<< Prev Question Next Question >>

Question 65/179

Referring to Spanning Tree Protocol, what is the function of Root Protection?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (179q)
Question 1: Which two statements are correct regarding the behavior show...
Question 2: What is the purpose of the 'route reflector' in BGP?...
Question 3: Which two authentication methods are available for OSPF on J...
Question 4: Which two statements are true regarding CoS on Juniper devic...
Question 5: Referring to Spanning Tree Protocol, what is the function of...
Question 6: What are two supported PoE management modes? (Choose two.)...
Question 7: What is the main advantage of using Anycast RP over traditio...
Question 8: You are asked to configure an 802.1X solution that supports ...
Question 9: You are configuring a Juniper switch. You assign a VLAN to a...
Question 10: Which PIM mode is typically used in a multicast network envi...
Question 11: You have a workstation and an IP phone that connect to the s...
Question 12: Click the Exhibit button. (Exhibit) Referring to the exhibit...
Question 13: Which two properties are found in the OSPF Type 1 LSA? (Choo...
Question 14: You are implementing a single spanning tree instance in your...
Question 15: Which two statements are true regarding BGP peering sessions...
Question 16: Which two statements are true regarding bidirectional PIM? (...
Question 17: Which multicast routing protocol uses a shared tree only, wi...
Question 18: Your network is configured for EVPN load balancing on three ...
Question 19: You have configured a EX Series switch as an access switch. ...
Question 20: A Layer 2 connection does not expend across data centers. Th...
Question 21: Which two are properties of a not-so-stubby area? (Choose tw...
Question 22: Which BGP path attribute is used to prevent routing loops wh...
Question 23: You are adding VNI 101 to your EVPN-VXLAN network, but traff...
Question 24: You have a workstation and a VoIP phone connected to port ge...
Question 25: Exhibit: Mar 16 17:48:06.145257 OSPF periodic xmit from 172....
Question 26: You have deployed a Juniper Networks device in the network, ...
Question 27: Which two statements are true regarding BGP route advertisem...
Question 28: Exhibit: (Exhibit) You are running OSPF as your IGP. The int...
Question 29: Exhibit: (Exhibit) You are configuring BGP policies for a si...
Question 30: Which two statements are true regarding traffic classifiers?...
Question 31: Which two statements are true regarding BGP load balancing? ...
Question 32: In OSPF, how does a router ensure that LSAs advertised to a ...
Question 33: When is it most appropriate to use BGP instead of an IGP lik...
Question 34: Which two statements are true regarding hierarchical policer...
Question 35: You are implementing the route summarization feature of OSPF...
Question 36: How does OSPFv3 address the need for scalability in larger n...
Question 37: You are troubleshooting an EVPN-VXLAN IP fabric and observe ...
Question 38: Which IGMP version supports Source-Specific Multicast (SSM)?...
Question 39: Which two statements are true regarding PIM sparse mode? (Ch...
Question 40: Where are BGP import policies enforced?...
Question 41: When a BA classifier, an input policer, and a multifield (MF...
Question 42: You have configured CoS on a Junos device. A packet is class...
Question 43: You are configuring a EX Series switch to provide power to P...
Question 44: What is a supplicant in 802.1x authentication?...
Question 45: You are deploying IP phones to a customer site. The IP phone...
Question 46: What does the 'inet6' NLRI family signify in BGP configurati...
Question 47: Your network is multihomed to two ISPs. The BGP sessions are...
Question 48: You have deployed sparse-mode multicast in your network usin...
Question 49: Referring to the exhibit, traffic ingresses on interface ge-...
Question 50: Which statement is true about multicast addressing?...
Question 51: You want to view the VLANs that have been created dynamicall...
Question 52: Which two statements are true regarding MAC limit restrictio...
Question 53: You are 802.1X supplicant, but traffic must be accepted once...
Question 54: Which is the first step in the BGP route selection process?...
Question 55: Referring to the exhibit, which statement is correct? (Exhib...
Question 56: A customer is connected to the provider's ge-0/0/0.0 interfa...
Question 57: Referring to the exhibit, which two statements are true? (Ch...
Question 58: Which address range is used for source-specific multicast?...
