<< Prev Question Next Question >>

Question 14/20

You have 1,000 devices that connect to an Azure IoT hub.
You are performing a scheduled check of deployed IoT devices. You plan to run the following command from the Azure CLI prompt.
aziot hub query --hub-name hub1 --query-command "SELECT * FROM devices WHERE connectionState = 'Disconnected'" What does the command return?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (20q)
Question 1: You plan to deploy Azure Time Series Insights. What should y...
1 commentQuestion 2: You need to install the Azure IoT Edge runtime on a new devi...
Question 3: Note: This question is part of a series of questions that pr...
Question 4: Note: This question is part of a series of questions that pr...
Question 5: You have an Azure IoT Central application that has a custom ...
Question 6: You need to store the real-time alerts generated by Stream A...
Question 7: You plan to deploy an Azure IoT hub. The IoT hub must suppor...
Question 8: You develop a custom Azure IoT Edge module named temperature...
Question 9: You create a new IoT device named device1 on iothub1. Device...
Question 10: You deploy an Azure IoT hub. You need to demonstrate that th...
Question 11: You have an Azure IoT solution that includes an Azure IoT hu...
Question 12: You use Azure Security Center in an Azure IoT solution. You ...
Question 13: You have the devices shown in the following table. (Exhibit)...
Question 14: You have 1,000 devices that connect to an Azure IoT hub. You...
Question 15: You have 1,000 devices that connect to a standard tier Azure...
Question 16: You have an Azure IoT hub that uses a Device Provisioning Se...
Question 17: You need to enable telemetry message tracing through the ent...
Question 18: You have an Azure IoT solution that includes a standard tier...
Question 19: From the Device Provisioning Service, you create an enrollme...
Question 20: You need to use message enrichment to add additional device ...