used during a co...
Question 28: Which Purity command can be used to validate I/O is balanced...
Question 29: The customer has completed the installation document and has...
Question 30: An Implementation Engineer performing an inventory of hardwa...
Question 31: A data pack has been installed and the puredrive list comman...
Question 32: An Implementation Engineer is setting up a customer environm...
Question 33: A customer would like to consolidate their SAS shelves and w...
Question 34: A customer would like to reduce SafeMode settings for retent...
Question 35: What hardware should the Implementation Engineer find in the...
Question 36: A customer has purchased a DirectFlash Shelf, but lacks avai...
Question 37: What is the minimum AC voltage required to operate a FlashAr...