Question 59: You are enabling MSTP in your Layer 2 network to prevent loo...
Question 60: The connection between DC1 and DC2 is routed as shown in the...
Question 61: Which statement is true regarding the simple-password authen...
Question 62: Which two statements are true regarding LLDP updates for dev...
Question 63: Which two statements are true regarding packet loss priority...
Question 64: Which two statements are true regarding OSPF LSAs? (Choose t...
Question 65: Referring to Spanning Tree Protocol, what is the function of...
Question 66: You have configured a EX Series access switch to support hos...
Question 67: Which of the following are components of IP multicast? (Choo...
Question 68: In a multicast network, what is the purpose of IGMP Query me...
Question 69: You have configured 802.1x access control. (Exhibit) Which s...
Question 70: Juniper devices use the token bucket algorithm for policing....
Question 71: Which two protocols are associated with the establishment of...
Question 72: What is the primary benefit of implementing BGP multipath in...
Question 73: How can BGP implement load balancing?...
Question 74: Which step comes first in the BGP route selection process af...
Question 75: You are asked to deploy 802.1X on your EX Series switches. Y...
Question 76: You are troubleshooting a BGP connection. (Exhibit) Referrin...
Question 77: You want to identify routes that pass through AS 5762 in ord...
Question 78: You are deploying a EX Series switch to provide PoE support ...
Question 79: Exhibit: (Exhibit) Referring to the exhibit, the source is c...
Question 80: When configuring BGP, what is the purpose of using NLRI fami...
Question 81: You have configured a EX Series access switch to support VoI...
Question 82: Exhibit: (Exhibit) There is a functioning OSPFv3 neighborshi...
Question 83: Which two statements are true regarding IGMP snooping? (Choo...
Question 84: Which BGP attribute is used to ensure loop-free interdomain ...
Question 85: Your enterprise network is running BGP VPNs to support multi...
Question 86: You recently implemented the configuration shown in the exhi...
Question 87: When configuring an EBGP session that peers with the loopbac...
Question 88: Which two telephony features are available on EX Series swit...
Question 89: Which statement is true regarding single-rate tricolor marki...
Question 90: Referring to the configuration shown in the exhibit, how man...
Question 91: What is the purpose of the 'community' attribute in BGP?...
Question 92: What is the effect of the 'as-override' option in a BGP rout...
Question 93: What are two characteristics of an access port on a Juniper ...
Question 94: In Junos, which command is used to configure IGMP snooping o...
Question 95: When configuring 802.1X authentication, what are three serve...
Question 96: Which two statements are true about 802.1Z dynamic filters b...
Question 97: Which statement is true regarding multifield classification?...
Question 98: Which EVPN route type is used for fast convergence and for a...
Question 99: Exhibit: (Exhibit) You are configuring dynamic rendezvous po...
Question 100: Select the correct statements about advanced BGP options. (C...
Question 101: Exhibit: (Exhibit) The policy shown in the exhibit is applie...
Question 102: Referring to the exhibit, which LSA type is used to advertis...
Question 103: Exhibit: (Exhibit) A router is attempting to form an OSPF ne...
Question 104: Which statement is true regarding MD5 authentication in OSPF...
Question 105: Referring to the exhibit, which two statements are correct? ...
Question 106: In the context of IP multicast, which statement about SSM is...
Question 107: You have deployed a Juniper switch that hosts multiple VLANs...
Question 108: Referring to the exhibit, what is the significance of the * ...
Question 109: Which statement is true regarding BGP's 'next-hop-self' comm...
Question 110: Exhibit: (Exhibit) Referring to the exhibit, which two state...
Question 111: Which two statements are true regarding behavioral aggregate...
Question 112: You are asked to implement fault tolerant RPs in your multic...
Question 113: Exhibit: (Exhibit) Referring to the log shown in the exhibit...
Question 114: You are securing the network using 802.1x access control. Yo...
Question 115: How is MSDP used in conjunction with PIM-SM?...
Question 116: When configuring IS-IS on a Junos device, which statement is...
Question 117: Which two statements are true regarding BGP communities? (Ch...
Question 118: How does Junos handle BGP route advertisements from a neighb...
