NS0-163 Exam Dumps | One method of configuring an interface for takeover is to enter ifconfig interface partner address at

Home
Network Appliance
NetApp Certified Data Administrator, ONTAP Professional
NetworkAppliance.NS0-163.v2024-07-26.q66
Question 17

Valid NS0-163 Dumps shared by ExamDiscuss.com for Helping Passing NS0-163 Exam! ExamDiscuss.com now offer the newest NS0-163 exam dumps, the ExamDiscuss.com NS0-163 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com NS0-163 dumps with Test Engine here:

Access NS0-163 Dumps Premium Version
(190 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 17/66

One method of configuring an interface for takeover is to enter ifconfig interface partner address at the command line. To make tins configuration persistent across reboots, you must enter tins information in the_____file for each appliance.

A. /vol/volO/mount

B. /voL'volO/home

C. /etc/rc

D. /etc/hosts

Correct Answer: C

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (66q): Question 1: A volume is SnapMirrored hourly. You revert the volume using...; Question 2: Open System SnapVault agents can be installed on all non-Net...; Question 3: The snapvault update command is only available on the second...; Question 4: A NearStore system or storage appliance can operate as a sec...; Question 5: SnapMirror will automatically tiy to restart a transfer afte...; Question 6: What is the maximum distance between a standard clustered pa...; Question 7: What is the maximum number of disk shelves per loop in a fab...; Question 8: Which statement describes the results of the snapmirror resy...; Question 9: Which one of the following options will allow a snapmirror s...; Question 10: NetApp X1024 Fibre Channel HBA is required on the storage sy...; Question 11: For a configuration change to be effective when using the OS...; Question 12: Which system is recommended as asecondary systemfor SnapVaul...; Question 13: When you are setting up SnapMirror, which one of the followi...; Question 14: What console message is a good indication that the storage a...; Question 15: Which two commands could be used if the cf giveback command ...; Question 16: Which one of the following statements does not apply to the ...; Question 17: One method of configuring an interface for takeover is to en...; Question 18: If an error message indicates that the cluster interconnect ...; Question 19: Protection Manager is an optional component of the Operation...; Question 20: A mirrored volume has a failed disk, but there are no availa...; Question 21: Node 1 in a clustered pair detects that it has lost connecti...; Question 22: To restore a primary SnapVault qtree to the exact qtree loca...; Question 23: Exhibit: (Exhibit) To remove a cluster setup, you must perfo...; Question 24: Which two of the following NetApp storage appliances do not ...; Question 25: Which one of the following statements apply to Advanced Sing...; Question 26: When configuring SyncMirror disk pools, which platforms requ...; Question 27: Which one of the following statements is not true when using...; Question 28: You cannot disable the SyncMirror license if one or more mir...; Question 29: In a Fabric Attached Metro Cluster, disk ownership by a node...; Question 30: Which one of the following commands is used to specify the d...; Question 31: What user-controllable security mechanism is built into OSSV...; Question 32: Which one of the following keywords alone can be used to con...; Question 33: Fill inthe blanks for the following statement: The qtree spe...; Question 34: The snapvault snap sched-x command can be used to:...; Question 35: SnapVaulr snapshots for SnapLock volumes are deleted automat...; Question 36: You can unlicense the cluster feature only in mode with clus...; Question 37: You can avoid data corruption when you issue the cf forcetak...; Question 38: Which Data ONTAP option would you enable to set system wide ...; Question 39: Which one of the following statements is not true of SnapLoc...; Question 40: After you use SnapRestore to revert a volume to a specific s...; Question 41: Data ONTAP uses inodes in an active file system to reference...; Question 42: Which one of the following does SnapRestore revert?...; Question 43: Fill in the blank for the following statement using the best...; Question 44: Which SyncMirror command mirrors an existing unmirrored aggr...; Question 45: Which three are required licenses for Fabric Attached MetroC...; Question 46: Identify the two commands that could be entered on a system ...; Question 47: To remove a cluster setup, you must perform the following st...; Question 48: Normally, before you split a SyncMirror volume, you ensure t...; Question 49: One week ago you performed a single file SnapRestore from a ...; Question 50: To restore a qtree protected with SnapVault from the seconda...; Question 51: Which statement is true of the cf forcetakover -d command?...; Question 52: The required hardware to add SyncMirror to an existing syste...; Question 53: Alter a SnapRestore reversion of a volume, incremental backu...; Question 54: When using MetroCluster, identify two methods for restrictin...; Question 55: Which MetroCluster configuration procedure is recommended fo...; Question 56: For each Open Systems platform directory to be backed up to ...; Question 57: In a synchronous SnapMirror configuration, the soui'ce stora...; Question 58: Which three statements apply to NearStore Personality licens...; Question 59: Which two choices are used to configure a semi-synchronous S...; Question 60: Data ONTAP uses inodes in an active file system to reference...; Question 61: You are trying to do a single file SnapRestore for a file, b...; Question 62: Which one of the following commands or procedures would you ...; Question 63: Identify the two commands that could be entered on a system ...; Question 64: You have connected all cables and disk shelves in a Fabric A...; Question 65: Which one of the following statements apply to the Free Spac...; Question 66: You want to create an automated test environment that perfor...

[×]

Download PDF File

Enter your email address to download NetworkAppliance.NS0-163.v2024-07-26.q66.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 17/66

LEAVE A REPLY

Download PDF File