JN0-363 Exam Dumps | You are troubleshooting two OSPF routers that have an adjacency that remains in the ExStart state. What

Home
Juniper
Service Provider Routing and Switching, Specialist (JNCIS-SP)
Juniper.JN0-363.v2024-05-21.q33
Question 6

Valid JN0-363 Dumps shared by ExamDiscuss.com for Helping Passing JN0-363 Exam! ExamDiscuss.com now offer the newest JN0-363 exam dumps, the ExamDiscuss.com JN0-363 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com JN0-363 dumps with Test Engine here:

Access JN0-363 Dumps Premium Version
(88 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 6/33

You are troubleshooting two OSPF routers that have an adjacency that remains in the ExStart state.
What would cause this problem?

A. mismatched OSPF hello intervals on the OSPF interfaces

B. mismatched authentication settings on the OSPF interfaces

C. mismatched MTU settings on the OSPF interfaces

D. mismatched subnet settings on the OSPF interfaces

Correct Answer: C

https://www.cisco.com/c/en/us/support/docs/ip/open-shortest-path-first-ospf/13684-12.html#anc13 Neighbors Stuck in Exstart/Exchange State The problem occurs most frequently when you attempt to run OSPF between a Cisco router and another vendor router. The problem occurs when the maximum transmission unit (MTU) settings for neighboring router interfaces do not match. If the router with the higher MTU sends a packet larger that the MTU set on the neighboring router, the neighbor router ignores the packet. When this problem occurs, the output of the show ip ospf neighbor command displays output similar to what is shown in this figure.
A mismatched Maximum Transmission Unit (MTU) setting on OSPF interfaces can cause routers to get stuck in the ExStart state. OSPF requires that both sides of a link have the same MTU to form a full adjacency.
References:
OSPF Troubleshooting, Juniper Networks Documentation
MTU and OSPF, Juniper Networks Documentation

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (33q): Question 1: You are bringing a new network online with three MX Series d...; Question 2: Exhibit (Exhibit) You have an established LSP between your R...; Question 3: Which two LSA types are permuted in OSPF totally stubby area...; Question 4: What are two bridging concepts that are used to maintain an ...; Question 5: Which new field is added to an IPv6 header as compared lo IP...; Question 6: You are troubleshooting two OSPF routers that have an adjace...; Question 7: Exhibit (Exhibit) You configured interface ge-0/070.0 to run...; Question 8: Exhibit (Exhibit) Referring to the exhibit, what must be inc...; Question 9: Which statement is correct about the FE80;:/10 prefix?...; Question 10: Which OSPF database packet determines which router is in cha...; Question 11: Referring to the exhibit, which statement is correct? (Exhib...; Question 12: Exhibit (Exhibit) You have configured graceful RE switchover...; Question 13: Exhibit (Exhibit) Referring to the exhibit, what is the mini...; Question 14: Click the Exhibit button. (Exhibit) Referring to the exhibit...; Question 15: Exhibit (Exhibit) Referring to the exhibit, what will happen...; Question 16: Which BGP message type is used to re-advertise routes that h...; Question 17: By default, which two statements are correct about switch po...; Question 18: What Is a key differentiator of generate routes from aggrega...; Question 19: Exhibit (Exhibit) Referring to the exhibit, internal BGP bet...; Question 20: Exhibit S Exhibit LSI1AAS 65501 ISPB AS 65502 Advertised Pre...; Question 21: Which two steps are required to enable MPLS on a physical in...; Question 22: How does a Junos device learn about MAC addresses when II is...; Question 23: Exhibit (Exhibit) Which two statements are correct about the...; Question 24: Exhibit (Exhibit) Referring to the exhibit, which two additi...; Question 25: Which two statements are correct about the way that BGP prop...; Question 26: You want to enable a routing platform with redundant REs to ...; Question 27: You want to share routes between two routing instances that ...; Question 28: Which two statements are correct about IS-IS interface metri...; Question 29: Which BGP attribute Is used to detect touting loops?...; Question 30: Which two statements are correct when using LDP? (Choose two...; Question 31: Exhibit (Exhibit) Referring to the exhibit, which two statem...; Question 32: Which configuration selling prohibits a static route from be...; Question 33: Which statement is correct about IS-IS?...

[×]

Download PDF File

Enter your email address to download Juniper.JN0-363.v2024-05-21.q33.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 6/33

LEAVE A REPLY

Download PDF File