Question 119: Which two statements are true regarding the single rate tric...
Question 120: When configuring IS-IS, what is the purpose of the Level 1-2...
Question 121: Your EX Series switch has IP telephones and computers connec...
Question 122: YourNet is learning the 210.210.40.0/24 route from Provider ...
Question 123: Which two statements are true regarding MDSP? (Choose two.)...
Question 124: What is the result of configuring a BGP multipath?...
Question 125: Which attribute is commonly used in BGP to influence inbound...
Question 126: You recently committed a change to a router to reject OSPF r...
Question 127: You must provide network connectivity to hosts that fail aut...
Question 128: Which two services does RADIIUS provide in network environme...
Question 129: Referring to the outputs shown in the exhibit, which two sta...
Question 130: You have an IPv4 multicast network configured as PIM-SM. Wha...
Question 131: What is the effect of the 'dampening' feature in BGP on a Ju...
Question 132: What is the role of the Rendezvous Point (RP) in multicast n...
Question 133: What is the purpose of IGMP snooping in multicast networking...
Question 134: When redistributing IGP routes into BGP, what information is...
Question 135: Which two multicast listener registration protocols are supp...
Question 136: Which of the following would be a reason to use BGP over an ...
Question 137: Which statement accurately describes the 'next-hop resolutio...
Question 138: Click the Exhibit button. (Exhibit) Which well-known communi...
Question 139: Which two statements about BGP communities are true? (Choose...
Question 140: You are deploying IP phones in your enterprise networks. Whe...
Question 141: Your enterprise network uses routing instances to support mu...
Question 142: You have a workstation and an IP phone that connect to the s...
Question 143: You notice a mass withdrawal of routes for some of the netwo...
Question 144: Your company has expanded into office space across the stree...
Question 145: What type of routing policy would be used in Junos to affect...
Question 146: Your IPv4 multicast network uses different MX Series routers...
Question 147: Which three statements are true about strict-high priority q...
Question 148: When implementing BGP routing policy, which Junos policy-sta...
Question 149: Which statement is correct about IS-IS?...
Question 150: Routers R1 and R2 receive the same 172.16.1.0/24 prefix from...
Question 151: Exhibit: (Exhibit) Referring to the exhibit, how is R5 able ...
Question 152: How is the Rendezvous Point (RP) used in multicast networkin...
Question 153: Which three types of ports are used for Junos Fusion Enterpr...
Question 154: Which statement is true regarding the OSPF overload setting?...
Question 155: You are redistributing static routes into an OSPF area. Whic...
Question 156: Which BGP attribute is not advertised to external peers?...
Question 157: Which two statements are true regarding multicast forwarding...
Question 158: Which two statements describe a multicast source tree? (Choo...
Question 159: You have configured DHCP snooping on a Juniper switch. Which...
Question 160: You are securing the network using 802.1x access control. Yo...
Question 161: Which two statements describe IGMP? (Choose two.)...
Question 162: You ate deploying P|M source-specific multicast (SSM) for a ...
Question 163: How does the Any-Source Multicast (ASM) model differ from th...
Question 164: You have configured captive portal for network access contro...
Question 165: Which two statements are true regarding the two-rate tricolo...
Question 166: Which two statements are true regarding Spanning Tree Protoc...
Question 167: Which of the following is NOT a function of OSPFv3?...
Question 168: You are securing the network by using access control on the ...
Question 169: Exhibit: (Exhibit) During an outage, you review the status o...
Question 170: You are configuring a Junos device and have created a firewa...
Question 171: You are configuring MSTP to prevent loops in your layer2 net...
Question 172: Which protocols are used for multicast traffic flow control?...
Question 173: A router receives a BGP route from two IBGP peers. The route...
Question 174: Which two statements are true regarding auto-RP? (Choose two...
Question 175: When configuring class of services, what would be you use to...
Question 176: You are asked to establish full connectivity between all dev...
Question 177: Click the Exhibit button. (Exhibit) Referring to the exhibit...
Question 178: You are deploying IP phones in your enterprise network that ...
Question 179: Which two statements are true regarding Q-in-Q tunneling? (C...