Click the exhibit button.
user@PE2# run show 12circuit connections
Layer-2 Circuit Connections:
Legend for connection status (St)
EI - - encapsulation invalid NP - - interface
h/w not present
MM - - mtu mismatch Dn - - down
EM - - encapsulation mismatch Vc-Dn - -
Virtual circuit Down
CM - - control-word mismatch UP - -
operational
VM - - vlan id mismatch CF - - Call admission
control failure
OL - - no outgoing label IB - - TDM
incompatible bitrate
NC - - intf encaps not CCC/TCC TM - - TDM
misconfiguration
BK - - Backup Connection ST - - Standby
Connection
CB - - rcvd cell-bundle size bad SP - - Static
Pseudowire
LD - - local site signaled down RS - - remote
sity standby
RD - - remote site signaled down HS - - Hot-
standby Connection
XX - - unknown
Legend for interface status
UP - - operational
Dn - - down
Neighbor: 10.10.1.1
Interface Type St Time
last up #Up trans
ge-1/1/1.6 (vc 2) rmt VM
[edit protocols 12circuit]
user@PE2# show
neighbor 10.10.1.1. {
interface ge-1/1/1.6 {
virtual-circuit-id 2;
encapsulation-type ethernet-vlan;
}
}
[edit logical-systems jpe interfaces]
user@PE2# show
ge-1/1/1 {
unit 6 {
encapsulation vlan-ccc;
vlan-id 6;
family ccc;
}
}
user@PE1# run show 12circuit connections
logical-system kpe
Layer-2 Circuit Connections:
Legend for connection status (St)
EI - - encapsulation invalid NP - - interface
h/w not present
MM - - mtu mismatch Dn - - down
EM- - encapsulation mismatch VC-Dn - -
Virtual -circuit Down
CM - - control-word mismatch Up - -
operational
VM - - vlan id mismatch CF - - Call admission
control failure
OL - - no outgoing label IB - - TDM
incompatible bitrate
NC - - intf encaps not CCC/TCC TM - - TDM
misconfiguration
BK - - Backup connection ST - - Standby
Connection
CB - - rcvd cell-bundle size bad SP - - Static
Pseudowire
LD - - local site signaled down RS - - remote
site standby
RD - - remote site signaled down HS - - Hot-
standby Connection
XX - - unknown
Legend for interface status
Up - - operational
Dn - - down
Neighbor: 10.10.1.3
Interface Type St Time
last up # Up trans
ge-1/0/1.5 (vc 2) rmt VM
[edit protocols 12circuit]
user@PE1# show
neighbor 10.11.1.1 {
interface ge-1/0/1.5 {
virtual-circuit-id 2;
encapsulation-type ethernet-vlan;
}
}
[edit interfaces]
user@PE1#
ge-1/0/1 (
unit 5 {
encapsulation vlan-ccc;
vlan-id 5;
family ccc;
}
}
An LDP Layer 2 circuit between PE1 and PE2 is not passing traffic. Both PE1 and PE2 show the circuit state as VM - - vlan id mismatch.
Referring to the exhibit, which action will solve this problem?